用一类特定的双耦合Duffing振子系统检测强色噪声背景中的周期信号

通过分析耦合参数作用、系统所呈现大尺度周期相态的复杂性以及与系统在无噪声条件下状态的比较，得出耦合振子系统的动力学行为比同类单振子系统的复杂，周期相态更稳定、抗噪能力更强.用构造的一类含特定恢复力项双中强度耦合Duffing振子系统检测色噪声背景中的谐波、方波信号，信噪比分别达到-111.0和-108.45dB. 关键词： 特定双耦合 Duffing振子系统 色噪声 周期信号 信噪比     

脉冲激光偏振方向对氮分子高次谐波的影响——基于含时密度泛函理论的模拟

采用含时密度泛函方法,结合赝势模型和电子交换相关作用的广义梯度近似,模拟了氮分子在超强飞秒激光脉冲作用下的高次谐波产生现象,并研究了激光脉冲偏振方向对氮分子高次谐波的影响.结果表明氮分子的高次谐波谱具有典型原子谐波谱的特征;谐波谱强度随着θ(激光偏振方向与分子轴向夹角)的增大而减小.这与J.Itatanl在Nature上报道的实验结果基本一致.     

过量Zn对β-Zn4Sb3热电性能影响的研究

采用真空熔融缓冷方法制备了单相β-Zn4Sb3以及含有过量Zn的β-Zn4Sb3块体热电材料.在300—700K的温度范围内测试了材料的电导率、Seebeck系数和热导率,研究了β-Zn4Sb3化合物中过量Zn的分布状态及其对材料热电性能的影响规律.结果表明：过量的Zn作为第二相较均匀的分布在β-Zn4Sb3的晶界上,随着Zn含量增加,材料电导率和热导率上升,Seebeck系数下降,Zn第二相的引入能有效提高材料的功率因子,Zn过量2at%的材料在700K时其ZT值达到1.10.     

Eu3+离子在微晶玻璃研究中的探针作用

制备出单掺Eu3+离子的氟氧化物玻璃陶瓷系列样品,利用Eu3+离子作为荧光探针,通过热处理前后Eu3+离子发射光谱中电偶极子跃迁与磁偶极子跃迁强度比值的变化表征在玻璃材料中微晶是否形成,分析了Eu3+离子荧光发射谱中电偶极子跃迁与晶体场对称性的关系,进一步表征了稀土离子所处微晶晶格场的变化.     

丙烯腈γ辐射聚合的NMR研究

用¹H NMR、¹³C NMR谱、自旋-晶格弛豫时间（T₁）和自旋-自旋弛豫时间（T₂）研究了丙烯腈在⁶⁰Co γ射线辐射聚合后的大分子结构变化与大分子链的运动. 结果表明随着辐射剂量增大，在单体形成聚合物的过程中，聚合物主链上出现了少量的-OH基团，继续增大辐射剂量， -OH部分被氧化. 对聚合物溶液的变温氢谱的研究表明，溶剂中的残余水与上述-OH形成氢键，且随着温度升高氢键被破坏，同时H₂O与-OH之间还存在着质子交换. 利用¹³C NMR谱对丙烯腈辐射聚合的产物进行了序列结构分析. 对T₁和T₂的研究表明，辐射剂量的增大并未影响到聚丙烯腈的链运动，证明了在丙烯腈的辐射聚合过程交联反应未发生.     

Features of the total disintegration events of heavyemulsion targets caused by 4.5A GeV/c16O

Total disintegration events produced by 4.5\,A GeV/c $^{16}$O--AgBr interactions are analysed to investigate the characteristics of secondary charged particles produced in such collisions. The multiplicity distributions of grey, black, and relativistic charged particles can be well represented by Gaussian distribution. The average multiplicity of grey particles is found to increase with the mass of projectile increasing, while that of black particles is found to decrease with the mass of projectile increasing. This result is in good agreement with the prediction of fireball model. Finally, the linear dependence between grey and black particles is observed, but there is no distinct dependence between the production of relativistic charged particles and the target excitation.     

Mn替代对Dy2AlFe16-xMnx化合物的结构和磁性的影响

通过X射线衍射及磁测量手段研究了Dy2AlFe16-xMnx化合物的结构和磁性.研究结果表明Dy2AlFe16-xMnx化合物具有六角相的Th2Ni17型结构.对x=1,2的样品采用X射线热膨胀测定法在104-647K的温度范围内测量了其热膨胀性质,发现这些化合物在低温下存在热膨胀反常现象,在居里点附近出现负膨胀性质.对自发磁致伸缩的研究结果表明Dy2AlFe16-xMnx化合物中存在着较强的各向异性的自发磁致伸缩,随着Mn含量的增加,其低温下的自发体磁致伸缩减弱.磁测量结果表明Mn的替代导致Dy2AlFe16-xMnx化合物的居里温度及自发磁化强度急剧下降.     

Effects of Nb2O5 on thermal stability and optical properties of Er3+-doped tellurite glasses

Er³⁺-doped tellurite glasses with molar compositions of xNb₂O₅-(14.7-x)Na₂O--10ZnO--5K₂O--10GeO₂-- 60TeO₂--0.3Er₂O₃ (x=0, 3, 5, 7 and 9) have been investigated for developing 1.5~μm fibre and planar amplifiers. The effects of Nb₂O₅ on the thermal stability and optical properties of Er³⁺-doped tellurite glasses have been discussed. It is noted that the incorporation of Nb₂O₅ (x=5) increases the thermal stability of tellurite glasses significantly. Er³⁺-doped niobium tellurite glasses exhibit a large stimulated emission cross-section (7.2\times 10^-21- 10.7×10^-21~cm² and the gain bandwidth, FWHM×\sigma_e^{\rm peak} (274\times 10^-28 - 480×10^-28~cm³), which are significantly higher than that of silicate and phosphate glasses. In addition, the intensity of upconversion luminescence of the Er³⁺-doped niobium tellurite glasses decreases rapidly with increasing Nb₂O₅ content. As a result, Er³⁺-doped niobium tellurite glasses might be a potential candidate for developing laser or optical amplifier devices.     

The stereochemistry of 1,2-additions of allylmagnesium, allylindium, and allylbismuth to cyclohexenones

Allylmagnesium, allylindium, and allylbismuth generally showed a preference for axial addition to cyclohexenones. Allylmagnesium was the most stereoselective. Reactions with an α-methylated enone (carvone) were the most selective, except that allylbismuth was unreactive with this substrate.     

Preparation and characterization of ZnO nanorods from NaOH solutions with assisted electrical field

ZnO naorods on ZnO-coated seed substrates were fabricated by solution chemical method from Zn(NO₃)₂/NaOH under assisted electrical field. The working mechanism of electrical field was analyzed and the factors affecting the rod growth such as potential, precursor concentration and growth temperature were elucidated. The structural and optical properties are characterized by SEM, TEM, XRD, HRTEM and UV-vis. The results indicated that the nanorods have wurtzite structure without electrical field and are primarily of zincite structure under electrical field; when the electrical field is 1.1-1.3 V, not only the elevation of ion diffusion and adsorption lower the crystallite/solution interfacial energy and then the crystal nucleation barrier by increasing charge intensity, but also the production of H⁺ through oxidation of OH⁻ increases properly the degree of solution supersaturation near the substrate, and thus lowers the activation energy. Both the two processes do favor to rod growth. With increasing precursor concentration in this system, the average diameter and length of ZnO nanorods increase, leading to decreasing of optical transmittance. The maximum rod growth rate at given concentration of Zn²⁺ occurs at a specific temperature.