助剂对Cu/Cr催化剂上甲醇部分氧化制氢的活性影响

曾研究了Cu/Cr二元催化剂上甲醇部分氧化制氢的反应，发现当Cu/Cr比为6：4时，催化剂的Cu^0比表面积最大，呈现出较好的活性。在Cu/Cr（6：4）催化剂中添加Fe,Zn,Al等8种助剂，考察其对甲醇部分氧化制氢催化性能的影响，并着重研究了Zn助剂的作用。实验结果表明，Zn的引入，有利于催化剂活性的提高。当Zn含量为10％时，催化剂活性最好。XRD表征结果表明，Cu/Cr催化剂的失活与其表面上的Cu物种烧结有关，Zn的引入可明显增强Cu/Cr（6：4）催化剂的热稳定性，提高其寿命。     

Studies on fluorenscence resonance energy transfer between CdS nanoparticles and DOCAI dyes

The water-soluble CdS nanoparticles were synthesized in aqueous solution. A novel fluorescence resonance energy transfer (FRET) system with CdS nanoparticles as energy donors and 3,30-diethyl-oxadicarbocyanine iodide (DOCAI) dyes as energy accepter has been developed.     

熔盐电解合成希土六硼化物的研究——REBO3、LiBO2和LiF体系熔盐电解合成RER6

本文在800℃和空气中电解REBO₃-LiBO₂-LiF熔盐体系合成了单相的REB₆.石墨川埚兼作容器和阳极.耐火金属棒如Cu和Mo等被悬吊在电解质中作为阴极.根据似二元体系LiBO₂-LiF和LiBO₂-LaBO₃的低熔点组成以La₂O₃、B₂O₃、Li₂CO₃和LiF为原料找到了具有较低熔点的熔盐体系.根据X射线粉末衍射,该熔体是由REBO₃、LiBO₂和LiF三个物相组成.     

环己硅烷类液晶化合物的量子化学研究

运用AM1和PM3两种SCF-MO方法，通过能量梯度全优化计算，给出20种环己硅烷类（苯基乙烷系）液晶化合物的稳定几何构型、电子结构和基本性质．联系有机电子结构理论进行了细致的讨论．     

Application of diaza-18-crown-6-capped beta-cyclodextrin bonded silica particles as chiral stationary phases for ultrahigh pressure capillary liquid chromatography

Two bonded chiral stationary phases (CSPs), 8-aminoquinoline-2-ylmethyl- and 8-aminoquinoline-7-ylmethyl-diaza-18-crown-6-capped [3-(2-O-beta-cyclodextrin)-2-hydroxypropoxy]propylsilyl silica particles (non-porous, 1.5 microm), have been prepared and evaluated using capillary liquid chromatography at high pressures (> or = 8000 p.s.i.). High column efficiency (up to 400 000 plates m(-1)) was achieved for chiral separations. These CSPs with two recognition sites, i.e. substituted-diaza-18-crown-6 and beta-cyclodextrin combined with high chromatographic efficiency provide good resolution of a variety of enantiomers and positional isomers in relatively short times under reversed-phase conditions. After inclusion of a Ni (II) ion from the mobile phase, the positively charged crown ether-capped beta-cyclodextrin facilitates specific static, dipolar, and host-guest complexation interactions with solutes.     

Development of a modified beta-cyclodextrin based fluorosensor for dipyridamole

2,6-O-diethyl-β-cyclodextrins were prepared and immobilized onto silica gel to develop a fluorosensor for dipyridamole. The analytical performance characteristics of the proposed sensor for analysis of dipyridamole were as follows: the detection limit was 0.8 nmol/L with a relative standard deviation of 1.4% for 10 determinations of 50 nmol/L of dipyridamole. The modification of β-CD improved the sensitivity and selectivity for measuring dipyridamole. The recommended method has been successfully tested for the determination of dipyridamole in clinical samples (urine and pharmaceutical preparations).