Synthesis and cell cycle inhibition of the peptide enamide natural products terpeptin and the aspergillamides

Total syntheses of the peptide enamide natural products terpeptin and aspergillamides A and B are reported. An oxidative decarboxylation-elimination protocol is employed to construct the indolic enamide moiety. Unambiguous stereochemical assignment of (−)-terpeptin is accomplished by synthesis of all possible stereochemical analogues. Select compounds have been evaluated in cell cycle inhibitor assays which show that the natural amino acid configuration of terpeptin has the most potent inhibitory activity.     

Method of observation of low density interface states by means of X-ray photoelectron spectroscopy under bias and passivation by cyanide ions

X-ray photoelectron spectroscopy (XPS) measurements under bias can observe low density interface states for metal-oxide-semiconductor (MOS) diodes with low densities. This method can give energy distribution of interface states for ultrathin insulating layers for which electrical measurements cannot be performed due to a high density leakage current. During the XPS measurements, a bias voltage is applied to the rear semiconductor surface with respect to the ∼3 nm-thick front platinum layer connected to the ground, and the bias voltage changes the occupation of interface states. Charges accumulated in the interface states shift semiconductor core levels at the interface, and thus the analysis of the bias-induced shifts of the semiconductor core levels measured as a function of the bias voltage gives energy distribution of interface states. In the case of Si-based MOS diodes, the energy distribution and density of interface states strongly depend on the atomic density of silicon dioxide (SiO₂) layers and the interfacial roughness, respectively. All the observed interface state spectra possess peaked-structures, indicating that they are due to defect states. An interface state peak near the Si midgap is attributable to isolated Si dangling bonds at the interface, while those above and below the midgap to Si dangling bonds interacting weakly with Si or oxygen atoms in the SiO₂ layers. A method of the elimination of interface states and defect states in Si using cyanide solutions has been developed. The cyanide method simply involves the immersion of Si in KCN solutions. Due to the high Si-CN bond energy of ∼4.5 eV, the bonds are not ruptured at 800 °C and upon irradiation. The cyanide treatment results in the improvement of the electrical characteristics of MOS diodes and solar cells.     

Three New Diarylpropanes from Dioscorea composita

Three new diarylpropanes were isolated from the dried rhizomes of Dioscorea composita Hemsl., and their structures were determined as 1, 3-bis-(2-hydroxy-4-methoxyphenyl) propane (1), 1, 3-bis-(2, 4-dihydroxyphenyl)propane (2), 1-(2′-hydroxy-4′-O-β-D- glucopymnosy-phenyl)-3-(2“, 4“-dihydroxyphenyl)propane (3), by spectroscopic analysis, respectively.     

Adsorption of fission products onto soils using a fission multitracer

The adsorption behavior of fission products to various soils was studied using a multitracer. The multitracer was prepared by neutron irradiation of ²³⁵U. Distribution coefficients of fission products were obtained for seventeen kinds of Japanese soils. It was found that zirconium, niobium, and rare earth elements show high distribution coefficients for all soil samples, however, elements like alkali metals show varied values.     

Precise synthesis of porphyrin array scaffolding polyisocyanides

Aryl isocyanides bearing free‐base and metallo‐porphyrins were prepared and polymerized with a Pd–Pt μ‐ethynediyl complex as the initiator to give polymers with narrow polydispersity indices. The molecular weights of the resulting polymers were precisely controlled by the initial feed ratio of the porphyrin monomer to the initiator. The UV–VIS spectra suggested that the porphyrin pendants are regularly arranged to form stacked columns. Metallo‐porphyrin polymers were also prepared by reacting free‐base porphyrin polymers with metal salts. The successive reactions of free‐base and zinc‐porphyrin monomers resulted in the formation of diblock polymers. © 2005 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 44: 585–595, 2006     

In‐line monitoring of UV photopolymerization with a quartz crystal resonator

An in‐line monitoring device using a quartz crystal resonator for thin film polymerization was proposed, and its performance has been evaluated by implementing in the UV polymerization of 2‐hydroxyethyl methacrylate with a photoinitiator of 1‐chloroanthraquinone. Because the variation of resonant resistance of the resonator is proportional to the square root of viscosity change that is closely related to the polymerization degree, the resistance can be used as a measure of the polymerization degree. The resistance measurements were compared with the outcome of instrumental analyses of polymerization degree using an FTIR spectrometer and a gel permeation chromatograph. The experimental results showed that the resistance measurements were consistent with the experimental outcome of the instrumental analyses, and this indicates the effectiveness of the proposed device. Owing to the simplicity and availability of the resonator system, its wide utilization in the monitoring of a variety of film polymerization processes, including photoresistor application, is expected. © 2006 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 44: 2428–2439, 2006     

价格波动对进出初级产品行业的影响

初级产品生产行业有两大特点：一是其初级投资有较大的不可逆转性，二是其产品价格具有较大的随机性（不确定性）。这两点的同时存在，给进入和退出初级产品行业造成壁垒。     

Seven novel seco-prezizaane-type sesquiterpenes from the pericarps of Illicium merrillianum

Seven new seco-prezizaane-type sesquiterpenes were isolated from the methanol extract of the pericarps of Illicium merrillianum. Their structures were elucidated as 3-deoxypseudoanisatin (1), 2beta-hydroxy-3,6-dedioxypseudoanisatin (2), 8alpha-hydroxy-10-deoxycyclomerrillianolide (3), 10beta-hydroxypseudoanisatin (4), 10beta-hydroxycyclopseudoanisatin (5), 1,6-dihydroxy-3-deoxyminwanensin (6), and 8-deoxymerrilliortholactone (7) by analyses of their spectroscopic data and chemical transformation. Compounds 4 and 5 as well as 6 and 7 coexist as a keto/acetal equilibrated mixture in methanol solution.     

Evaluation of radioimmunoassay of the blood tobramycin level for the purpose of setting the dosage based on the clinical pharmacokinetic theory and a comparison of radioimmunoassay with other assay methods

With the purpose to use for therapeutic drug monitoring (TDM), blood concentrations of tobramycin (TOB) in each patient were measured by radioimmunoassay (RIA). A RIA kit of TOB (Clinical assay-Japan Travenol) was evaluated for precision and recovery, in that partial improvement of the method was made, in order to measure low level of TOB. The RIA was compared with high-performance-liquid-chromatography (HPLC), bioassay (BA) and 2 kinds of enzyme immunoassay (EIA) (EMIT and SLFIA). The RIA of TOB revealed high precision (1.8-2.4% in C.V.) and high reproducibility (5.0-6.9% in C.V.). It was found that this RIA kit can be used for measuring low level of serum TOB concentrations by a modification of the method. The total range of measurable blood level is from 0.1 to 16.0 micrograms/ml. The nearly one to one correspondence was observed between RIA and other 4 methods, when 154 samples obtained from 18 cases were measured. A representative case of TDM for TOB was demonstrated, in which predicted concentrations agreed fairly well with actual measured values at steady state. It was concluded that the RIA kit is useful for clinical application of TDM for the adequate dosage regimen of TOB. Modification of the method for rapid assay of a small number of samples will increase the clinical usefulness.