Importance of REP values when comparing the CALUX bioassay results with chemoanalyses results Example with spiked vegetable oils

Differences between chemical activated luciferase gene expression (CALUX) bioassay and chemoanalyses results are observed.This paper shows that calculations of the TEQ values using REP values instead of WHO TEF values give different results. The REP values do affect the results obtained by the CALUX technique. These differences are more marked for the dioxin like PCB compounds (CALUX TEQ values are lower than WHO TEQ values) than for the dioxin compounds (CALUX TEQ values are higher than WHO TEQ values).The CALUX results were compared with the concentrations of the congeners’ spiked into the oil.     

Enzyme electrokinetics: electrochemical studies of the anaerobic interconversions between active and inactive states of Allochromatium vinosum [NiFe]-hydrogenase

The cycling between active and inactive states of the catalytic center of [NiFe]-hydrogenase from Allochromatium vinosum has been investigated by dynamic electrochemical techniques. Adsorbed on a rotating disk pyrolytic graphite "edge" electrode, the enzyme is highly electroactive: this allows precise manipulations of the complex redox chemistry and facilitates quantitative measurements of the interconversions between active catalytic states and the inactive oxidized form Ni(r) (also called Ni-B or "ready") as functions of pH, H(2) partial pressure, temperature, and electrode potential. Cyclic voltammograms for catalytic H(2) oxidation (current is directly related to turnover rate) are highly asymmetric (except at pH > 8 and high temperature) due to inactivation being much slower than activation. Controlled potential-step experiments show that the rate of oxidative inactivation increases at high pH but is independent of potential, whereas the rate of reductive activation increases as the potential becomes more negative. Indeed, at 45 degrees C, activation takes just a few seconds at -288 mV. The cyclic asymmetry arises because interconversion is a two-stage reaction, as expected if the reduced inactive Ni(r)-S state is an intermediate. The rate of inactivation depends on a chemical process (rearrangement and uptake of a ligand) that is independent of potential, but sensitive to pH, while activation is driven by an electron-transfer process, Ni(III) to Ni(II), that responds directly to the driving force. The potentials at which fast activation occurs under different conditions have been analyzed to yield the potential-pH dependence and the corresponding entropies and enthalpies. The reduced (active) enzyme shows a pK of 7.6; thus, when a one-electron process is assumed, reductive activation at pH < 7 involves a net uptake of one proton (or release of one hydroxide), whereas, at pH > 8, there is no net exchange of protons with solvent. Activation is favored by a large positive entropy, consistent with the release of a ligand and/or relaxation of the structure around the active site.     

Unprecedented selective ipso-nitration of calixarenes monitored by the O-substituents

The electrophilic ipso-reactions of a tBu-calix[6]arene that presents alternate O-methyl and O-2-methylen-N-methyl-imidazolyl groups (1) at the small rim have been studied. Whereas 1 underwent per-sulfonation in sulfuric acid, it selectively reacted with nitric acid to yield a tris-nitro derivative. The ipso-nitration occurred regioselectively on the calixarene anisol units. The reaction has been studied with various tBu-calixarenes (2-11) presenting alternate anisol and phenol ether units. The regioselectivity of the process appeared to be correlated to the presence of a protonable site on the O-substituent. It is proposed that the corresponding protonated heteroatom (N for the amines, O for the amides and the carboxylic acid), situated in the gamma or epsilon position of the phenoxy moieties, deactivates the corresponding aromatic ring by removing electron density through intramolecular hydrogen bonding. The high control operated by the O-substituents at the small rim even allowed the selective ipso-nitration of partially detertiobutylated calixarene 1(H3). Hence, these findings open new routes to a wide range of nonsymmetrically substituted calixarenes at the large rim.     

Asymmetric base-mediated epoxide isomerisation

The base-mediated rearrangement of epoxides into allylic alcohols is a well-known synthetic transformation. The first enantioselective version of the reaction using a chiral base was reported in 1980. Since then, the reaction has received a lot of attention mostly due to the great usefulness of chiral allylic alcohols in organic synthesis. Major breakthroughs in the area were the first report on using a sub-stoichiometric amount of chiral base, and the development of chiral bases for a true catalytic reaction protocol. The present review covers the time from when the first asymmetric epoxide isomerisation reaction was reported (1980) up to now, focusing on the period 1997-2001.     

Relaxometric study of copper [15]metallacrown-5 gadolinium complexes derived from alpha-aminohydroxamic acids

Proton nuclear magnetic relaxation dispersion (NMRD) profiles were recorded between 0.24 mT and 1.4 T for lanthanum(III)- and gadolinium(III)-containing [15]metallacrown-5 complexes derived from alpha-aminohydroxamic acids and with copper(II) as the ring metal. The influence of the different R-groups on the proton relaxivity was investigated, and a linear relationship between the relaxivity and the molecular mass of the metallacrown complex was found. The selectivity of the metallacrown complexes was tested by transmetalation experiments with zinc(II) ions. The crystal structure of the copper [15]metallacrown-5 gadolinium complex with glycine hydroximate ligands is reported.     

Photolysis wavelength dependence of the translational anisotropy and the angular momentum polarization of O2(a 1Deltag) formed from the UV photodissociation of O3

The translational anisotropy and angular momentum polarization of the O(2)(a (1)Delta(g),v = 0;J = 15-27) molecular photofragment produced from the UV photodissociation of O(3) in the range from 270 to 300 nm have been determined using resonance-enhanced multiphoton ionization in conjunction with time-of-flight mass spectrometry. At the shortest photolysis wavelengths used, the fragments exhibit the anisotropic vector correlations expected from a prompt dissociation via the (1)B(2) <--(1)A(1) transition. Deviations from this behavior are observed at longer photolysis wavelengths with, in particular, the angular momentum orientation showing a significant reduction in magnitude. This indicates that the dissociation can no longer be described by a purely impulsive model and a change in geometry of the dissociating molecule is implied. This observation is substantiated by the variation of the translational anisotropy with photolysis wavelength. We also observe that the bipolar moments describing the angular momentum polarization of the odd J states probed are consistently lower in magnitude than those of the even J states and that this variation is observed for all photolysis wavelengths.     

Does charge carrier dimensionality increase in mixed-valence salts of tetrathiafulvalene-terminated dendrimers?

[structure: see text] In four new dendrimers terminated by 12 electroactive tetrathiafulvalenyl substituents, the tridimensional character of the inter- and intradendrimeric charge and electron transfer, and hence of the electroconductivity, is evidenced by examination of the electronic spectra of their corresponding neutral state and cation radical, dication, and mixed-valence salts, including a closed-shell anion.     

Activated carbon oxygen content influence on water and surfactant adsorption

This research investigates the adsorption properties of three activated carbons (AC) derived from coconut, coal, and wood origin. Each carbon demonstrates different levels of resistance to 2 M NaOH treatment. The coconut AC offers the greatest and wood AC the least resistance. The influence of base treatment is mapped in terms of its effects on specific surface area, micropore volume, water adsorption, and dodecanoic acid adsorption from both water and 2 M NaOH solution. A linear relationship exists between the number of water molecules adsorbed at the B-point of the water adsorption isotherm and the oxygen content determined from elemental analysis. Surfactant adsorption isotherms from water and 2 M NaOH indicate that the AC oxygen content effects a greater dependence on affinity for surfactant than specific surface area and micropore volume. We show a linear relationship between the plateau amount of surfactant adsorbed and the AC oxygen content in both water and NaOH phases. The higher the AC oxygen content, the lower the amount of surfactant adsorbed. In contrast, no obvious relationship could be drawn between the surfactant amount adsorbed and the surface area.     

1-Protected 5-amido 1,2,3-triazoles via ruthenium-catalyzed [3+2] cycloaddition of azides and ynamides

Ynamides react with various azides in the ruthenium-catalyzed Huisgen [3+2] cycloaddition reaction. This ruthenium-catalyzed azide-ynamide cycloaddition reaction yields 1-protected 5-amido 1,2,3-triazoles.     

Interpretation of CALUX results in view of the EU maximal TEQ level in milk

Analyses of dioxins in food have become increasingly important since the European Commission has enforced maximal toxic equivalent concentration (TEQ) levels in various food and feed products. Screening methodologies are usually used to exempt those samples that are below the maximum permitted limit and that can, therefore, be released to the market. In addition, one needs to select those samples that require confirmation of their dioxin TEQ level. When bioassays are used as screening tools, the interpretation of the obtained results should consider the higher variability and uncertainty associated with them. This paper explores the use of CALUX data as quantitative screening results. The validation of the method for the polychlorinated dibenzo-p-dioxins (PCDD)/F TEQ determination in milk samples is described with emphasis on the decision limit (CC) and the precision of the method. The decision limit amounts to 4.53 pg TEQ/g fat. Repeatability and within-lab reproducibility coefficients of variation are below 30%. The newly introduced parameter CC^* of 1.47 pg TEQ/g fat delimits with CC a range of suspicious results. These data are not significantly different from the maximum limit of 3 pg TEQ/g fat and should be confirmed by a confirmatory analytical method such as HRGC–HRMS.