X—射线荧光光谱测定甜饮料中微量元素

本文提出了低温蒸干和炭化制样Ｘ－射线荧光分析甜饮料中１６种微量元素的方法，试样在电热板上经低温蒸干，于马旨炉中３００℃炭化３０ｍｉｎ，在液压样品成形机上压制成样片进行测定，所测元素不需用任何基体校正，由微机从校正曲线查得含量，榈分析结果与ＩＣＰ－ＡＥＳ和ＡＡＳ法相吻合。     

Influence of the exchange‐correlation functional in all‐electron calculations of the vibrational frequencies of corundum (α‐Al2O3)

The equilibrium structural parameters, high‐ and low‐frequency dielectric tensors, Born effective charges, and Γ‐point vibrational frequencies of bulk Al₂O₃ corundum are calculated by using the periodic, ab initio program CRYSTAL, which adopts an all‐electron Gaussian‐type basis set. The effect of basis set and the performance of three different functionals, i.e., LDA, PW91, and B3LYP, are discussed. The mean absolute deviation from the measured frequencies is as small as 7 cm^?1 for both the LDA and B3LYP functionals, indicating that these functionals perform extremely well in this case. The mean absolute deviation increases to 18 cm^?1 when the PW91 functional is used. All three functionals reproduce the equilibrium geometry of corundum to a high level of accuracy, with LDA and B3LYP outperforming PW91 slightly. The comparison of the current all‐electron calculations with previous plane‐wave, pseudo‐potential calculations shows an overall similar performance. The results of isotopic substitution for both Al and O are also presented. © 2006 Wiley Periodicals, Inc. Int J Quantum Chem, 2006     

游离和溶胶-凝胶固定化甲醛脱氢酶酶促反应动力学的研究

采用溶胶-凝胶法对甲醛脱氢酶进行固定化，酶的包埋率超过了98％．在pH7附近、37℃下，以游离酶和固定化酶作催化剂，NADH为电子供体，进行了甲酸转化为甲醛的酶促反应．游离和固定化甲醛脱氢酶酶促反应都遵循Michaelis-Menten反应机理，用Dalziel提出的双底物酶促反应动力学方程进行拟合．固定化酶酶促反应速率为游离酶酶促反应速率的50％左右．固定化酶的动力学常数φ和米氏常数K高于游离酶，估计是凝胶基质孔中存在扩散效应所致．     

A novel synthesis of allyl and propargyl selenides in aqueous media promoted by indium

Allylic and propargyl bromides react smoothly with diorganyl diselenides in aqueous media to give allylic and propargyl selenides in moderate to good yields. The reaction need not be carried out in inert atmosphere. The speed is quicker than the same reactions in organic media.     

DETERMINATION OF DEGREE OF CRYSTALLINITY OF NYLON 1212 BY WIDE-ANGLE X-RAY DIFFRACTION

Based on the X-ray scattering intensity theory and using the approximate expression for the atomic scattering factor, the correction factors for three crystalline peaks and an amorphous peak of Nylon 1212 were calculated and the formula of degree of crystallinity of Nylon 1212 was derived by a graphic multipeak resolution method. The degree of crystallinity calculated from the WAXD method is compatible with those obtained by density and calorimetry methods.     

Printed plastic electronics and paperlike displays

Plastic electronic materials and high‐resolution printing methods may be important technologies for new classes of consumer electronic devices that are lightweight, mechanically flexible and bendable, and that can cover large areas at low cost. This article summarizes some of our recent work in this area. It focuses on the materials and patterning techniques that we used to produce plastic active‐matrix backplane circuits for a type of paperlike display. © 2002 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 40: 3327–3334, 2002     

Superabsorbent hydrogel composites

A new cost‐effective approach to enhance gel strength of superabsorbent hydrogels was invented. Superabsorbent hydrogel composites (SHCs) were prepared through an optimized rapid solution polymerization of concentrated partially neutralized acrylic acid in the presence of a crosslinking agent under normal atmospheric conditions. Kaolin was used as an inorganic component in the polymerization process to strengthen the hydrogel products. FT‐IR spectroscopy was used to confirm grafting of acrylic chains on to the surface of kaolin particles. Morphology of the products was studied by scanning electron microscopy (SEM). Compared with the kaolin‐free hydrogel (control), kaolin caused a reduced equilibrium swelling and swelling rate as low as 17–31% and 19–29%, respectively. Kaolin, however, resulted in enhanced gel strength as high as 21–35% compared to the control. Differential scanning calorimetry (DSC) and thermogravimetric analysis (TGA) were used to study thermal properties of the composites. The SHCs exhibited higher thermal stability than the control. Meanwhile, changes in certain thermal transitions reconfirmed the chemical interaction of the acrylic chain with kaolin. These thermostabilized strengthened superabsorbent hydrogels may be considered as good candidates for agricultural application to retain more water under soil pressure. Copyright © 2003 John Wiley & Sons, Ltd.     

Carbon‐based Nanosensors for Salicylate Determination in Pharmaceutical Preparations

Thiourea derivative‐based carbon paste electrode (TUD1‐CPE) was constructed as a potentiometric sensor for the determination of salicylate anion in pharmaceutical formulations, Aspocid® and Aspirin®. The optimized CPE contained 45.5 % graphite, 0.5 % reduced graphene oxide (rGO), 46.0 % nitrophenyl octyl ether (NPOE) plasticizer, 5.0 % TUD1 ionophore, and 3.0 % tridodecylmethyl ammonium chloride as additive. The incorporation of NPOE of high dielectric constant, and rGO in electrode caused better performance of the sensor; Nernstian response of 59.0 mV decade^?1 in the concentration range of 10^?1–10^?5 mole L^?1, a detection limit of 1×10^?5 mole L^?1 in a very short response time of 6 seconds. The prepared sensor showed high selectivity against similar anions (i. e. , benzoate, I^?, SCN^?). Selectivity was confirmed by calculating the formation constant (K_β) using sandwich membrane method, where K_β for TUD1‐salicylate is 10^0.43. Theoretical calculations at DFT‐B3LY/6‐31G** level of theory were performed to find interaction mechanism, Energies of HOMO and LUMO orbitals, non‐linear optical (NLO) properties (the electronic dipole moment (μ), first‐order hyperpolarizability (β), the hyper‐Rayleigh scattering (β_HRS) and the depolarization ratio (DR)), and other global properties; these calculations showed lower values of β and DR, higher value of β_HRS, and the shortest lengths of the four N?H bonds between TUD1 and salicylate which confirm their strong complexation and salicylate‐selectivity. Also, all the studied anion‐TUD1 exhibited relatively high NLO properties, and these results were considered as a preliminary study for investigating new types of NLO bearing materials. The sensors were applied successfully for the determination of salicylate anion in Aspocid® and Aspirin®.     

Theoretical and experimental studies of the electrochemistry of <Emphasis Type="Italic">p</Emphasis>-aminophenol on a golden electrode

The geometric parameters, vibrational frequencies, and thermochemical values of p-quinonimine (p-AQ) and p-aminophenol (p-AP) were computed ab initio (IIF) and by the density functional theory (DFT) method with the 6-31G(d, p) basis set. Cyclic voltammetry with a golden electrode of p-AP solutions in phosphate buffers at pH 7.30 showed that the standard electrode potential of half reaction for p-QI and p-AP was 0.728 V. The standard electrode potentials of half reactions for p-QI and p-AP were calculated using the free energies and solvation energies of p-QI, p-AP, p-benzoquinone (p-BQ), and hydroquinone (p-HQ). The results showed that the standard electrode potential of half reaction for p-QI and p-AP was 0.743 V at the B3LYP/6-31G(d, p) level and 0.755 V at the HF/6-31G(d, p) level. The standard electrode potentials computed at the B3LYP/6-31G(d, p) and HF/6-31G(d, p) levels were close to their experimental values. The article is published in the original.     

Cycloarsanes (AsCF3)n (n = 4, 5) – Precursors for the Highly Reactive Diarsene F3CAs=AsCF3

Tetrakis(trifluoromethyl) cyclotetraarsane (F₃CAs)₄ ( 2 ) was used to repeat the UV initiated [4+2]‐cycloaddition reaction of the diarsene F₃CAs=AsCF₃ ( 1 ) with cyclohexa‐1,3‐diene (CHD) and to isolate single crystals of the cycloadduct 4 for a X‐ray diffraction analysis. 4 crystallizes in the space group and contains the diarsene group in its E‐configuration. 2 was also applied for [2+2]‐cycloaddition reactions of 1 with tBuC≡P and MeC≡CNⁱPr₂, but in contrast to positive results with (F₃CP)₄ the products were too labile for isolation. However, 2 was successfully used at room temperature as precursor for coordinating 1 as π‐donor ligand to the Pd(PPh₃)₂ complex fragment yielding η²‐bis(trifluoromethyl)diarsene‐bis(triphenylphosphane)‐palladium(0) 5 , which was characterized by X‐ray diffraction of single crystals and by spectroscopic investigations (NMR, IR, MS). Attempts to prove the existence of the diarsene 1 , generated by different methods, by spectroscopic studies very probably failed due to its extreme reactivity, not allowing the necessary concentrations for detection. Quantum chemical calculations of the stability of 1 with respect to dimerization, the stability of the [2+2]‐cycloadduct with 1‐di(isopropyl)aminopropyne and the energy difference between 4 and the 2,3‐dimethyl‐1,3‐butadiene cycloadduct of 1 were performed to understand the considerable differences between 1 and the related diphosphene F₃CP=PCF₃.