Theoretical studies of mechanisms of cycloaddition reaction between difluoromethylene carbene and acetone

Mechanisms of the cycloaddition reaction between singlet difluoromethylene carbene and acetone have been investigated with the second‐order Møller–Plesset (MP2)/6‐31G* method, including geometry optimization and vibrational analysis. Energies for the involved stationary points on the potential energy surface (PES) are corrected by zero‐point energy (ZPE) and CCSD(T)/6‐31G* single‐point calculations. From the PES obtained with the CCSD(T)//MP2/6‐31G* method for the cycloaddition reaction between singlet difluoromethylene carbene and acetone, it can be predicted that path B of reactions 2 and 3 should be two competitive leading channels of the cycloaddition reaction between difluoromethylene carbene and acetone. The former consists of two steps: (i) the two reactants first form a four‐membered ring intermediate, INT2, which is a barrier‐free exothermic reaction of 97.8 kJ/mol; (ii) the intermediate INT2 isomerizes to a four‐membered product P_2b via a transition state TS2b with an energy barrier of 24.9 kJ/mol, which results from the methyl group transfer. The latter proceeds in three steps: (i) the two reactants first form an intermediate, INT1c, through a barrier‐free exothermic reaction of 199.4 kJ/mol; (ii) the intermediate INT1c further reacts with acetone to form a polycyclic intermediate, INT3, which is also a barrier‐free exothermic reaction of 27.4 kJ/mol; and (iii) INT3 isomerizes to a polycyclic product P₃ via a transition state TS3 with an energy barrier of 25.8 kJ/mol. © 2006 Wiley Periodicals, Inc. Int J Quantum Chem, 2007     

典型钙/镁基吸附剂对二氧化硒吸附特性研究

针对钙/镁基矿物吸附剂的主要组分CaO、CaCO₃、MgO在500-800 ℃下对Se的吸附特性进行研究，并选取天然矿物方解石、白云石研究其对Se的吸附效果，且对矿物煅烧所得CaO进行吸附实验。结果表明，三种组分中CaO的吸附效果最佳，800 ℃时单位质量CaO对Se的吸附量可达368 mg/g。CaCO₃对Se的吸附在700 ℃时效果最佳且其吸附产物的热稳定性较好。镁基吸附剂仅在中温段对Se具有一定吸附效果。方解石对Se的吸附效果随温度变化趋势与CaCO₃相似，因其较好的孔隙结构，吸附效果略优于CaCO₃。煅烧方解石得到的F-sor对Se的吸附效果优于CaO和CaCO₃煅烧得到的C-sor，这与其良好的比表面积、孔隙结构与抗烧结能力有关，且F-sor吸附产物的热稳定性相对较好。F-sor对Se的吸附量最高可达403 mg/g。     

新型高吸水聚合物凝胶型屏蔽暂堵剂MTC-1的合成及性能

以丙烯酸（AA）、丙烯酰胺（AM）、2-丙烯酰胺基-2-甲基丙磺酸（AMPS）为原料，蒙脱土（MMT）为改性剂，过硫酸钾和无水亚硫酸氢钠为氧化还原引发体系，六亚甲基四胺（C₆H₁₂N₄）为交联剂，采用水溶液聚合法合成了一种新型高吸水聚合物凝胶型屏蔽暂堵剂（MTC 1），其结构经IR表征。在最优合成条件（AM/AMPS/AA=11/7/1, m/m/m，引发剂加量0.6 wt%，于45 ℃反应2.5 h）下，MTC-1的最大吸水倍率为1006倍。岩心流动实验结果表明：MTC-1的堵水性能较高，封堵效率达到83.72%。     

Hypericin-Induced Phototoxicity in Cultured Fibroblasts and Swine Erythrocytes

Hypericin is a naturally occurring photosensitizer, whose presence in plants has been responsible for cutaneous phototoxicity in grazing animals. The photosensitizing properties of this agent have recently been exploited in models for anti-tumor and anti-viral activity. The cytotoxicity of hypericin and light was assessed in 3T3 mouse fibroblasts using the MTT [3-(4, 5-dimethylthiazol-2-yl)-2, 5-diphenyl tetrazolium bromide)] assay and the lactate dehydrogenase (LDH) leakage assay. Membrane damage was assessed in swine erythrocytes using hemolysis, potassium (K⁺) leakage and formation of lipid hydroperoxides. Concentration- and light-dependent decreases in fibroblast viability were seen starting at hypericin concentrations of 1.25 μM and light power flux levels of 24 J/cm² using a visible light source and at 0.417 μM hypericin and a similar light dose using a solar simulator, No LDH leakage was observed at hypericin concentrations up to 30 μM and visible light up to 144 J/cm². Light-and/or concentration-dependent increases in hemolysis, K⁺ leakage and formation of lipid hydroperoxides in red blood cell (RBC) membranes were observed, but at concentrations and light doses much greater than those required to induce cytotoxicity in fibroblasts. Lipid peroxidation and hemolysis occurred at 15 μM hypericin and 24 J/cm² (visible light source). Potassium ion leakage occurred at concentrations and light levels as low as 5 μM and 12 J/cm² or 15 μM and 4.8 J/cm² (visible light source) but was still a less sensitive indicator than fibroblast cytotoxicity. Evidence for both type I and type II reactions was shown in RBC membranes by TLC analysis of cholesterol products. In the absence of light, hypericin appears to be relatively nontoxic in the models tested.     

4,5-环氧环己烷1,2-二甲酸单丁酯单缩水甘油酯/m-PDA的热固化特征

本文叔述了4,5-环氧环己烷1,2-二甲酸单丁酯单缩水甘油酯(DME-47)/间-苯二胺(m-PDA)体系的热固化特征。结果表明,由于DME-47中羧酸缩水甘油酯型环氧基的反应活性远大于脂环环氧基。所以,DME-47/m-PDA体系固化反应明显地分两阶段进行。由TBA恒温固化动力学数据求得体系在100—160℃表观反应活化能E_α=13.9kcal/mol,在160—240℃E_α=16.6kcal/mol,根据实验数据按Arrhenius关系式推算,本体系在室温25℃下可以存放80天左右而不凝胶化,20℃下可存放120天左右。     

K3Na5(H2NCH2CH2NH3)2{(VO)12O6[B3O6(OH)]6}(H2O)•12H2O的合成与晶体结构

利用水热合成技术成功制备出一种新型多钒硼氧化合物， 用X射线单晶衍射分析技术对其晶体结构和分子结构进行了确定。结果表明在该化合物中多钒硼氧阴离子具有一个新颖的三明治结构。上下两个结构单元都是由六个VO₅四角锥交替地通过顺式和反式共边的方式连接起来构成的一个钒氧三角形结构。中间的结构单元是由BO₃平面三角形和BO₄四面体以共角的方式相互连接形成的一个折叠型的B₁₈O₃₆(OH)₆环。三明治结构中层与层之间通过桥氧相连。一个水分子处于它的核心位置上，与每个VO₅四角锥中的钒原子都保持几乎相等的距离。该化合物及其晶体中存在着丰富的化学结构和成键信息，同时也有作为氧化还原反应催化剂的潜能。     

正庚烷在β沸石负载碳化钼催化剂上的异构化研究

利用程序升温还原法制备了β沸石负载碳化钼催化剂。XRD表征显示，利用正戊烷作为碳源得到了对异构化具有活性的βMo2C。以正庚烷为模型反应物，在连续流动固定床反应装置上考察了温度、压力、空速和氢烃比对βMo2C/β沸石催化剂临氢异构化反应性能的影响。获得了β沸石负载碳化钼催化剂上正庚烷异构化的最佳反应条件温度270℃～275℃，压力1.0MPa～1.5MPa，体积空速1.0h－1，氢烃体积比200∶1。在最佳条件下反应物转化率为82%，选择性和异构产物收率分别达到71%和58%。     

新型含氟聚芳醚酮的合成与表征

聚芳醚酮具有很高的热稳定性和优良的电性能及机械性能 ,已经被广泛应用于宇航、电子及核能等高技术领域 [1] .氟元素的引入可以降低材料介电常数、折光指数和吸水率 ,提高热稳定性、溶解性和阻燃性 ,增加材料透明度 ,使这类聚合物在光电子、光学和微电子等应用领域的研究倍受关注 [2～ 4 ] .本文在合成含三氟甲基苯侧基的聚芳醚酮 [5] 的基础上 ,设计并合成了新型的含氟量更高的单体和聚合物 ,并对其性能进行了初步研究 .1　实验部分1 .1　试剂与仪器　 [3,5 -二 (三氟甲基 ) ]苯代对苯醌 (自制 ) ;锌粉 ,A.R.级 ,天津化学试剂一厂产品 ;…     

应变速率和电位对应力腐蚀裂纹扩展的影响

以滑移-溶解-再钝化模型为基础,推导出应力腐蚀裂纹扩展速率与裂尖应变速率和电位之间的理论公式.计算表明,在裂纹扩展速率与裂尖应变速率的关系曲线中有两个特征区域.裂纹扩展速率在区域I随裂尖应变速率增加而增大,而在区域II不随裂尖应变速率的改变而变化.用慢应变速率拉伸技术（SSRT）测量了304L不锈钢的裂纹增长速率.当电位控制在区域II的阳极区时,理论计算的裂纹扩展速率与实验得到的结果比较吻合.     

Remarkable nanosize effect of zirconia in Au/ZrO2 catalyst for CO oxidation

Nanosize effect of ZrO2 in Au/ZrO2 catalyst was studied by deposition-precipitation of Au nanoparticles in similar sizes (4-5 nm) on ZrO2 nanoparticles of varying sizes. The catalysts were characterized with XRD, TEM, XPS, and nitrogen adsorption to understand the effect of ZrO2 particle size on the catalytic nanostructures. Nanocomposite Au/ZrO2 catalysts consisting of comparably sized Au-metal (4-5 nm) and ZrO2 (5-15 nm) nanoparticles are found advantageous over those containing similarly sized Au-metal but larger ZrO2 (40-200 nm) particles for CO oxidation. This finding may have important implications on the designed preparation of advanced nanostructured catalysts and other chemical materials.