天文斑点成像技术中的噪声影响分析

为进一步说明天文像复原新方法-迭代位移叠加法的性质，对探测器的附加噪声在斑点干涉术、斑点掩模法和迭代位移叠加法中的影响分别进行了分析。结果表明：在斑点掩模法中，复杂的噪声高阶矩统计被引入了重谱的噪声偏差，因此对噪声极为敏感，使数据处理更加复杂化；与斑点掩模法相比，迭代位移叠加法仅涉及对噪声的一阶矩统计平均，所以此新方法的特点是对噪声不敏感，具有图像复原处理过程简单快捷的优越性。     

V3+:YAG晶体的生长、色心与光谱性能研究

采用石墨电阻加热的温梯法生长了V:YAG晶体,晶体的不同部位呈现两种不同的颜色:浅绿色和黄褐色.通过对比分析不同颜色V:YAG晶体的室温吸收光谱,推断出石墨发热体高温下扩散出来的C可以起到还原作用,提高晶体中V3+tetra离子的浓度,同时诱导了F心的形成.在1300℃下,对不同颜色的V:YAG晶体进行真空退火处理,发现处于八面体格位中的V3+离子在热激发作用下与近邻的四面体格位Al3+离子存在置换反应,由此产生一定浓度的四面体格位V3+离子.同时,F心在退火过程中被完全消除,释放出来的自由电子被高价态的V离子俘获,可以进一步提高晶体中四面体格位V3+离子的浓度.     

Newton-Leibniz integration for ket-bra operators in quantum mechanics and derivation of entangled state representations

Newton-Leibniz integration rule only applies to commuting functions of continuum variables, while operators made of Dirac’s symbols (ket versus bra, e.g., |q〉〈q| of continuous parameter q) in quantum mechanics are usually not commutative. Therefore, integrations over the operators of type |〉〈| cannot be directly performed by Newton-Leibniz rule. We invented an innovative technique of integration within an ordered product (IWOP) of operators that made the integration of non-commutative operators possible. The IWOP technique thus bridges this mathematical gap between classical mechanics and quantum mechanics, and further reveals the beauty and elegance of Dirac’s symbolic method and transformation theory. Various applications of the IWOP technique, including constructing the entangled state representations and their applications, are presented.     

基于分步式压印光刻的激光干涉仪纳米级测量及误差研究

针对在未做隔离保护处理的环境中，基于Michelson干涉原理的激光干涉仪测量系统存在严重的干扰误差，不适合分步式压印光刻纳米级对准测量的要求.采用Edlen公式的分析及计算，不仅在理论上揭示出环境温度、湿度、气压等变化对激光干涉仪测量准确度的影响，而且证明影响测量准确度的最大干扰源是空气流动的结果.通过气流隔离措施和系统测量反馈校正控制器，能够实时补偿激光干涉仪两路信号的相差.最终，测量漂移误差在10 min内由13 nm降低到5 nm以内，满足压印光刻在100 mm行程中达到20 nm定位准确度要求.     

粒子-转子模型和推转壳模型中的能谱统计分析

用粒子–转子模型和推转壳模型研究了6个粒子分别填充在单j壳和双j壳上的混沌行为.分析了单j壳和双j壳情况下能谱的最近邻能级间距分布和谱刚度随自旋及推转频率的变化,结果表明,当组态空间大小不变时,系统在双j壳(g_7/2+d_5/2)情况下比在单j壳(i_13/2)情况下更规则,而当组态空间从单j壳(i_13/2)扩大到双j壳(i_13/2+g_9/2)时,系统的混沌程度变化不大.同时比较了将6个粒子的两体相互作用分别取为δ力和对力时的系统的混沌行为     

Soliton interaction under the influence of higher-order effects

In this paper, we present exact N-soliton solution by employing simple, straightforward Darboux transformation based on the Lax pair for Hirota equation, a higher-order nonlinear Schrödinger (HNLS) equation. As examples, one- and two-soliton solutions in explicit forms are given and their properties are also analyzed. A bound solution without interaction will be theoretically predicted if one can adjust frequency shift for each soliton appropriately. Further, we obtain the approximate eigenvalues by employing two-soliton solution and discuss analytically the interaction between neighboring solitons under the influence of the higher-order effects. It is shown that the combined effects of the higher-order effects can restrain the interaction between neighboring solitons to some extent. The results are proved by directly solving HNLS equation numerically.     

A High Power Conversion Efficiency L-Band Erbium Doped Fiber Amplifier

By using two sections of erbium doped fiber and a fiber optical reflector, a novel, highly efficient L bandamplifier is demonstrated with significantly power-conversion-efficiency enhancement and the gain increasing of as much as 13 dB.     

Reciprocating sliding wear behavior of laser-clad small amplitude Mo2Ni3Si/NiSi metal silicide composite coatings

Mo₂Ni₃Si/NiSi metal silicide composite coatings with a fine microstructure consisting of Mo₂Ni₃Si primary dendrites and the interdendritic Mo₂Ni₃Si/NiSi eutectics were fabricated on austenitic stainless steel AISI 321 by laser cladding process. Small amplitude reciprocating sliding wear resistance of the coatings is evaluated as functions of normal load and slip amplitude and the wear mechanisms were discussed based on worn surface morphology observations. Results showed that the Mo₂Ni₃Si/NiSi coatings have excellent small amplitude reciprocating sliding wear resistance.     

Hybrid Electrodes Used in Polymer Electro-Optic Modulator with Ultra-Broadband

Hybrid electrode combined coplanar waveguide (CPW) and microstrip lines in ultra-broadband electro-optic modulators. The characteristics of the modulators with hybrid electrode is like that of the modulator with the microstrip lines, in which the microstrip electrode is loaded above only one arm of Mach-Zehnder (M-Z) optical waveguide, besides the problem of microstrip line to coaxial transition and corona polarization in polymer modulators have been best solved at the same time. By using finite element method (FEM), the characteristic parameters such as half-wave voltage, modulation bandwidth characteristic impedance, effective microwave refractive index of polymer modulators with microstrip line and hybrid electrode are analysed and compared in this paper. The results present that velocity match, impendence match and lower microwave propagating loss is easily realized in modulators with hybrid electrode.