Recognition of anions and monocarboxylic acids by a fluorescent guanidine-based receptor

A guanidine-based fluorescent receptor has been synthesised to study its binding behaviour towards anions (F^? , Cl^? , Br^? , I^?  and AcO^? ). The two donor N–H bonds of the receptor do not point in the same direction; rather, one N–H bond is intramolecularly hydrogen-bonded with the carbonyl oxygen atom. The nature of the donor–acceptor (DA) arrangement induces moderate binding properties. The binding behaviour towards monocarboxylic acids (benzoic acid and phenylacetic acid) is also compared. The binding behaviour of receptor 1 towards the F^?  anion is higher among the anions studied, whereas in the case of monocarboxylic acid, the binding constant with phenylacetic acid is higher than benzoic acid.     

Stereospecific Formal [3+2] Dipolar Cycloaddition of Cyclopropanes with Nitrosoarenes: An Approach to Isoxazolidines

The MgBr₂‐catalyzed formal [3+2] cycloaddition of donor–acceptor activated cyclopropanes with nitrosoarenes offers a novel approach to various structurally diverse isoxazolidines. The reactions, which are experimentally easy to conduct, occur with complete stereospecificity and perfect control of regioselectivity. Product isoxazolidines can be readily transformed into α‐amino lactones by reductive or decarboxylative N? O cleavage and subsequent lactonisation, and the N‐aryl bond cleavage is also possible under oxidative conditions.     

AC Conduction and Time–Temperature Superposition Scaling in a Reduced Graphene Oxide–Zinc Sulfide Nanocomposite

We report, herein, the results of an in depth study and concomitant analysis of the AC conduction [σ′(ω): f=20 Hz to 2 MHz] mechanism in a reduced graphene oxide–zinc sulfide (RGO–ZnS) composite. The magnitude of the real part of the complex impedance decreases with increase in both frequency and temperature, whereas the imaginary part shows an asymptotic maximum that shifts to higher frequencies with increasing temperature. On the other hand, the conductivity isotherm reveals a frequency‐independent conductivity at lower frequencies subsequent to a dispersive conductivity at higher frequencies, which follows a power law [σ′(ω)∝ω^s] within a temperature range of 297 to 393 K. Temperature‐independent frequency exponent ′s′ indicates the occurrence of phonon‐assisted simple quantum tunnelling of electrons between the defects present in RGO. Finally, this sample follows the “time–temperature superposition principle”, as confirmed from the universal scaling of conductivity isotherms. These outcomes not only pave the way for increasing our elemental understanding of the transport mechanism in the RGO system, but will also motivate the investigation of the transport mechanism in other order–disorder systems.     

Sulphonated macroporous resin catalysts: Studies on the dehydration of 2-butanol

Sulphonated styrene-divinylbenzene resins with various cross-linking have been synthesized and the dehydration of 2-butanol has been studied on these acid catalysts. The pore structure of the resin controls the rate of dehydration. Thecis totrans ratio of the 2-butene formed indicate that the resin catalysts behave like aqueous solution of acids, i.e.dissociated protons are responsible for catalysis.     

Separation of lignosulfonate from its aqueous solution using supported liquid membrane

This paper presents an experimental and theoretical study on facilitated transport of lignosulfonate (LS) through a flat sheet supported liquid membrane using trioctylamine (TOA) as carrier and dichloroethane as diluent. The studies were carried out with various support materials and operating conditions (viz. carrier concentration, strip phase concentration, salt concentration, etc.) and their effects on the transport of LS. The results were analyzed to identify a suitable combination of support and operating condition that would yield best performance of the supported liquid membrane (SLM) in terms of fast and efficient transport of LS. The stability of the SLM was assessed in terms of loss of liquid from the pores of membrane support. The SLM is found to be stable till 10 h. Co-transport mechanism has been adopted in this work by using NaOH as the strip phase. It was observed that extraction of LS is increased with increase in concentration of NaOH up to a limiting value of 0.5 M NaOH. Difference of salt concentration between feed and strip phase considerably affect the separation process. The diffusional resistances of organic membrane (Δorg) and aqueous solution (Δaq) calculated from the permeation model, which is again a combination of three unique mechanisms viz., diffusion through a feed aqueous layer, a fast interfacial chemical reaction, and diffusion of carrier–complex through the organic membrane, are found to be 609.9 and 176.6 s cm⁻¹, respectively. The values of the diffusion coefficient in the membrane (D_org) and in the bulk organic phase (D_complex) are 1.67×10⁻⁹ and 6.68 × 10⁻⁸ m²s⁻¹, respectively. The extraction of LS is about 90%. Nearly 43% of LS can be recovered at optimum condition.     

Laser induced optoacoustic spectroscopy of benzil: Evaluation of structural volume change upon photoisomerization

The cis-skew to trans-planar photoisomerization of benzil in the photoexcited state was studied by laser-induced optoacoustic spectroscopy (LIOAS) in a series of normal alkane solvents at room temperature. The structural volume change due to the photoisomerization process has been estimated and compared with the same calculated from the optimized skew and trans structures. The magnitude of the structural volume change is estimated to be 22.9 ± 1.2 mL/mol. This study reveals that an expansion in volume occurs during the photoinduced isomerization process. In non-polar alkane solvents, the estimated volume change has been argued to be free from electrostrictional contribution.     

Simultaneous separation of mercury and lignosulfonate from aqueous solution using supported liquid membrane

This paper presents an experimental investigation on facilitated and simultaneous transport of mercury and lignosulfonate (LS) through a flat sheet supported liquid membrane (SLM) having Nylon 6,6 as support, trioctylamine (TOA) as carrier and dichloroethane as solvent. The experiments were performed at various operating conditions such as strip phase concentration, feed pH, carrier concentration and feed concentration to find the best set of parameters that would yield the maximum separation of pure mercury as well as its mixture with LS. The experiments were performed in co-transport mode using NaOH as the strip phase. It was observed that extraction of mercury as well as its mixture increases with increase in concentration of NaOH up to a certain limit 0.1 M NaOH in case of pure solution and 0.2 M NaOH in case of mixture). Feed phase pH significantly affects the mercury separation process. However, initial feed concentration does not affect the extraction process appreciably. Separation of mixture of mercury and LS behaves in a similar way as their pure solution; however the extraction is low in comparison to pure solution. The extraction of mercury from its pure solution is about 81% in 1 h. The extraction of mercury and LS from their mixture is about 52.6% and 50.2%, respectively at optimum condition and in a period of 2 h.     

Detecting hidden spatial and spatio-temporal structures in glasses and complex physical systems by multiresolution network clustering

We elaborate on a general method that we recently introduced for characterizing the “natural” structures in complex physical systems via multi-scale network analysis. The method is based on “community detection” wherein interacting particles are partitioned into an “ideal gas” of optimally decoupled groups of particles. Specifically, we construct a set of network representations (“replicas”) of the physical system based on interatomic potentials and apply a multiscale clustering (“multiresolution community detection”) analysis using information-based correlations among the replicas. Replicas may i) be different representations of an identical static system, ii) embody dynamics by considering replicas to be time separated snapshots of the system (with a tunable time separation), or iii) encode general correlations when different replicas correspond to different representations of the entire history of the system as it evolves in space-time. Inputs for our method are the inter-particle potentials or experimentally measured two (or higher order) particle correlations. We apply our method to computer simulations of a binary Kob-Andersen Lennard-Jones system in a mixture ratio of A₈₀B₂₀ , a ternary model system with components “A”, “B”, and “C” in ratios of A₈₈B₇C₅ (as in Al₈₈Y₇Fe₅ , and to atomic coordinates in a Zr₈₀Pt₂₀ system as gleaned by reverse Monte Carlo analysis of experimentally determined structure factors. We identify the dominant structures (disjoint or overlapping) and general length scales by analyzing extrema of the information theory measures. We speculate on possible links between i) physical transitions or crossovers and ii) changes in structures found by this method as well as phase transitions associated with the computational complexity of the community detection problem. We also briefly consider continuum approaches and discuss rigidity and the shear penetration depth in amorphous systems; this latter length scale increases as the system becomes progressively rigid.     

Moment method analysis of charge distribution & capacitance for the dielectric coated tilted plates isolated in free space

This paper presents a method for the evaluation of the capacitance of the dielectric coated metallic plates forming a corner using the method of moments based on the pulse basis function and the point matching. Two integral equations are formed based on the boundary conditions for the potential on the conductor surface and continuity of the normal component of the displacement flux density at the dielectric-free space interface. A set of simultaneous equations are formed from the two integral equations using the method of moments. The total free charge on the conductor surface is found from the solution of the set of simultaneous equations. Numerical data on the capacitance and the charge distribution are presented. The validity of the analysis has been justified by comparing the data on the capacitance that is available in the literature for a metallic structure with the data on the capacitance computed with the present method for a similar structure considering a very low dielectric constant as well as a very thin dielectric coating. Further validation has been carried out by comparing the capacitance data of the specific case when the angle between two metallic plates is 180° forming a dielectric coated metallic rectangular plate for which the capacitance data are available in the literature.