Magnetic characterization of FeCo nanowire arrays by first-order reversal curves

FeCo nanowire arrays have been obtained by current pulse electrodeposition into nanoporous alumina templates. First-order reversal curve (FORC) diagrams have been used to investigate magnetostatic interaction and average coercivity of individual FeCo nanowires embedded in porous alumina templates. The FeCo nanowires with a wires length up to 3 μm and wires diameter ranging from 25 to 50 nm showed interacting single-domain behavior. Using FORC diagrams, the spread of coercivity distribution was seen to be almost independent of the wires diameter, but with increase in diameter the inter-wire magnetostatic interaction was increased. It was found that for arrays with higher diameter, the coercivity of the arrays is lower than the average coercivity of the individual wires. It was detected that an increase in wire diameter results in a considerable increase in the spread of the distribution in the H_u direction of FORC distribution. Curve fitting on the experimental data proved a relatively linear relation between interaction field and square diameter of the nanowires.     

Influence of tungsten doping concentration on the electronic and optical properties of anatase TiO2

The structural, electronic and optical properties of tungsten-doped TiO₂ have been investigated using density functional theory with plane wave basis sets and ultrasoft pseuodopotential. Substitutional W doping at Ti sites create W 5d states just below the conduction band minimum while interstitial W doping gives isolated W 5d states in the middle of forbidden region. Averaged bond lengths show that W doping at Ti sites produce minimum structural distortion as compared to the interstitial W-doped TiO₂. Substitutional W-doped TiO₂ has better visible light absorption compared to interstitial W-doped TiO₂ and has stable configuration which provide reasonable explanation for the experimental findings. Tungsten doping in TiO₂ with different doping concentrations is investigated as an enabling concept for enhancing the visible light absorption. Optical properties show that optimal W doping concentration would improve the visible light absorption. 2.08% W doping concentration gives strong visible and ultraviolet light absorption among all doped models found consistent with experiments.     

A simple route for the synthesis of novel N-alkyl-2-(alkylthio)-1H-imidazole derivatives

Novel $N$ -alkyl-2-(alkylthio)-1 $H$ -imidazole derivatives were synthesized in a single step by an efficient and simple method in high yields. Readily available starting materials, mild reaction conditions, operational simplicity and novelty are the key advantages of this method. Besides their novel structures, these compounds may have important biological activities and industrial applications.     

Tachyon-polytropic inflation on the brane

We consider the tachyon-brane inflationary universe model in the context of a polytropic gas equation of state. In slow-roll approximation, we discuss general conditions of this model. For exponential potential, in high-energy limit the characteristics of the model are presented. By using the seven-year Wilkinson Microwave Anisotropy Probe (WMAP7) observational data, we constrain the cosmological parameters of the model.     

Atomistic investigation of phase transition in solid argon induced by shock wave transmission

A molecular dynamics (MD) simulation is employed to study the phase transition process in argon induced by shock wave transmission. Deriving the relation between the shock and piston velocities, the theoretical equation of state for argon is presented. Also, argon equation of state is obtained by measuring the quantities directly from simulations to be able to detect the phase transitions. The phase transition is also detected by using argon phase diagram and free energy calculations. A comparison shows good agreement between the theoretical and MD results for the phase transitions. Based on these simulations, it is concluded that under a shock wave transmission with suitable energy, the solid argon experiences a phase transition from solid to liquid and another from liquid to supercritical fluid. By reflecting the shock wave back at the end of its passage, the whole argon may reach the supercritical state.     

Laser Light and X-Ray Diffraction Studies of Oriented Isotactic Polypropylene (iPP) Prepared by Temperature Slope Crystallization

Isotactic polypropylene (iPP) film was melt-crystallized in a temperature gradient. The iPP film showed well oriented α- and β-crystalline textures along the gradient. The crystalline structure, phase transition boundary and lamellar twisting were examined by X-ray diffraction and laser light diffraction (LLD). On the α-β boundary, LLD shows a sharp streak perpendicular to the boundary, where the a-axis of the β-crystal is oriented perpendicular to the temperature gradient. Apart from the boundary, the a-axis of the β-crystal becomes parallel to the gradient. The β-crystal shows lamellar twisting with a pitch of 200 μm at room temperature. When heated the β-crystal, the lamellar distance of 295Å at room temperature decreases to 285Å at 80–100°C and then increases to more than 300Å above 120°C. During the heating, the value of the twist period increases from 200 to 210 μm at 90–100°C, and then to above 224 μm at 140°C. The increase of the twist period is related to the increasing crystalline thickness of the β-lamellae.     

An accurate mathematical study on the free vibration of stepped thickness circular/annular Mindlin functionally graded plates

An analytical solution based on a new exact closed form procedure is presented for free vibration analysis of stepped circular and annular FG plates via first order shear deformation plate theory of Mindlin. The material properties change continuously through the thickness of the plate, which can vary according to a power-law distribution of the volume fraction of the constituents, whereas Poisson’s ratio is set to be constant. Based on the domain decomposition technique, five highly coupled governing partial differential equations of motion for freely vibrating FG plates were exactly solved by introducing the new potential functions as well as using the method of separation of variables. Several comparison studies were presented by those reported in the literature and the FEM analysis, for various thickness values and combinations of stepped thickness variations of circular/annular FG plates to demonstrate highly stability and accuracy of present exact procedure. The effect of the geometrical and material plate parameters such as step thickness ratios, step locations and the power law index on the natural frequencies of FG plates is investigated.     

Hybrid simulated annealing and MIP-based heuristics for stochastic lot-sizing and scheduling problem in capacitated multi-stage production system

This paper addresses lot sizing and scheduling problem of a flow shop system with capacity constraints, sequence-dependent setups, uncertain processing times and uncertain multi-product and multi-period demand. The evolution of the uncertain parameters is modeled by means of probability distributions and chance-constrained programming (CCP) theory. A new mixed-integer programming (MIP) model with big bucket time approach is proposed to formulate the problem. Due to the complexity of problem, two MIP-based heuristics with rolling horizon framework named non-permutation heuristic (NPH) and permutation heuristic (PH) have been performed to solve this model. Also, a hybrid meta-heuristic based on a combination of simulated annealing, firefly algorithm and proposed heuristic for scheduling is developed to solve the problem. Additionally, Taguchi method is conducted to calibrate the parameters of the meta-heuristic and select the optimal levels of the algorithm’s performance influential factors. Computational results on a set of randomly generated instances show the efficiency of the hybrid meta-heuristic against exact solution algorithm and heuristics.     

Chaos and reproduction in sea level

Prediction of sea-level is an important task for navigation, coastal engineering and geodetic applications, as well as recreational activities. This study presents a comparison of Chaos theory and Auto-Regressive Integrated Moving Average (ARIMA) techniques for sea level modelling for daily, weekly, 10-day and monthly time scale at the Cocos (Keeling) islands from 1992 to 2001. The state space reconstruction of the unknown underlying process is directly employed from time series data, through Takens delay embedding method: optimal embedding dimension and delay time are obtained from false nearest neighbours and average mutual information techniques, respectively. Optimal values are then used for the estimation of the correlation dimension and the largest Lyapunov exponent, for inspecting possible signatures of chaotic dynamics. We find a positive Lyapunov exponent an evident feature of chaos. Indeed, the nonlinear prediction of sea level, in the period ranging from January 2001 to December 2001, is in an excellent agreement with the data for the same period, evidencing the nonlinear nature of the process. ARIMA method is also used for sea level modelling, for the same time scales; the performances of the two models are compared using such statistical indices as the root mean square error (RMSE) and correlation coefficient (CC). The comparative analyses show that the chaos theory model has a slight edge over ARIMA while both models are in principal acceptable.