DFT mechanistic study of the H2‐assisted chain transfer copolymerization of propylene and p‐methylstyrene catalyzed by zirconocene complex

DFT computations have been performed to investigate the mechanism of H₂‐assisted chain transfer strategy to functionalize polypropylene via Zr‐catalyzed copolymerization of propylene and p‐methylstyrene (pMS). The study unveils the following: (i) propylene prefers 1,2‐insertion over 2,1‐insertion both kinetically and thermodynamically, explaining the observed 1,2‐insertion regioselectivity for propylene insertion. (ii) The 2,1‐inserion of pMS is kinetically less favorable but thermodynamically more favorable than 1,2‐insertion. The observation of 2,1‐insertion pMS at the end of polymer chain is due to thermodynamic control and that the barrier difference between the two insertion modes become smaller as the chain length becomes longer. (iii) The pMS insertion results in much higher barriers for subsequent either propylene or pMS insertion, which causes deactivation of the catalytic system. (iv) Small H₂ can react with the deactivated [Zr]?pMS?PP_n facilely, which displace functionalized pMS?PP_n chain and regenerate [Zr]? H active catalyst to continue copolymerization. The effects of counterions are also discussed. © 2014 Wiley Periodicals, Inc. J. Polym. Sci., Part A: Polym. Chem. 2015 , 53, 576–585     

QEPAS系统中石英音叉模态仿真计算与研究

对石英音叉增强型光声光谱(QEPAS)系统中常用的石英音叉进行了有限元模态计算，获得石英音叉前6阶振型与模态频率，认知了第4阶对称摆动振型为有效振动，利用单因素法分析了石英音叉的音臂长度l₁、音臂宽度w₁、音臂厚度t、音臂切角θ、音臂圆孔直径d及音臂圆孔高度h对低阶有效共振频率(Fre)的影响，敏感度依次为： l₁> w₁>d>θ>t>h，考虑实际设计情形，筛选出了l₁，w₁，d与h四个石英音叉设计变量，采用Box-Behnken实验设计方案与RSM(response surface methodology)方法，以Fre为函数目标，建立l₁，w₁，d与h的二次回归响应面模型，得到了参数之间的交互作用，利用Design-Expert软件对响应面模型进行设计参数反求，结果表明，在15 000 Hz≤Fre≤25 000 Hz计算区域内误差较小，基本满足QEPAS系统的计算需求，所提出的研究与设计方法具有一定通用性，可为QEPAS系统中石英音叉结构参数设计提供参考。     

Metabolic Profiling of Amino Acids by Liquid Chromatography–Tandem Mass Spectrometry (LC–MS) to Characterize the Significance of Glutamine in Triple-Negative Breast Cancer (TNBC)

Triple-negative breast cancer (TNBC) is considered to be aggressive based on its low overall survival and disease-free rates. Currently, there is no molecular-targeted therapy. The identification of a suitable biomarker is still a research focus for TNBC at the present time. Amino acid metabolism fulfills multiple important physiological roles in humans. Their metabolic abnormalities have been reported in numerous cancer studies and amino acid pathways may also be chemotherapeutic targets. This study reports the profiling analysis of amino acids in TNBC and non-TNBC cell lines for detecting biomarkers based on the strategy of N-phosphorylation labeling with liquid chromatography–tandem mass spectrometry (LC–MS). Glutamine (Gln) was found to be significantly down-regulated in TNBC cells because it was largely absorbed and consumed in the TNBC cell lines. These results indicate faster proliferation of TNBC and higher consumption of glutamine to meet the material and energy demand, suggesting its potential role in TNBC progression. Hence, glutamine may be regarded as a biomarker and Gln-targeted approaches may become a new therapeutic strategies for TNBC.     

Directing-Group-Free C7-Alkylations of N-Alkylindoles Mediated by Cationic Zirconium Complexes: Role of Brønsted Acid for Catalytic Manifold

Highly position selective alkylations of N-alkylindoles at C7-positions have been enabled by cationic zirconium complexes. The strategy provides a straightforward access to install alkyl groups at C7-positions of indoles without a complex directing group. Mechanistic studies provided support for the importance of Brønsted acids in the catalytic manifold.     

双掺(Tm3+,Tb3+)LiYF4激光器1.5 μm波长激光阈值分析

由速率方程推出了双掺（Tm^3 ,Tb^3 ）离子准四能级系统的激光阈值解析式，讨论了Tm^3 和Tb^3 离子之间的相互作用。分析了1.5μm波长附近的激光阈值和Tm^3 、Tb^3 离子的掺杂原子数分数及晶体长度的关系。结果表明，对于对应Tm^3 离子^3H4→^3F4跃迁的约1.5μm波长的激光，激活离子Tm^3 的掺杂原子数分数过大时，交叉弛豫作用将使系统阈值迅速增加。Tb^3 离子的加入，一方面能抽空激光下能级，起到降低阈值的作用；另一方面亦减少了激光上能级的寿命，使阈值升高。故Tb^3 离子有最佳掺杂原子数分数。对于Tm原子数分数为y=0.01的Tm:LiYF4晶体，Tb^3 离子的最佳掺杂原子数分数为0.002左右，同时表明，激光阈值与晶体长度有关。最佳晶体长度与Tm^3 、Tb^3 离子的掺杂原子数分数以及晶体的衍射损耗和吸收损耗有关。     

玻璃陶瓷材料中Tm3+离子红外到蓝色上转换发光

系统研究了PbF2+GeO2+WO3ⅩⅣTmF3玻璃陶瓷材料中,在近红外光(1.06μm)激发下,Tm3+离子的发光特性.实验中观测到Tm3+离子的两组峰值位置分别在20920cm-1和22173cm-1的蓝色上转换发光,并证实这两组上转换发光分别与吸收三个和四个光子有关,同时建立了上转换发光的模型.为了选择最佳掺杂浓度,详细地测量了Tm3+离子峰值为20920cm-1的蓝色上转换发光强度与TmF3浓度的关系.     

n(Zn)：n(Ga)比值对合成ZnGa2O4结构及光致发光性能的影响

以ZnO和HGaO₂为原料,用不同配比合成出系列ZnGa₂O₄,并对其晶体结构和发光性能进行了研究。用荧光分光光度计检测了ZnGa₂O₄的激发和发射光谱,用X射线衍射仪检测了ZnGa₂O₄的衍射图谱,用热重差热仪绘制了TGA-DAT曲线。对检测结果分析认为:1.ZnGa₂O₄属于尖晶石结构,稍过量的Zn或Ga能进入ZnGa₂O₄结构中,并对ZnGa₂O₄的晶格常数产生一定影响。2.ZnGa₂O₄存在两个自激发光中心,当Ga稍过量时,自激发光中心是四面体镓氧键[T_d(Ga-O)],最大激发波长约248nm,最大发射波长约367nm;当Zn稍过量时,自激发光中心是八面体镓氧键[O_h(Ga-O)],最大激发波长约270nm,最大发射波长约441nm。当n(Zn):n(Ga)在理论值附近,激发和发射光强度最大,而且光谱峰位发生了红移。3.ZnGa₂O₄的热稳定性能非常好。上述结论对研究ZnGa₂O₄基质或掺杂的发光材料具有一定意义。     

微球动态涂敷状态实时监测光学系统的设计

 介绍了一种可用于实时监测直径0.2～1.0 mm激光核聚变靶球涂敷状态的光学系统的设计，系统采用环形LED照明系统以适合特殊的照明要求，用Petzval型物镜使500 mm处的微球清晰成像于CCD像面上，CCD输出的图像电信号经图像采集卡转换成数字信号，最后该数字信号由计算机进行处理，实现了系统对靶球膜层涂敷作业的自动监控，大大提高了涂敷效率。所设计的系统轴上点最大弥散斑直径为12.6 mm,轴外最大弥散斑直径为15.8 mm，整个视场的像质比较均匀,分辨率较高，对于波长522 nm的光线，场曲和畸变分别小于15 mm和0.012%，像质优良。