Effects of Coverage,Water, and Defects on Catechol/TiO2 Interface

Catechol adsorbed on TiO₂ is one of the simplest models to explore the relevant properties of dye-sensitized solar cells. However, the effects of water and defects on the electronic levels and the excitonic properties of the catechol/TiO₂ interface have been rarely explored. Here, we investigate four catechol/TiO₂ interfaces aiming to study the influence of coverage, water, and defects on the electronic levels and the excitonic properties of the catechol/TiO₂ interface through the first-principles many-body Green's function theory. We find that the adsorption of catechol on the rutile (110) surface increases the energies of both the TiO₂ valence band maximum and conduction band minimum by approximately 0.7 eV. The increasing coverage and the presence of water can reduce the optical absorption of charge-transfer excitons with maximum oscillator strength. Regarding the reduced hydroxylated TiO₂ substrate, the conduction band minimum decreases greatly, resulting in a sub-bandgap of 2.51 eV. The exciton distributions in the four investigated interfaces can spread across several unit cells, especially for the hydroxylated TiO₂ substrate. Although the hydroxylated TiO₂ substrate leads to a lower open-circuit voltage, it may increase the separation between photogenerated electrons and holes and may therefore be beneficial for improving the photovoltaic efficiency by controlling its concentration. Our results may provide guidance for the design of highly efficient solar cells in future.     

MIL-101(Cr) Microporous Nanocrystals Intercalating Graphene Oxide Membrane for Efficient Hydrogen Purification

Graphene oxide (GO) is a promising two-dimensional building block for fabricating high-performance gas separation membranes. Whereas the tortuous transport pathway may increase the transport distance and lead to a low gas permeation rate, introducing spacers into GO laminates is an effective strategy to enlarge the interlayer channel for enhanced gas permeance. Herein, we propose to intercalate CO₂-philic MIL-101(Cr) metal-organic framework nanocrystals into the GO laminates to construct a 2D/3D hybrid structure for gas separation. The interlayer channels were partially opened up to accelerate gas permeation. Meanwhile, the intrinsic pores of MIL-101 provided additional transport pathways, and the affinity of MIL-101 to CO₂ molecules resulted in higher H₂/CO₂ diffusion selectivity, leading to a simultaneous enhancement in gas permeance and separation selectivity. The MIL-101(Cr)/GO membrane with optimal structures exhibited outstanding and stable mixed-gas separation performance with H₂ permeance of 67.5 GPU and H₂/CO₂ selectivity of 30.3 during the 120-h continuous test, demonstrating its potential in H₂ purification application.     

Selective Construction of Trefoil knots and a Molecular Borromean Ring Induced by Steric Hindrance of Thioether Ligands

Two Cp*−Rh^III based trefoil knots were obtained in high yield under ambient conditions via the coordination-driven self-assembly of semi-rigid thioether dipyridyl ligand 1,4-bis[(pyridin-4-ylthio)methyl]benzene ( L₁ ), ligand chloranilic acid (H₂− CA ) and 6,11-dihydroxytetracene-5,12-dione (H₂- TtDo ) with Cp*Rh^III metal corner units, respectively. Furthermore, using the bulkier 4,4′-{[(2,5-dimethyl-1,4-phenylene)bis(methylene)]bis(sulfanediyl)}dipyridine ( L₂ ) in the place of ligand L₁ in the construction process resulted in the formation of a teranuclear metallacycle and a template-free Borromean ring in high yields thanks to significantly altered intermolecular forces between the constituent ligands induced by the sterically-hindering methyl groups of L₂ , as demonstrated via a detailed X-ray crystallographic analysis and NMR spectroscopy.     

Aprotic Amine-modified Manganese Dioxide Catalysts for Selectivity-tunable Oxidation of Amines

Organic modifiers have shown promising potential for regulating the activity and selectivity of heterogeneous catalysts via tuning their surface properties. Despite the increasing application of organic modification technique in regulating the redox-acid catalysis of metal oxides, control of the acidity of metal oxide catalysts for enhanced reaction selectivity without sacrificing their redox activity remains a substantial challenge. Herein, we show the successful control of redox-acid catalysis of metal oxides with aprotic tertiary amine modifiers. Robust modification of manganese dioxide catalysts with N,N-dialkylcyclohexylamine selectively blocks the Lewis acid sites, with their redox activity mostly unaffected. This enables efficient synthesis of imines in high to excellent selectivity via aerobic oxidation of structurally diverse aryl amines.     

Dynamic Visualization of Free Radicals at Single Oxygen Bubbles using Chemiluminescence

The generation of free radicals is a key process in the formation and the collapse of the bubbles in water, however, the direct and dynamic observation of the radicals in this process at single bubbles has never been achieved. Here, the hydroxyl (OH^.) and oxygen (O₂^.−) radicals at single oxygen bubbles are continuously traced using chemiluminescence (CL), in which these radicals at the bubble react with the surrounding luminol in the solution emitting the light. Varied increase trends of luminescence are observed in the generation of a bubble, floating, short parking at the water/air interface and the final explosion, revealing the complexity in the distribution of radicals at the bubble unprecedentedly. Despite more radicals are observed at the bubble generated at a deep position under the water for the stabilization, almost the same amount of radicals are included in the bubbles that is independent on the water pressure during the production of the bubble. This rich information collected from the dynamic study of bubbles illustrates the complicated generation and distribution process of radicals at the bubbles, and will facilitate the understanding of the function about the bubbles.     

The Effect of Oleic Acid Emulsification using SPE on Fluorite and Dolomite Flotation**

Collector OA, oleic acid, is widely used industrially for fluorite flotation. Low selectivity, dispersibility and collecting capability of the OA collector are always observed. In this study, compared with flotation of dolomite, a collector mixture of OA and SPE (styrylphenol polyoxyethylene ether) demonstrated significantly better performances for the fluorite. An optimal mass ratio 4 : 1 OA : SPE was found, and the recovery of fluorite was increased from over 85 % to more than 94 % compared with pure OA. Furthermore, the dosage of the collector agent was reduced from 50 mg mL⁻¹ to 20 mg mL⁻¹, which did not negatively impact the recovery of dolomite. The results from the contact angle tests indicated that SPE selectively increased the surface hydrophobicity of fluorite but had little effect on dolomite. Besides, zeta potential measurements and IR analyses revealed that the addition of SPE led to strong chemical adsorption on the surface of fluorite, resulting in a significant difference in the flotation performances of the two minerals. Therefore, SPE-emulsified OA is corroborated to prompt more selectivity and collecting capability on flotation of fluorite over dolomite.     

SiOx encapsulated FeSi2–Si eutectic nanoparticles as durable anode of lithium-ion batteries

Low-cost and high-efficiency production of silicon-based material is the key to improve the energy density of lithium-ion batteries. Herein, we propose a novel structure of FeSi₂–Si eutectic nanoparticles protected by the SiO_x shell. FeSi₂, as a buffer phase can improve the electrochemical stability of the electrode. A SiO_x shell is formed on the surface of the nanoparticles through the passivation process. SiO_x encapsulated FeSi₂–Si eutectic nanoparticles exhibit excellent capacity of 674.9 mAh/g after 500 charge/discharge cycles. The capacity retention rate is above 90% after the stabilization process. This work provides a new nanomaterial design for high performance silicon-based anode materials of lithium-ion batteries.     

Enhanced Oral Absorption of Icaritin by Using Mixed Polymeric Micelles Prepared with a Creative Acid-Base Shift Method

The purpose of this study was to develop mixed polymeric micelles with high drug loading capacity to improve the oral bioavailability of icaritin with Soluplus^® and Poloxamer 407 using a creative acid-base shift (ABS) method, which exhibits the advantages of exclusion of organic solvents, high drug loading and ease of scaling-up. The feasibility of the ABS method was successfully demonstrated by studies of icaritin-loaded polymeric micelles (IPMs). The prepared IPMs were characterized to have a spherical shape with a size of 72.74 ± 0.51 nm, and 13.18% drug loading content. In vitro release tests confirmed the faster release of icaritin from IPMs compared to an oil suspension. Furthermore, bioavailability of icaritin in IPMs in beagle dogs displayed a 14.9-fold increase when compared with the oil suspension. Transcellular transport studies of IPMs across Caco-2 cell monolayers confirmed that the IPMs were endocytosed in their intact forms through macropinocytosis, clathrin-, and caveolae-mediated pathways. In conclusion, the results suggested that the mixed micelles of Soluplus^® and Poloxamer 407 could be a feasible drug delivery system to enhance oral bioavailability of icaritin, and the ABS method might be a promising technology for the preparation of polymeric micelles to encapsulate poorly water-soluble weakly acidic and alkaline drugs.     

Flexible all-solid-state supercapacitor based on polyhedron C-ZIF-8/PANI composite synthesized by unipolar pulse electrodeposition method

Journal of Solid State Electrochemistry - In this work, the unipolar pulse electrodeposition (UPED) method is used to electrodeposit the conductive polyaniline (PANI) on the carbonized polyhedron...     

From borophosphate to fluoroborophosphate: a rational design of fluorine-induced birefringence enhancement

The introduction of oxofluoride anion into anionic group assists to tune optical properties owing to the change of coordination,electronegativity,and according anionic framework.Here,we proposed a rational design of new compounds by fluorine-driven structure and optical property evolution.A new borophosphate Ba_2BP_3O_(11)with the monoclinic space group P2_1/c has been synthesized in the sealed system.Ba_2BP_3O_(11)exhibits a rare P–O–P bridge formation,which is the first example in alkaline-earth metal borophosphates.By further substituting[BO_4]~(3-)with[BO_3F]~(4-),the first alkaline-earth metal/lead fluoroborophosphates M_2BP_2O_8F (M=Ba and Pb) with the same space group were designed.Since the scissors effect of fluorine,in M_2BP_2O_8F (M=Ba and Pb),a BO_3F tetrahedron corner-sharing with three PO_4tetrahedra forms 1D chains along the b-axial direction,which are filled by MO_n(M=Ba/Pb,n=5,6,8) distorted polyhedra.The first principles calculation shows that the borophosphate Ba_2BP_3O_(11)has a birefringence about 0.013@1,064 nm,while the fluoroborophosphates M_2BP_2O_8F (M=Ba and Pb) have the values of 0.035 and 0.043@1,064 nm,respectively.Such an apparent enhancement in birefringence is derived from synergies of the oxyfluoride and cation.The introduction of fluorine-containing heteroanionic groups provides a feasible strategy to design novel promising optical materials.