Navier-Stokes方程带Backtracking技巧的两重网格算法

1 引 言考虑二维不可压 Navier-Stokes方程:     

传输线中脉冲信号反射波的测量和应用

将高频单脉冲信号输入同轴电缆，借助数字存储示波器记录输入、输出端的波形和相对延时，可以测量传输线的电缆长度和衰减系数，同时观察脉冲波形因色散引起的畸变．     

一个在水稻胚胎中差异表达基因的分离鉴定

通过筛选水稻开花后48～50h的原胚和120～122h的分化胚的cDNA文库,得到一个在胚胎发育过程中表达有差异的克隆,命名为OsEES,测序结果显示OsEES含有一个预测的亚精氨合成酶结构域,编码一个大小约38×103(pI6.5)的蛋白.同时RNA原位杂交的结果显示开花48～50h的原胚中的信号强度明显大于开花120～122h的分化胚,表明OsEES可能在水稻胚胎发生过程中起到一定的调控作用.     

Low-threshold, high-efficiency, high-repetition-rate optical parametric generator based on periodically poled LiNbO3

We report a high-repetition-rate optical parametric generator (OPG) with a periodically poled lithium niobate (PPLN) crystal pumped by an acousto-optically Q-switched CW-diode-end-pumped Nd:YVO_4 laser. For the maximum 1064nm pump power of 970mW, the maximum conversion efficiency is 32.9% under the conditions of 250℃, 1064nm pulse repetition rate of 22.6kHz and pulse width of 12ns, and the PPLN OPG threshold in the collinear case is less than 23.7μJ. The output power increases with the increase of the crystal temperature. The 1485－1553nm signal wave and 3383－3754nm idler wave are obtained by changing the temperature and the angle of the PPLN crystal.     

Melt rheology of polylactide/montmorillonite nanocomposites

In this article, the linear and nonlinear shear rheological behaviors of polylactide (PLA)/clay (organophilic‐montmorillonite) nanocomposites (PLACNs) were investigated by an Advanced Rheology Expanded System rheometer. The nanocomposites were prepared by master batch method using a twin‐screw extruder with poly(ε‐caprolactone) (PCL) as a compatibilizer. The presence of org‐MMT leads to obvious pseudo‐solid‐like behaviors of nanocomposite melts. The behaviors caused by the formation of a “percolating network” derived from the reciprocity among the strong related sheet particles. Therefore, the storage moduli, loss moduli, and dynamic viscosities of PLACNs show a monotonic increase with MMT content. Nonterminal behaviors exists in PLACNs nanocomposites. Besides the PLACNs melts show a greater shear thinning tendency than pure PLA melt because of the preferential orientation of the MMT layers. Therefore, PLACNs have higher moduli but better processibility compared with pure PLA. © 2007 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 45: 3189–3196, 2007     

Decentered twisted Gaussian Schell-model beams and their propagation through a misaligned first-order optical system

The propagation properties of decentered twisted Gaussian Schell-model (DTGSM) beams passing through a misaligned first-order optical system are studied. The explicit expressions for the cross-spectral density function and Wigner distribution function of the output beam are derived, which retain their form unchanged. It is shown that the DTGSM beams preserve their closed property. The second-order moments matrix and the Wigner distribution function evolve with the usual laws, whereas the first-order moments matrix varies, as if a ray passes through such system. The propagation of DTGSM beams through an aligned first-order optical system is treated as the limiting case that corresponds to the vanishing misalignment parameters.     

光学扫描全息术中的孪生像噪音及消除

阐述了光学扫描全息术的基本原理,分析了孪生像噪音的来源,提出了一种新的数字滤波方法.计算机仿真结果表明:孪生像噪音以振荡形式传播,降低了重构图像的信噪比,影响了重构图像的分辨率;用电子复用技术,即用复全息图函数代替实全息图函数的方法可以有效地消除孪生像噪音;采用单一通道对信号进行处理,即只用一个实全息图函数,通过数字滤波方法同样可以消除孪生像噪音,该方法简便、实用而有效.     

Preparation,thermal properties,and flame retardance of epoxy–silica hybrid resins

A novel epoxy system was developed through the in situ curing of bisphenol A type epoxy and 4,4′‐diaminodiphenylmethane with the sol–gel reaction of a phosphorus‐containing trimethoxysilane (DOPO–GPTMS), which was prepared from the reaction of 9,10‐dihydro‐9‐oxa‐10‐phosphaphenanthrene‐10‐oxide (DOPO) with 3‐glycidoxypropyltrimethoxysilane (GPTMS). The preparation of DOPO–GPTMS was confirmed with Fourier transform infrared, ¹H and ³¹P NMR, and elemental analysis. The resulting organic–inorganic hybrid epoxy resins exhibited a high glass‐transition temperature (167 °C), good thermal stability over 320 °C, and a high limited oxygen index of 28.5. The synergism of phosphorus and silicon on flame retardance was observed. Moreover, the kinetics of the thermal oxidative degradation of the hybrid epoxy resins were studied. © 2003 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 41: 2354–2367, 2003     

Synthesis of MgAl2O4 Spinel Nanometer Powder via Biology Polysaccharide Assisted Sol-Gel Process

A novel and cost-effective sol-gel process for preparation of MgAl₂O₄ spinel nanometer powders has been developed in this study. A solution of magnesium and aluminum nitrates in stoichiometric proportion was successfully embraced in the biology polysaccharide gel network, formed by the synergistic interaction between xanthan gum (XG) and locust bean gum (LBG) utilizing their broad-spectrum stability of salt tolerance and character of transformation from sol to gel on the condition of proper temperature and relative proportion of polymeric components. Dry gel could be obtained by vacuum dehydration of aqueous gel at low temperatures. Monolithic MgAl₂O₄ spinel nanometer powders were produced by calcining the dry gel above 800°C, with average crystallite size of 20 nanometers.