Guest‐Assisted Proton Conduction in the Sulfonic Mesoporous MIL‐101 MOF

Post‐synthesis modification of MIL‐101(Cr)‐NO₂ was explored in order to decorate the organic backbone by propyl‐sulfonic groups, with the aim to incorporate mobile and acidic protons for solid‐state proton electrolyte applications. The resulting solid switched from insulating towards proton superconductive behavior under humidity, while the conductivity recorded at 363 K and 95 % relative humidity reached 4.8×10^?3 S cm^?1. Propitiously, the impregnation of the material by strong acidic molecules (H₂SO₄) further boosted the proton conductivity performances up to the remarkable σ value of 1.3×10^?1 S cm^?1 at 363 K/95 % RH, which reaches the performances of the best proton conductive MOF reported so far.     

New ceramic microfiltration membranes from mineral coal fly ash

This work aims to develop a new mineral porous tubular membrane based on mineral coal fly ash. Finely ground mineral coal powder was calcinated at 700 °C for about 3 h. The elaboration of the mesoporous layer was performed by the slip casting method using a suspension made of the mixture of fly ash powder, water and PVA. The obtained membrane was submitted to a thermal treatment which consists in drying at room temperature for 24 h then a sintering at 800 °C. SEM photographs indicated that the membrane surface was homogeneous and did not present any macro defects (cracks, etc.). The average pore diameter of the active layer was 0.25 μm and the thickness was around 20 μm. The membrane permeability was 475 l/h m² bar.This membrane was applied to the treatment of the dying effluents generated by the washing baths in the textile industry. The performances in term of permeate flux and efficiency were determined and compared to those obtained using a commercial alumina microfiltration membrane. Almost the same stabilised permeate flux was obtained (about 100 l/h m²). The quality of permeate was almost the same with the two membranes: the COD and color removal was 75% and 90%, respectively.     

Deterministic solution of the kinetic theory model of colloidal suspensions of structureless particles

A direct modeling of colloidal suspensions consists of calculating trajectories of all suspended objects. Due to the large time computing and the large cost involved in such calculations, we consider in this paper another route. Colloidal suspensions are described on a mesoscopic level by a distribution function whose time evolution is governed by a Fokker–Planck-like equation. The difficulty encountered on this route is the high dimensionality of the space in which the distribution function is defined. A novel strategy is used to solve numerically the Fokker–Planck equation circumventing the curse of dimensionality issue. Rheological and morphological predictions of the model that includes both direct and hydrodynamic interactions are presented in different flows.     

Theoretical diagnostic and prediction of physical properties of quaternary InGaAsP compound using artificial neural networks optimized by the Levenberg Maquardt algorithm

The quaternaries \(In_{1 - x} Ga_{x} As_{y} P_{1 - y}\) are the main promising elements for the fabrication of optoelectronic devices. The adjustment of their physical parameters is assumed by the change of the molar fraction \(x\) and \(y\). These parameters can be affected by the variation of temperature and pressure. To make the theoretical diagnosis of these materials, it is fundamental to know the energy gap ‘\(\varvec{E}_{\varvec{g}}\)’ and the lattice parameter ‘\(a\)’, over a wide range of chemical compositions \(0 \le x \le 0.47\) and \(0 \le y \le 1\), at different temperatures and pressures. We show that by using the Artificial Neural Network method optimized by the Levenberg Maquardt algorithm ANN-LM, it is possible to obtain results very close to the experiment. The scatter plot and error calculation show that the ANN-LM model provides more accurate values of the lattice parameter than those calculated by Vegard’s law. On the other hand, the energy gap values \(Eg (x, y, T)\) estimated, using the ANN-LM model, proved to be close to the experimental values that those calculated by the empirical equations. In addition, the ANN-LM method allowed us to estimate with great accuracy the values of the energy gap at different temperatures and pressures \(Eg (P, T)\). Our work provides crucial information on the physical properties of the quaternary without the use of approximations, and without taking into account the hypothesis of a perfect agreement between \(InGaAsP\) and \(InP\) substrate.     

Strong perturbation effects in heavy ion induced electronic sputtering of lithium fluoride

Electronic sputtering of lithium fluoride by swift heavy ions was studied as a function of electronic energy loss (dE/dx) _e . The single crystal targets were irradiated with swift heavy ion beams (166Z _P 692; 46E _P /M _P (MeV/u) 611). This allowed varying the deposited energy by a factor of 20 (1.86dE/dx (keV/nm) 632). The sputtered secondary ions were measured from well controlled LiF targets without surface contaminations, by means of the time-of-flight technique (TOF-SIMS). The mass spectrum reveals an important contribution of clusters (over single ions), which increases with (dE/dx) _e . Another observation for the strongest perturbation at high dE/dx (>8 keV/nm) is that the secondary ion yields saturate: Y(dE/dx) = constant. In contrast, at lower dE/dx (<8 keV/nm) for weaker perturbation, the yield Y scales with (dE/dx)². This quadratic increase would rather point towards a thermal evaporation-like mechanism leading to electronic sputtering, however, the origin of the yield saturation remains an open finding.     

Voltammetric Sensing of Amino Acids in the Presence of Cu(II) in Acidic and Alkaline Solutions

A number of amino acids have been determined at carbon film electrodes in the presence of copper. Strongly acidic, 0.1 M HCl, in the presence of 0.1 mM Cu(II), as well as alkaline, 0.1 M NaOH, solution permit successful measurement of individual amino acids, clearer separation between oxidation of Cu and Cu‐complexes occurring in alkaline solution. Electrochemical impedance showed that Cu(II) facilitates charge transfer, particularly in alkaline medium. Square wave voltammetry with preconcentration increased the response compared to linear sweep voltammetry. Protein hydrolysis rates were monitored through determination of amino acids produced by decomposition, injecting samples into alkaline electrolyte solution.     

Antimicrobial and Antioxidant Properties of Total Polyphenols of Anchusa italica Retz

Anchusa italica Retz has been used for a long time in phytotherapy. The aim of the present study was to determine the antioxidant and antibacterial activities of extracts from the leaves and roots of Anchusa italica Retz. We first determined the content of phenolic compounds and flavonoids using Folin–Ciocalteu reagents and aluminum chloride (AlCl₃). The antioxidant activity was determined using three methods: reducing power (FRAP), 2.2-diphenyl-1-picrylhydrazyl (DPPH), total antioxidant capacity (TAC). The antimicrobial activity was investigated against four strains of Escherichia coli, two strains of Klebsiella pneumoniae and coagulase-negative Staphylococcus, and one fungal strain of Candida albicans. The results showed that the root extract was rich in polyphenols (43.29 mg GAE/g extract), while the leave extract was rich in flavonoids (28.88 mg QE/g extract). The FRAP assay showed a strong iron reduction capacity for the root extract (IC₅₀ of 0.11 µg/mL) in comparison to ascorbic acid (IC₅₀ of 0.121 µg/mL). The DPPH test determined an IC₅₀ of 0.11 µg/mL for the root extract and an IC₅₀ of 0.14 µg/mL for the leaf extract. These values are low compared to those for ascorbic acid (IC₅₀ of 0.16 µg/mL) and BHT (IC₅₀ 0.20 µg/mL). The TAC values of the leaf and root extracts were 0.51 and 0.98 mg AAE/g extract, respectively. In vitro, the extract showed inhibitory activity against all strains studied, with diameters of zones of inhibition in the range of 11.00–16.00 mm for the root extract and 11.67–14.33 mm for the leaf extract. The minimum inhibitory concentration was recorded for the leaf extract against E. coli (ATB:57), corresponding to 5 mg/mL. Overall, this research indicates that the extracts of Anchusa italica Retz roots and leaves exert significant antioxidant and antibacterial activities, probably because of the high content of flavonoids and polyphenols.