Synthesis of 1,4‐Diaryl‐piperazine‐2,5‐diones: New Behavior of N,N‐Dimethylformamide Dimethyl Acetal (DMFDMA)

Reactions of chloroacetamides (5) with N,N‐dimethylformamide dimethyl acetal gave 1,4‐diaryl‐piperazine‐2,5‐diones 11a–e in good yield, rather than 1,5‐diaryl‐3,7‐dimethoxy‐1H,5H‐[1,5]diazocine‐2,6‐diones (9a–e).     

Low‐level Laser Therapy Ameliorates CCl4‐induced Liver Cirrhosis in Rats

This study investigated the effects of low‐level laser therapy (LLLT) in the liver function, structure and inflammation in a experimental model of carbon tetrachloride (CCl₄)‐induced liver cirrhosis. Wistar rats were divided into Control, LLLT, CCl₄ and CCl₄+LLLT groups. CCl₄ groups received CCl₄ (0.4 g kg^?1; i.p.), three times a week, for 12 weeks. A 830 nm LLLT was performed with a continuous wave, 35 mW, 2.5 J cm^?2 per point, applied to four points of the liver (right and left upper and lower extremities, in the four lobes of the liver) for 2 weeks. Liver structure and inflammation (cirrhotic areas, collagen deposition, inflammation, density of Kupffer and hepatic stellate cells) and function (aspartate aminotransferase, alkaline phosphatase, gamma glutamyltransferase, lactate dehydrogenase, total proteins and globulins) were evaluated. LLLT significantly reduced CCl₄‐increased aspartate aminotransferase (P < 0.001), alkaline phosphatase (P < 0.001), gamma‐glutamyl transferase (P < 0.001) and lactate dehydrogenase (P < 0.01) activity, as well as total proteins (P < 0.05) and globulins (P < 0.01). LLLT also reduced the number of cirrhotic areas, the collagen accumulation and the hepatic inflammatory infiltrate. Of note, LLLT reduced CCl₄‐increased number of Kupffer cells (P < 0.05) and hepatic stellate cells (P < 0.05). We conclude that LLLT presents beneficial effects on liver function and structure in an experimental model of CCl₄‐induced cirrhosis.     

The synthesis and optical properties of different zinc oxide nanostructures

The tetrapod-like whiskers (T-ZnO), nanoaeroplanes, nanocombs, nanobelts, bead-like nanoforms and many other forms of hexagonal zinc oxide were synthesized by the chemical deposition process (CVD). From the experimental results it can be seen that the composition of source gases and the speed of oxidation are essential to the growth of each of these morphologies of zinc oxide. By controlling the growth conditions, one novel morphology of ZnO (bead-like nanoform) has been obtained. The ZnO tetrapod-like whiskers were grown without catalysts on the walls of quartz tube. The structure and morphology of the T-ZnO was characterized. All four legs of as-grown ZnO nanotetrapods are needle-like and hexagonal shaped and grow in the ±[0001] direction. The effect of synthesis conditions on the morphology and size T-ZnO was observed. Possible mechanisms of growth were investigated. The lengths of the legs of the tetrapods range from 1 to 15 μm and diameter varying from 0.03 to 1 μm during the synthesis. In the photoluminescence spectra T-ZnO clearly shows two maxima at UV and visible regions. The oxygen impurity, particularly, oxygen flow rates mainly influences on increasing (decreasing) at PL peaks. The maximum near of 590–610 nm (～2 eV), confirming the influence of native defects (oxygen vacancies and interstitials) on the PL intensity and optical quenching exciton peak.     

Regiospecific Phenyl Esterification to Some Organic Acids Catalyzed by Combined Lewis Acids

A new and efficient method for the preparation of various phenyl esters has been achieved by a simple reaction of an acid with phenol in the presence of anhyd. ZnCl₂ and a catalytic amount of AlCl₃. This combined Lewis acid also catalyzes the selective phenyl esterification to different dioic acids and is very simple and high yielding.     

Influence of oxygen flow rate on the surface chemistry and morphology of radio frequency (RF) magnetron sputtered zinc oxide thin films

Zinc oxide thin films were deposited, by radio frequency magnetron sputtering, on heated and unheated substrates. The oxygen flow rate was varied during deposition, and its effects on the structural and chemical properties of the films were investigated. The films had oriented c‐axis growth with nano‐crystallite size. Their surfaces manifested columnar microstructure, with a surface roughness that was suppressed by the introduction of oxygen. Chemical analysis showed that deposition under an oxygen atmosphere resulted in substantial reduction of oxygen vacancies, with a corresponding incorporation of chemisorbed species. Copyright © 2013 John Wiley & Sons, Ltd.     

Temperature Effect on the Phase Behavior of the Systems Water/Sucrose Laurate/Ethoxylated‐mono‐di‐glyceride/Oil

The phase behavior of the systems water/sucrose laurate/ethoxylated mono‐di‐glyceride/oil was investigated as function of temperature and the weight ratio of EMDG in the mixed surfactants. The oils were R (+)‐limonene, isopropylmyristate, and caprylic‐capric triglyceride. This study demonstrates that the phase inversion temperature (PIT) decreases and the efficiency of the mixed surfactants (γ¯) increase as the weight ratio of the EMDG in the mixed surfactants increases. R (+)‐limonene gave lower phase inversion temperatures and higher efficiencies compared to isopropylmyristate, and caprylic‐capric triglyceride. The solubilization capacity of the system water/sucrose laurate/oil increased upon the addition of ethoxylated mono‐di‐ glyceride which stabilize the surfactant layer and increase the interfacial area.     

Water‐in‐Crude Oil Emulsions in the Burgan Oilfield: Effects of Oil Aromaticity,Resins to Asphaltenes Content (R/(R+A)), and Water pH

Asphaltenes and resins separated from emulsion samples collected from Burgan oil field were used with heptane‐toluene mixtures as model oil to study the effect of oil aromaticity, resin content, and pH of the aqueous phase on the stability of water in model emulsions. It was confirmed that, as long as the asphaltenes are completely solubilized, increasing aromaticity leads to less stable emulsions. A consistent correlation between emulsion stability and relative resin mass content (R/(R+A)) was observed for all three of the field samples. There was a sharp decrease in stability when the R/(R+A) value exceeded 0.75. Emulsion stability was enhanced at high pH and possibly at very low pH (<2).     

Synthesis of Some Oil Spill Dispersants Based on Sorbitol Esters and Their Capability to Disperse Crude Oil on Seawater to Alleviate Its Accumulation and Environmental Impact

In this respect mono‐, di‐, and tri‐ sorbitol oleate esters [SMO, SDO, and STO] were prepared and then ethoxylated using ethylene oxide to obtain six sorbitol esters at different ethylene oxide content (e.o=5, 12, 15, 20, 35, and 45). They were tested as oil spill dispersants individually and in blends. From the obtained data, it was found that the blends are more effective than the corresponding individual surfactants. The maximum dispersion capability for the prepared surfactants was obtained at HLB range from 9 to 11 for the both individual surfactants and blends. The increase of total carbon number in the surfactant alkyl group leads to increase dispersion capability of the dispersant. The wide range of ethylene oxide content was used, but the maximum dispersion efficiency was obtained at ethylene oxide=20 in E(20)STO. Meanwhile, the dispersion capability increases when the interfacial tension decreases.     

Modelling interaction between ammonia and nitric oxide molecules and aquaporins

Aquaporin is a family of small membrane-proteins that are capable of transporting nano-sized materials. In the present paper, we investigate the structure of these channels and provide information about the mechanism of individual molecules being encapsulated into aquaglyceroporin (GlpF) and aquaporin-1 (AQP1) channels by calculating the potential energy. In particular, we presents a mathematical model to determine the total potential energy for the interaction of the ammonia and nitric oxide molecules and different aquaporin channels which we assume to have a symmetrical cylindrical structure. We propose to describe these interactions in two steps. Firstly, we model the nitrogen atom as a discrete point and secondly, we model the three hydrogen atoms on the surface of a sphere of a certain radius. Then, we find the total potential energy by summing these interactions. Next, by considering the nitric oxide molecule as two discrete atoms uniformly distributed interacting with GlpF and AQP1 channels then gathering all pairs of interaction to determine the potential energy. Our results show that the ammonia and nitric oxide molecules can be encapsulated into both GlpF and AQP1 channels.     

Identification of ligands that target the HCV-E2 binding site on CD81

Hepatitis C is a global health problem. While many drug companies have active R&D efforts to develop new drugs for treating Hepatitis C virus (HCV), most target the viral enzymes. The HCV glycoprotein E2 has been shown to play an essential role in hepatocyte invasion by binding to CD81 and other cell surface receptors. This paper describes the use of AutoDock to identify ligand binding sites on the large extracellular loop of the open conformation of CD81 and to perform virtual screening runs to identify sets of small molecule ligands predicted to bind to two of these sites. The best sites selected by AutoLigand were located in regions identified by mutational studies to be the site of E2 binding. Thirty-six ligands predicted by AutoDock to bind to these sites were subsequently tested experimentally to determine if they bound to CD81-LEL. Binding assays conducted using surface Plasmon resonance revealed that 26 out of 36 (72 %) of the ligands bound in vitro to the recombinant CD81-LEL protein. Competition experiments performed using dual polarization interferometry showed that one of the ligands predicted to bind to the large cleft between the C and D helices was also effective in blocking E2 binding to CD81-LEL.