天然蚕丝与丝素蛋白多孔膜的生物降解性研究

较为详细地研究了经不同条件处理的丝素蛋白多孔膜材料和天然蚕丝在蛋白酶作用下的降解性能以及降解前后材料的微观形貌和结构的变化. 结果表明, 丝素蛋白材料中不同结构(构象)的含量是影响其降解速度的一个重要因素. 对于由再生丝素溶液所制备的材料, 调控其中Silk II结构(β-折叠构象)的比例可能是控制丝素蛋白材料降解速度的有效途径.     

微波辐照下无皂阳离子聚(St-MMA)高分子纳米粒子的制备和表征

讨论了微波辐照下 ,以丙酮 水为分散介质 ,利用阳离子型自由基引发剂偶氮二异丁基脒盐酸盐(AIBA)引发苯乙烯 (St)和甲基丙烯酸甲酯 (MMA)共聚 ,合成出表面带正电荷的P(St MMA)共聚物纳米粒子 ,考察了丙酮用量、单体和引发剂浓度对纳米粒子粒径、粒径分布和乳液稳定性的影响 .结果表明 ,丙酮 水的体积比由 0增加到 1 2 6∶1时 ,粒子的平均水化半径从 12 2 2 1nm降低到 2 4 6 8nm ,粒径分布变宽 ,乳液抗电解质稳定性逐渐增强 ;增加引发剂和共聚单体MMA的浓度 ,粒子的水化半径逐渐减小 ,粒径分散系数增大 .     

LaNi4.7Al0.3单颗粒微电极电化学行为的研究

报道了一种单颗粒微电极制备新方法, 并研究了LaNi4.7Al0.3球形单颗粒微电极的电化学行为.     

MAA存在下VAc/BA核壳乳液聚合过程中的胶粒形态研究

用ＴＥＭ和电位滴定法对不同配方和工艺条件得到的胶粒形态结构和羧基分别进行了表征。结果表明：加入甲基丙烯酸有利于胶粒的稳定和形成规则的核壳胶粒。半连续加料不会形成完全反转的核壳结构,但是,核层在反应过程中由于聚合物簇的迁移会造成形变。由于胶粒中聚合物浓度高,粘度大,因而胶粒形态变化受动力学影响甚大,羧基分布主要是由动力学确定的。     

磁性纳米固体酸SO42--TiO2-Fe3O4催化剂的合成、表征及催化性能的研究

首先研究制备了Fe3O4和SO42--TiO2固体酸催化剂,在此基础上采用共沉淀和浸渍的方法制备了磁性和超细SO42--TiO2-Fe3O4固体酸催化剂。利用XRD,TEM和FT-IR等分析测试手段对催化剂的结构和性能进行了表征。测定结果证实该催化剂具有较小的粒度,较高的磁性表现。在乙酸丁酯合成反应中SO42--TiO2-Fe3O4展示了很高的催化活性(酯化率可达82.7%),而且利用Fe3O4的磁性可对催化剂进行分离和回收.     

SiO2包覆纳米CaCO3的透射电镜表征

在透射电子显微镜（TEM）电子衍射模式下，用适当孔径的物镜光阑选择非晶态SiO2的衍射区域，拍摄以溶胶一凝胶法制备的SiO2包覆纳米CaCO3的暗场像。与未经包覆SiO2的纳米CaCO3的暗场像作对比，可以看出经过SiO2包覆的纳米CaCO3粒子周围有一白色亮环，从而得到SiO3包覆层的暗场照片。用高分辨方法观察了包覆层与CaCO3粒子间的界面情况。     

Photovoltaic Characteristics of a Naphthylamine Derivative

Organic photovoltaic （OPV） cells were fabricated via vacuum vapor deposition with {4-[2-（3-di-cyanomethylidene-5,5-dimethylcyclohexenyl）vinyl]phenyl}di（1-naphthyl）amine （DNP-2CN） as the electron donor, and fullerene （C60） as the electron acceptor. A thin film （10 nm） of tris（8-quinolinolato）aluminum （Alq3） was adopted as the buffer layer. A device based on this DNP-2CN exhibited an open circuit voltage （Voc） of 370 mV, a short-circuit current density （Jsc） of 0.61 mAocm 2, and a white-light power conversion efficiency （ η） of 0.09% （AM1.5, 75 mW.cm^- 2）.     

Synthesis and Characterization of Novel Polyimides Based on Pyridine-containing Diamine

A new aromatic diamine monomer containing pyridine unit, 2,6-bis （4-aminophenoxy- 4＇-benzoyl）pyridine（BABP）, was synthesized in three steps, starting from 2,6-pyridinedicarboxyl chloride. A series of novel pyridine-containing polyimides were prepared v/a the polycondensation of BABP with various aromatic dianhydrides through poly（amic acid） precursors, and thermal or chemical imidization of the precursors. The polyimides exhibit desirable properties, e.g., good solubility in N-methyl-2-pyrrolidone and m-cresol, excellent thermal stability and film-forming capability, as well as high inherent viscosity, indicating high molecular weight.     

二甲醚电氧化及其阳极催化剂研究

Anode electro-catalysts for direct dimethyl-ether fuel cell (DDFC), Pt/C, PtRu/C (1∶1) and PtSn/C (3∶2), were prepared by chemical impregnation-reduction method with formaldehyde as the reductant. DME electro-oxidation and adsorption at Pt electrode and Pt electro-catalysts were investigated by Cyclic Voltammetry(CV), Quasi-steady state polarization and Gas Chromatography(GC). CV showed that there were two current peaks of DME electro-oxidation at Pt electrode around 0.8V (vs RHE); DME was adsorbed at Pt electrode more weakly and slowly than oxygen, methanol, even hydrogen; the onset potential of DME oxidation was 50mV less than that of methanol, and DME peak potential 110 mV lower, thus more advantageous for using in fuel cells than methanol. GC showed that small amount of HCHO was generated during DME electro-oxidation. The mechanism of DME electro-oxidation was proposed. Among the three electro-catalysts (Pt/C, PtRu/C and PtSn/C), Pt alloy catalysts, especially PtRu/C, showed a higher performance toward DME electro-oxidation, as in the case of methanol. Temperature experiments showed that both DME electro-oxidation and adsorption on Pt and Pt alloy catalysts were favored with increased temperature.     

电感耦合等离子体原子发射光谱分析中光谱干扰校正卡尔曼滤波法研究

本文利用电感耦合等离子体原子发射光谱多色仪的扫描功能,用卡尔曼滤波法对各种光谱干扰进行校正。结果表明,该法能处理各种类型光谱干扰,不需要样品基体匹配,其测定回收率明显优于在峰法和离峰法,具有简便、准确等优点。