Interaction between Metal in Metallo Enzyme and Small Biological Molecules

ＩｎｔｅｒａｃｔｉｏｎｂｅｔｗｅｅｎＭｅｔａｌｉｎＭｅｔａｌｌｏＥｎｚｙｍｅａｎｄＳｍａｌｌＢｉｏｌｏｇｉｃａｌＭｏｌｅｃｕｌｅｓ￥ＨｕＪｉｅ－Ｈａｎ；ＳｈｕＺａｎ－Ｙｏｎｇ；ＴａｏＬｉ－Ｍｅｉ；ＣｈｅｎｇＧｕｏ－Ｂａｏ（ＤａｌｉａｎＩｎｓｔｉｔｕｔ...     

丙酮一步法合成甲基异丁基酮催化剂研究

用浸渍法制备了丙酮一步法合成甲基异丁基酮负载型催化剂，考察了载体的预处理温度、添加镧助剂对催化剂性能的影响；用BET法测定了催化剂的表面积；采用H2-O2滴定法测定Pd的分散度．结果发现，用经过1．023K焙烧过的Al2O3为载体的催化剂具有较好的催化性能，添加镧助剂后催化剂的分散度、活性有较大的提高．     

Synthesis of 2,2＇-（Substituted Arylmethylene）bis（1,6,6-trimethyl 6,7,8,9-tetrahydrophenanthro[1,2-b]furan-10,11-dione） Derivatives

The reactions of tanshinone IIA with aromatic aldehydes have been investigated and several 2, T-（substituted arylmethylene） bis （1,6,6-trimethyl-6,7,8,9-tetrahydrophenanthro[1,2-b]- furan- 10, 11-dione） derivatives were obtained,     

Synthesis and Absorption Properties of New Na Specific Adsorbent Li（1＋x）AlxTi（2-x）（PO4）3

A new kind of adsorbent Li（1＋x）AlxTi（2-x）（PO4）3 was synthesized by solid state reaction method. The influence of the content of doping aluminum on the adsorbent Li（1＋x）AlxTi（2-x）（PO4）3 was investigated by XRD, while the morphology of powders was observed by SEM. The investigation of the adsorption properties showed that the adsorbent can selectively adsorb sodium with the adsorption capacity of 11.76 mg/g. The optimum conditions of adsorption are at pH 10.0-11.0 in LiCl solution.     

Surface composition and property of film prepared with aqueous dispersion of polyurethaneurea-acrylate including fluorinated block copolymer

The aqueous dispersion of polyurethaneurea-acrylate (PUA) including small amount of fluorinated block copolymers containing carboxyl groups (PATF), which can be dissolved in water, was used to make films and the surface properties of these films were examined. The experimental data show that the modified PUA film exhibits a hydrophobic surface property, although the original surface of PUA film is hydrophilic. The surface composition of the modified PUA film was measured by ATR and XPS. The results indicate that there is a concentration gradient of the fluorine groups along the lines of thickness of the modified film and towards the outmost surface layer, resulting from the migration of fluorinated blocks to the air side surface of the modified PUA film during the film formation process. However, the PUA film can not be modified effectively by adding the sodium salt of PATF, since the urethane groups in the system are easy to occupy on the surface of the film.     

A kinetic stability study of MN (MBe,Mg, Ca,Sr, and Ba)

This work describes a structure and kinetic stability study of some complexes with the general formula MN, where M are the alkaline earth metal atoms, Be, Mg, Ca, Sr, and Ba. A complex (A) with two points of attachment to the N₅ ring is the most energetically favored for all metals considered here. Except for Be, structure (B) containing a mono‐coordinated metal atom is a transition state corresponding to the metal atom transfer around the N₅ ring. Pyramidal structure (C) is kinetically unstable with the low isomerization barrier height, ranging from 0.9 to 6.7 kcal/mol. The dissociation barrier heights for the lowest energy isomers (A) are predicted to be 1.2–18.7 kcal/mol (Be to Ba), indicating that kinetic stability increases from lighter to heavier metal atoms. © 2004 Wiley Periodicals, Inc. Int J Quantum Chem, 2004     

Synthesis of 6（E）—Geranylgeraniol—19—oic Acid

Facile synthesis of 6(E)-geranylgeraniol-19-oic acid 1,a naturally occurring alicyclic diterpene acid, by a Horner-Wadsworth-Emmons olefination of two readily available fragments 2 and 3,is described.     

A New Biochemical Way for Conversion of CO2 to Methanol via Dehydrogenases Encapsulated in SiO2 Matrix

CO2 is converted to nethanol through an enzymatic approach using formate dehydrogenase(FateDH),formaldehyde dehydrogenase(FaldDH）and alcohol dehydrogenase(ADH)coencapsulated in silica gel prepared by modified sol-gel process as catalysts,TEOS as precursor,NADH as an electron donor.The highest yield of methanol was up to 92.1% under 37℃,pH7.0 and 0.3Mpa.     

Membrane permeation-controlled transdermal delivery system design. Influence of controlling membrane and adhesive on skin permeation of isosorbide dinitrate

A membrane permeation-controlled transdermal delivery system (MC-TDS) of isosorbide dinitrate (ISDN), a model drug, was prepared from polyvinyl alcohol aqueous gel containing the drug, a membrane consisting of ethylene-vinyl acetate copolymer membrane and acrylic adhesive (EV-a). The permeability of ISDN through the EV-a membrane was 2.5 times higher than that through excised hairless rat skin. The ratio of plasma concentration of ISDN after application of MC-TDS on stripped (damaged) skin relative to intact skin was lower than that after application of Frandol tape-S, a marketed ISDN TDS, which suggests that the EV-a membrane might work as a control membrane for overall delivery rate of ISDN to the body. When MC-TDS stored at 30 degrees C for 13.5-48h was applied to the damaged skin, however, the initial plasma concentration of ISDN was very much higher than the expected therapeutic level and was not controlled by the EV-a membrane. The initial high plasma concentration of ISDN after application of the stored MC-TDS on the damaged skin was due to migration of ISDN from the reservoir to the adhesive during storage at 30 degrees C. The migration of drugs into the adhesive might be an important problem in developing efficient MC-TDS.     

The Crystalline Changes of Starch from Rhizoma Dioscorea by Acid Hydrolysis

Dioscoreae (Chinese name Shanyao), the rhizome of various species of genus Dioscorea opposita Thunb.(Dioscoreaceae), has been used as an important invigorant in traditional Chinese medicine (TCM) for many years1. Starch, the most abundant carbohydrate in …