From Nongelating to Gelating: Synthesis and Structural Self‐Assembling Property Relationships of a Homologous Series of Oligo(amide–triazole)s

A homologous series of oligo(amide–triazole)s (OAT) [ OAT‐CO₂H‐2 n and OAT‐COPrg‐(2 n +1) ] with an increasing number of primary amide (CONH) and triazole hydrogen‐bonding functionalities was prepared by an iterative synthetic procedure. It was found that their self‐assembly and thermoreversible gelation strength had a strong correlation to the number of hydrogen‐bonding moieties in the oligomers. There also existed a threshold value of the number of CONH units, above which all the oligomers became organogelators. Hence, oligomers with ≤4 CONH units are devoid of intermolecular hydrogen bonding and also non‐organogelating, whereas those that contain >4 CONH units show intermolecular association and organogelating properties. For the organogelators, the T_gel value increases monotonically with increasing number of CONH units. On the basis of FTIR measurements, both the CONH and triazole C? H groups were involved in the hydrogen‐bonding process. A mixed xerogel that consisted of a 1:1 weight ratio of two oligomers of different lengths ( OAT‐CO₂H‐6 and OAT‐CO₂H‐12 ) was found to show microphase segregation according to differential scanning calorimetry, thus indicating that oligomers that bear a different number of hydrogen‐bonding units exhibited self‐sorting to maximize the extent of intermolecular hydrogen bonding in the xerogel state.     

反相悬浮聚合法制备球状卡波树脂的研究

以偶氮二异丁脒盐酸盐(V50)作为引发剂,失水山梨醇硬脂酸酯(Span60)和聚二甲基硅氧烷PEG-7磷酸酯为复合分散剂,蔗糖烯丙基醚和三甲基丙基聚氧乙烯(15)醚三丙烯酸酯为复合交联剂,丙烯酸为单体,正已烷为反应介质,采用反相悬浮聚合方法制备了球状卡波树脂.用光学显微镜和扫描电镜分别对聚合反应的成粒过程和产物的形貌进行了研究.结果表明,聚合体系呈现典型的悬浮聚合相态特征,并获得了堆积密度较高(0.65 g/cm3)的球状卡波树脂.聚合反应动力学研究结果表明,该反相悬浮聚合的聚合速率对单体浓度和引发剂浓度的反应级数分别约为1.36和0.70;聚合反应的表观活化能为78.0 kJ/mol.交联剂对卡波树脂的性能有重要的影响,通过适度交联可提高产物的增稠效率及其抗剪切性能.     

Effect of Water Fraction on Rheological Properties of Waxy Crude Oil Emulsions

This article discusses the effect of water fraction on the rheological properties of waxy crude oil emulsions including gel point, yield stress, viscosity, and thixotropy. The experimental results reveal that the rheological behaviors of the w/o emulsion samples all intensify with the increase of water volume fraction within 60%. Of more significance is that a correlation for w/o emulsions between yield stress and water volume fraction is put forward with an average relative error of 6.75%. In addition, some mainstream viscosity prediction models of w/o emulsions are evaluated, and Elgibaly model is the best-fit for the emulsions in this study.     

K~+、Na~+、Ca~(2+)、Mg~(2+)对胜利褐煤平衡复吸水的影响

以胜利褐煤为研究对象,利用FT-IR等手段,用灰分、不同湿度下的平衡复吸水含量等,系统研究了不同相对湿度下K+、Na+、Ca2+、Mg2+的水合作用对胜利褐煤平衡复吸水含量的影响。结果表明,相同浓度不同类型的金属离子与煤样的交换能力的趋势为Ca2+Na+K+Mg2+。金属离子对胜利褐煤平衡复吸水含量影响力的顺序为Mg2+Ca2+Na+≈K+。相对湿度高时,平衡复吸水含量的主要控制因素为游离水分子之间的分子作用力;相对湿度中等时,平衡复吸水含量的主要控制因素为金属水簇与毛细管之间的毛细管作用力;相对湿度低时,平衡复吸水含量的主要控制因素为金属离子的水合作用。     

On the Size Evolution of Monolayer‐Protected Gold Clusters during Ligand Place‐Exchange Reactions: The Effect of Solvents

Ligand place‐exchange (LPE) reactions are extensively applied for the post‐functionalization of monolayer‐protected gold clusters (MPCs) by using excessive incoming ligands to displace initial ones. However, the modified MPCs are often enlarged or degraded; this results in ill‐defined size‐dependent properties. The growth of MPCs essentially involves an unprotected surface that is subsequently has gold atoms added or is fused with other gold cores owing to collision. Reported herein is a guideline for the selection of solvents to suppress unwanted MPC growth. Favorable solvents are those with significant affinity to gold or with low solubility for desorbed ligands because these properties retard LPE reactions and minimize the time available for unprotected gold cores. This finding provides a general and convenient approach to regulate the size of functionalized MPCs.     

Solvent extraction of U(VI) by trioctylphosphine oxide using a room-temperature ionic liquid

The unique physical and chemical properties of room-temperature ionic liquids(RTILs) have recently received increasing attention as solvent alternatives for possible application in the field of nuclear industry, particularly in liquid-liquid separations of radioactive nuclides. We investigated solvent extraction of U(VI) from aqueous solutions into a commonly used ionic liquid 1-butyl-3-methylimidazolium bis(trifluoromethylsulfonyl)imide([C4mim][NTf2]) using trioctylphosphine oxide(TOPO) as an extractant. The effects of contact time, TOPO concentration, acidity, and nitrate ions on the U(VI) extraction are discussed in detail. The extraction mechanism was proposed based on slope analysis and UV-Vis measurement. The results clearly show that TOPO/[C4mim][NTf2] provides a highly efficient extraction of U(VI) from aqueous solution under near-neutral conditions. When the TOPO concentration was 10 mmol/L, the extraction of 1 mmol/L U(VI) was almost complete( 97%). Both the extraction efficiency and distribution coefficient were much larger than in conventional organic solvents such as dichloromethane. Slope analysis confirmed that three TOPO molecules in [C4mim][NTf2] bound with one U(VI) ion and one nitrate ion was also involved in the complexation and formed the final extracted species of [UO2(NO3)(TOPO)3]+. Such a complex suggests that extraction occurs by a cation-exchange mode, which was subsequently evidenced by the fact that the concentration of C4mim+ in the aqueous phase increased linearly with the extraction percent of U(VI) recorded by UV-Vis measurement.     

Dual Sulfide–Disulfide Crosslinked Networks with Rapid and Room Temperature Self‐Healability

Polymer‐based crosslinked networks with intrinsic self‐repairing ability have emerged due to their built‐in ability to repair physical damages. Here, novel dual sulfide–disulfide crosslinked networks (s‐ssPxNs) are reported exhibiting rapid and room temperature self‐healability within seconds to minutes, with no extra healing agents and no change under any environmental conditions. The method to synthesize these self‐healable networks utilizes a combination of well‐known crosslinking chemistry: photoinduced thiol‐ene click‐type radical addition, generating lightly sulfide‐crosslinked polysulfide‐based networks with excess thiols, and their oxidation, creating dynamic disulfide crosslinkages to yield the dual s‐ssPxNs. The resulting s‐ssPxN networks show rapid self‐healing within 30 s to 30 min at room temperature, as well as self‐healing elasticity with reversible viscoelastic properties. These results, combined with tunable self‐healing kinetics, demonstrate the versatility of the method as a new means to synthesize smart multifunctional polymeric materials.

     

Surface hydrophobization of cotton via laccase-mediated polydopamine deposition and dodecyl gallate grafting

Natural fibers containing components with phenolic hydroxyl groups, such as jute, wool, and silk, can be directly modified by laccase-catalyzed grafting. However, cellulosic fibers like cotton cannot be functionalized in this manner. In this work, we developed a facile two-step method to graft polymers on cotton fabric via laccase catalysis. First, polydopamine (PDA) coating was deposited on the surface of the cotton fabrics via catalysis of laccase/2,2,6,6-tetramethylpiperidine-1-oxyl (TEMPO) system. Then, the newly formed PDA coating acted as the secondary reaction platform for subsequent laccase-mediated grafting of hydrophobic monomer dodecyl gallate (DG). The oxidation of dopamine (DA) catalyzed with the laccase/TEMPO system was investigated using UV–visible (UV–vis) spectroscopy. The scanning electron microscopy (SEM) and X-ray photoelectron spectroscopy (XPS) results verified that the PDA was coated on the surface of cotton fibers. Fourier transform infrared (FTIR) spectra indicated that the PDA-coated cotton was successfully grafted with DG (DG-PDA-cotton). According to the weighting method, the grafting percentage was about 1.06%. The hydrophobicity of the DG-PDA-cotton fabrics was greatly improved with a contact angle of 133°. Also, the grafted cotton fabrics show repellency of water-soluble stains like coffee, milk, and tea. This study provides a new strategy for surface modification of cotton by laccase-mediated grafting, which offers the references for the green fabrication of cotton fabrics with improved functionalization.     

铜基串联催化剂电催化CO2还原的研究进展

化石燃料的燃烧和其他人类活动排放了大量的CO₂气体,引发了诸多环境问题。电催化CO₂还原反应(CO₂RR)可以储存间歇可再生能源,实现人为闭合碳循环,被认为是获得高附加值化学品和燃料的有效途径。电催化CO₂RR涉及多个电子-质子转移步骤,其中^*CO通常被认为是关键中间体。铜由于对^*CO具有合适的吸附能,已被广泛证明是唯一能够有效地将CO₂还原为碳氢化合物和含氧化合物的金属催化剂。然而,纯Cu稳定性差、产品选择性低、过电位高,阻碍了工业级多碳产品的生产。构筑Cu基串联催化剂是提高CO₂RR性能的一种有前途的策略。本文首先介绍电催化CO₂RR的反应路线和串联机理。然后,系统地总结铜基串联催化剂对电催化CO₂RR的最新研究进展。最后,提出合理设计和可控合成新型电催化CO₂RR串联催化剂面临的挑战和机遇。     

Identification of metabolites of Ginkgolide B in vivo and in vitro using ultra-high-performance liquid chromatography-quadrupole time-of-flight mass spectrometry

Ginkgolide B is a dietary diterpene with multiple pharmacological activities. However, current research on ginkgolide B is not comprehensive. The current study analyzed the metabolic profile of ginkgolide B in vivo and in vitro using ultra-high-performance liquid chromatography quadrupole time-of-flight mass spectrometry. To detect and identify the different metabolites in ginkgolide B, a novel data processing method was used as an assistant tool. A total of 53 different metabolites of ginkgolide B (38 phase I metabolites and 15 phase II metabolites) were detected relative to blank samples. The biotransformation route of ginkgolide B was identified as oxidation, dehydroxylation, hydrogenation, decarbonylation, demethylation, sulfate conjugation, glucose conjugation, methylation, and acetylation. The current study demonstrated a method for rapidly detecting and identifying metabolites and provided useful information to further characterize the pharmacology and mechanism of ginkgolide B. A method for the analysis of other diterpene metabolic components in vivo and in vitro was also established.