新型双钼酸盐红色荧光粉的制备及发光性能研究

采用高温固相法合成了一种新型的白光LED用双钼酸盐红色荧光粉,利用XRD,F-4500等对其进行了研究。结果表明:该系列荧光粉可以被近紫外光(396 nm)和蓝光(466 nm)有效激发,发射峰值位于615 nm(Eu3+离子的5D0→7F2跃迁)的红光;而且在钾铕双钼酸盐荧光粉KEu(MoO4)2中引入适量的钨酸能加强其发光强度,而不改变样品的发射光谱的形状和发射峰的位置。此外,在确定WO24-/MoO42最佳比值的前提下,文章还详细探讨了碱金属离子相互置换对样品发光性能影响的机制。     

螯合吸附材料ASA-PGMA/SiO2对稀土离子的吸附性能研究

采用静态吸附法研究了ASA-PGMA/SiO2对稀土离子的螯合吸附性能、吸附动力学和热力学。实验结果表明,其对稀土离子的吸附能力分别为:La3+:38.6 mg.g-1,Pr3+:39.6 mg.g-1,Nd3+:41.8 mg.g-1,Sm3+:42.8 mg.g-1,Tb3+:46.2 mg.g-1。吸附等温模型符合Lang-muir型单分子层吸附。介质pH值对材料的吸附能力有很大影响,pH值为6时吸附量最大。以盐酸为洗脱剂,当酸度为0.1 mol.L-1时,洗脱率为99.8%。连续吸附-脱附实验表明,ASA-PGMA/SiO2重复使用10次后,吸附能力变化很小。     

固体氧化物燃料电池La0.7Sr0.3Cr1-xMnxO3-δ阳极性能研究

采用溶胶凝胶法制备了La0.7Sr0.3Cr1-xMnxO3-δ(x=0.3,0.4,0.5,0.6)系列阳极粉体。在1000℃下焙烧后,XRD结果显示粉体物相为单一的钙钛矿相。制备以La0.7Sr0.3Cr1-xMnxO3-δ为阳极,Ce0.8Sm0.2O1.9(SDC)为电解质,Pr0.6Sr0.4Co0.8Fe0.2O3-δ-SDC复合阴极的电解质支撑型固体氧化物燃料单电池。由扫描电子显微镜(SEM)观察表明单电池电解质致密,阳极孔径分布均匀,厚度约为20μm,多孔阴极厚度为10μm。采用直流四电极法测试以La0.7Sr0.3Cr0.5Mn0.5O3-δ为阳极用湿氢气作燃料时在800℃下获得最大输出功率为232.84 mW.cm-2,短路电流为0.92 A.cm-2。     

Quantitative and multicomponent analysis of prevalent urinary calculi using Raman spectroscopy

This study established a quantitative micro‐Raman spectroscopic (MRS) method for measuring multicomponents (binary and ternary compositions) of prevalent urine calculi extracted from the ureter after the ureteroscopic lithotripsy (URSL) procedure. The analysis used calibration curves of known mixtures of synthetically prepared calcium oxalate monohydrate (COM), hydroxyapatite (HAP), calcium oxalate dehydrate (COD), dicalcium phosphate dehydrate (DCPD), and uric acid. A variety of samples of binary and ternary mixtures including COM/HAP, COM/COD, COD/HAP, COM/uric acid, COD/uric acid, HAP/uric acid, HAP/DCPD, and COM/COD/HAP were prepared in various concentration ratios for use as the basis of the quantitative analysis. Intensities of the characteristic bands at 961 cm⁻¹ (I_HAP), 986 cm⁻¹ (I_DCPD), 1402 cm⁻¹ (I_UricAcid), 1462 cm⁻¹ (I_COM), and 1477 cm⁻¹ (I_COD) were used for the calculation. We derived a set of quantitative analysis equations for the ternary composition COD/COM/HAP group by combining two binary equations from the groups COM/COD and the HAP/COM. This study quantitatively measured 18 urine samples extracted from the 18 patients' ureters after the URSL procedure. Fifteen samples were binary mixtures, whereas three samples were ternary mixtures. This research successfully applied the quantitative MRS‐based analysis technique from bench to bedside. Copyright © 2012 John Wiley & Sons, Ltd.     

Quantized four-terminal resistances in a ferromagnetic graphene p-n junction

The quantum Hall and longitudinal resistances in four-terminal ferromagnetic graphene p-n junctions under a perpendicular magnetic field are investigated. In the Hall measurement, the transverse contacts are assumed to be located at the p-n interface to avoid the mixing of edge states at the interface and the resulting quantized resistances are then topologically protected. According to the charge carrier type, the resistances in a four-terminal p-n junction can be naturally divided into nine different regimes. The symmetric Hall and longitudinal resistances are observed, with many new robust quantum plateaus revealed due to the competition between spin splitting and local potentials.     

聚乙烯胺类修饰萘酰亚胺衍生物的合成、DNA键合行为和活性研究

合成了二乙烯三胺、三乙烯四胺和四乙烯五胺等低分子量聚乙烯胺类修饰的萘酰亚胺衍生物.通过UV-Vis谱、荧光光谱、圆二色谱和热变性试验研究了合成化合物与小牛胸腺DNA的键合行为,同时通过四甲基偶氮唑蓝(MTT)染色法研究了化合物对Bel-7402(人肝癌细胞)、HL-60(白血病细胞)、A549(人肺癌细胞)和Hela(人宫颈癌细胞)等细胞株的体外抗肿瘤活性,化合物NI1对A549细胞显示良好的抑制活性,优于阳性对照顺铂.     

Fabrication of microgel-in-liposome particles with improved water retention

Corneocytes represents the main water reservoir of stratum corneum, and that ability intimately arises from their architecture and total composition. Here we describe a novel method for fabricating a microgel-in-liposome (M-i-L) structure consisting of a sodium hyaluronate microgel and a lipid membrane envelop in order to mimic corneocyte cell structures. The essence of our approach is to use a lecithin-based microemulsion with a very low interfacial tension between the water droplet and oil continuous phase. Using this emulsion enables us to stabilize a dispersion of microgel particles without phase separation or aggregation. The addition of excess water produced single-core or multicore microgel particles enveloped in a lipid layer. To demonstrate the applicability of this unique vesicle system, we encapsulated a high concentration of natural moisturizing factor (NMF) in the microgel core and investigated how the M-i-L structure affected the water retention in comparison with other control systems. We have observed that our M-i-L particles with the NMF in the core, which mimicked the corneocyte cell structure, showed an excellent ability to retain water in the system. This experimental result inspired us to investigate how corneocyte cells, which feature a lipid-enveloped hydrogel structure, provide such long-lasting hydration to the skin.     

Emulsion polymerization of styrene using irreversible addition–fragmentation chain transfer agents: effect on the course of the polymerization and molecular weight

The emulsion polymerization of styrene with three different chain transfer agents (CTAs) based on irreversible addition–fragmentation chain transfer (AFCT) mechanism was first reported in this work. The influences of these irreversible AFCT agents on the rate of polymerization, particle size, and molecular weight were investigated. It was found that the intrinsic activity and desorption behaviors of the CTAs determined the efficiency for molecular weight control, rate of polymerization, and particle size in the emulsion polymerization. It has been demonstrated that the rate of polymerization and particle size decreased dramatically in the presence of the irreversible AFCT agents with high chain transfer constant (ethyl α-p-toluenesulfonyl-methacrylate), meanwhile, the molecular weight of the polystyrene could not be controlled well, whereas the irreversible AFCT agents with low chain transfer constant (butyl(2-phenylallyl)sulfane and 2,3-dichloropropene) had a slight effect on the polymerization rate, particle size, and were fairly well for molecular weight control over the whole conversion range in the emulsion polymerization of styrene. The average number of radicals per particle and the number-average molecular weight were calculated by classical radical emulsion polymerization theory, and the experimental results were in good agreement with the results of model calculations, when the irreversible AFCT agents were used as CTAs. The effect of chain transfer agents on the kinetics and nucleation in the emulsion polymerization of styrene can be attributed to desorption of chain-transferred radicals from the polymer particles. The results of this work show that butyl(2-phenylallyl)sulfane as CTA in emulsion polymerization of styrene provides the best balance between the rate of polymerization and the efficiency for molecular weight control conflicting tendencies.     

用光刺激放电法研究纳米粉末掺杂低密度聚乙烯中陷阱能级

通过光刺激放电(PSD)技术研究了纳米粉末掺杂低密度聚乙烯(LDPE)中的陷阱能级.利用连续扫描法得到了不同掺杂比例的Al₂O₃,MgO纳米粉末掺杂试样以及相同掺杂比例的多种纳米粉末掺杂试样的PSD电流谱,定性地得出了试样陷阱能级的深浅变化.分步扫描法定量地描述了LDPE试样在Al₂O₃纳米掺杂前后陷阱能量分布的变化.结果表明,掺杂比例大于0.2%的Al₂O₃纳米粉末掺杂、大于0.5%的MgO纳米粉末掺杂能够显著地使得LDPE陷阱能级变深.结合纳米掺杂对LDPE空间电荷注入影响的相关报道,可推测纳米掺杂对空间电荷注入的抑制与试样中陷阱能级变深存在密切的关联.