Dimeric Manganese-Catalyzed Hydroarylation and Hydroalkenylation of Unsaturated Amides

An unprecedented Mn(I)-catalyzed selective hydroarylation and hydroalkenylation of unsaturated amides with commercially available organic boronic acids is reported. Alkenyl boronic acids have been successfully employed for the first time in Mn(I)-catalyzed carbon–carbon bond formation. A wide array of β-alkenylated amide products can be obtained in moderate to good yields, which offers practical access to five- and six-membered lactams. This protocol has predictable regio- and chemoselectivity, excellent functional group compatibility and ease of operation in air, representing a significant step-forward towards manganese-catalyzed C−C coupling.     

Efficient Quantum Dot Light-Emitting Diodes Based on Well-Type Thick-Shell CdxZn1−xS/CdSe/CdyZn1−yS Quantum Dots

Device grade quantum dots (QDs) require QDs ensembles to retain their original superior optical properties as in solution. QDs with thick shells are proven effective in suppressing the inter-dot interaction and preserving the emission properties for QDs solids. However, lattice strain–induced defects may form as the shell grows thicker, resulting in a notable photoluminescence quenching. Herein, a well-type Cd_xZn_1−xS/CdSe/Cd_yZn_1−yS QDs is proposed, where ternary alloys CdZnS are adopted to match the lattice parameter of intermediate CdSe by separately adjusting the x and y parameters. The resultant thick-shell Cd_0.5Zn_0.5S/CdSe/Cd_0.73Zn_0.27S QDs reveal nonblinking properties with a high PL QY of 99% in solution and 87% in film. The optimized quantum dot light-emitting diodes (QLEDs) exhibit a luminance of 31547.5 cd m⁻² at the external quantum efficiency maximum of 21.2% under a bias of 4.0 V. The shell thickness shows great impact on the degradation of the devices. The T₅₀ lifetime of the QLEDs with 11.2 nm QDs reaches 251 493 h, which is much higher than that of 6.5 and 8.4 nm QDs counterparts. The performances of the well-type thick-shell QLEDs are comparable to state-of-the-art devices, suggesting that this type of QDs is a promising candidate for efficient optoelectronic devices.     

Direct Intermediate Regulation Enabled by Sulfur Containers in Working Lithium–Sulfur Batteries

Polysulfide intermediates (PSs), the liquid-phase species of active materials in lithium–sulfur (Li-S) batteries, connect the electrochemical reactions between insulative solid sulfur and lithium sulfide and are key to full exertion of the high-energy-density Li-S system. Herein, the concept of sulfur container additives is proposed for the direct modification on the PSs species. By reversible storage and release of the sulfur species, the container molecule converts small PSs into large organosulfur species. The prototype di(tri)sulfide-polyethylene glycol sulfur container is highly efficient in the reversible PS transformation to multiply affect electrochemical behaviors of sulfur cathodes in terms of liquid-species clustering, reaction kinetics, and solid deposition. The stability and capacity of Li-S cells was thereby enhanced. The sulfur container is a strategy to directly modify PSs, enlightening the precise regulation on Li-S batteries and multi-phase electrochemical systems.     

双掺(Tm3+,Tb3+)LiYF4激光器1.5 μm波长激光阈值分析

由速率方程推出了双掺（Tm^3 ,Tb^3 ）离子准四能级系统的激光阈值解析式，讨论了Tm^3 和Tb^3 离子之间的相互作用。分析了1.5μm波长附近的激光阈值和Tm^3 、Tb^3 离子的掺杂原子数分数及晶体长度的关系。结果表明，对于对应Tm^3 离子^3H4→^3F4跃迁的约1.5μm波长的激光，激活离子Tm^3 的掺杂原子数分数过大时，交叉弛豫作用将使系统阈值迅速增加。Tb^3 离子的加入，一方面能抽空激光下能级，起到降低阈值的作用；另一方面亦减少了激光上能级的寿命，使阈值升高。故Tb^3 离子有最佳掺杂原子数分数。对于Tm原子数分数为y=0.01的Tm:LiYF4晶体，Tb^3 离子的最佳掺杂原子数分数为0.002左右，同时表明，激光阈值与晶体长度有关。最佳晶体长度与Tm^3 、Tb^3 离子的掺杂原子数分数以及晶体的衍射损耗和吸收损耗有关。     

电路过渡过程的计算机辅助分析

电路过渡过程所列方程是微分方程，本文中采用的是方框图模型分析法，即将微分方程的复杂示解分解成最基本的加（减）、乘（除）、积分（微分）、增益等运算，采用VB设计用户界面产进行计算，并给出了一算例。     

P schl-Teller势阱中线性与非线性光学折射率变化

利用量子力学中的密度矩阵算符理论导出了P schl-Teller势阱中的线性与三阶非线性光学折射率的解析表达式。P schl-Teller势阱中有两个可调参数κ和λ,势阱的形状及其非对称性会随势阱参数的取值不同而明显不同,从而其线性与非线性光学折射率变化的大小也会随势阱参数和入射光强的变化而呈规律性的变化。文章以典型的GaAs/AlGaAs势阱为例作了数值计算,数值计算结果表明,势阱的形状和入射光强对光学折射率有着重要的影响。     

研究性物理实验与大学生创新心理品质培养

文章提出了大学研究性物理实验与创新心理品质培养的主题,介绍了大学研究性物理实验的特点,论述了大学研究性物理实验对大学生创新心理品质的影响。     

A New Type of Terahertz Waveguides

A new type of THz waveguides, which employs a solid polyethylene rod as the core and polyethylene tubes in a periodic array of square lattice as the cladding, is proposed. Optical properties of this new THz waveguide, especially in dispersion, confinement loss and single mode property, are investigated in detail with the plane wave expansion method and the beam propagation method. Numerical results demonstrate that the new THz waveguide can reach not only low dispersion but also low confinement loss at single mode propagation. Therefore, the square lattice structure is a better candidate as THz waveguides than the triangular ones.     

Sparse polynomials, redundant bases, gauss periods, and efficient exponentiation of primitive elements for small characteristic finite fields

Gauss periods give an exponentiation algorithm that is fast for many finite fields but slow for many other fields. The current paper presents a different method for construction of elements that yield a fast exponentiation algorithm for finite fields where the Gauss period method is slow or does not work. The basic idea is to use elements of low multiplicative order and search for primitive elements that are binomial or trinomial of these elements. Computational experiments indicate that such primitive elements exist, and it is shown that they can be exponentiated fast.     

基于模糊集相容性的模糊控制规则优化方法

在简要介绍模糊模型的完备性和相容性的基础上 ,根据模糊集贴近度 ,提出模糊集相容性的概念 ;通过对模糊控制规则表特征的分析 ,进一步完善规则相容性概念及其定量评价方法 ;最后给出模糊控制规则模型自寻优优化方法。仿真结果表明 ,该方法可以大大提高控制系统的控制性能。