Elongating the area of plasma/fluid interaction of surface nanosecond pulsed discharges

Plasma-assisted flow control is of high industrial interest, but practical applications at full scale require a large surface of interaction. Nanosecond pulsed Dielectric Barrier Discharge (DBD) have demonstrated promising results of flow control, but their interacting region is limited to only a few cm². In this paper, the conditions to extend a surface nanosecond DBD are documented. It is shown that a sliding discharge regime can fully fill an inter-electrode distance of 40 mm. This discharge regime promotes the formation of two hemispheric pressure waves originating from both air-exposed electrodes while an horizontal region of pressure gradient is also observed.     

(111)择优取向的Pb(Zr0.52Ti0.48)O3铁电薄膜的制备及研究

选用不同浓度的Pb(Zr_0.52Ti_0.48)O₃溶胶，用Sol-gel法在Pt/Ti/SiO₂/Si基片上沉积一层厚度不同的Pb(Zr_0.52Ti_0.48)O₃ (PZT52)过渡层，经400℃烘烤、550℃退火等程序后，再用Sol-gel法在PZT52过渡层上沉积Pb(Zr_0.52Ti_0.48)O _{关键词： PZT铁电薄膜 择优取向 过渡层 剩余极化强度}     

(Ni0.8Zn0.2Fe2O4)epoxy-PZT双层膜中的磁电效应

讨论了Ni_0.8Zn_0.2Fe₂O₄ (NZFO)与锆钛酸铅(PZT)的双层膜结构样品的磁电(ME)效应.NZFO粉料由溶胶-凝胶法制成，再经900℃热压，并高温烧结.在该双层膜中测量到了很强的磁电相互作用.发现横向的磁电效应比纵向效应大一个数量级，并且随NZFO烧结温度的提高而增加.当烧结温度从950℃上升到1380℃时，横向ME电压系数(α_E)的最大值变化范围为25.6 mV Am^-2≤α_E≤199.6 mV Am^-2.理论分析显示NZFO-PZT双层膜样品中ME效应源于NZFO与PZT之间相对良好的磁电耦合. 关键词： 镍铁氧体 PZT 热压法 ME效应     

多排叶片内部流动以及叶片排与排气系统相互作用研究

本文采用高分辨率格式和多块多网格方法求解雷诺平均Navier-Stokes方程,数值模拟多排叶片内的三维粘性流动;使用数值激盘模拟叶片排的存在,研究叶片排与非轴对称排气部件之间的相互作用以及复杂的内部流动。文中描述了数值方法,给出了NASA透平导叶和单级透平内部流场的数值结果及其与相应实验结果的对比,也给出了多级透平内部流场的数值结果,以及透平与排气部件之间的耦合流场的结果。     

Polarization inscription in ferroelectric (111) PZT and (100) SBT films

Ferroelectric thin films form an equilibrium domain structure compatible with their respective crystallographic symmetry. In tetragonal (111) PZT, 90° domains prevail; in (pseudo-tetragonal) (100) SBT both 90° and 180° domains are present. The size of 90° domains has been measured for e.g., PZT as slabs of 15 nm width. Domain size is a result of stress minimization in the film during the paraelectric (PE) → ferroelectric (FE) transition. A precise and regular domain pattern for (111) PZT and (100) SBT films has been investigated in detail by TMSFM. Single domains can be addressed mechanically with the tip of an AFM. Such single domain switching corresponds to a data storage density of 200 Gbit/inch². Applications of ferroelectric and high- paraelectric materials for e.g., non-volatile data storage replacing DRAM devices or as sensors in infrared cameras are increasingly becoming popular.     

后退火温度对溅射沉积Pb(Zr0.52Ti0.48)O3铁电薄膜结构和性能的影响

在具有Ti缓冲层的Pt(111)底电极上,用射频溅射工艺在较低的衬底温度(370℃)和纯Ar气氛中沉积Pb(Zr0.52Ti0.48)O3(PZT)薄膜,沉积过程中基片架作15°摇摆以提高膜厚的均匀性。然后将样品在大气中进行5min快速热退火处理,退火温度550-680℃。用XRD、SEM分析薄膜的微结构,RT66A标准铁电测试系统测量样品的铁电和介电性能。结果表明,所沉积的Pt为(111)取向,仅当后退火温度高于580℃,沉积在Pt(111)上的PZT薄膜才能形成钙钛矿结构的铁电相,退火温度在580-600℃时结晶为(110)择优取向,退火温度高于600℃时结晶为(111)择优取向。PZT薄膜的极化强度随退火温度的升高而增加,但退火温度超过650℃时漏电流急剧上升,因此退火处理的温度对PZT薄膜的结构和性能有决定性的影响。     

Orientation control of perovskite thin films on glass substrates by the application of a seed layer prepared from oxide nanosheets

Orientation control of perovskite compounds was investigated by the application of a seed layer prepared from oxide nanosheets. An aqueous suspension of oxide nanosheets was prepared by the exfoliation of a layered compound of KCa₂Nb₃O₁₀ oxide grains. A seed layer composed of (TBA)Ca₂Nb₃O₁₀ nanosheets (TBA = tetrabutylammonium) was formed on a glass substrate by simply dip coating it in the suspension. Two kinds of perovskite compounds, LaNiO₃ (LNO) and Pb(Zr,Ti)O₃ (PZT) with a preferred orientation of (00l) were successfully grown on this seeded glass substrate. In this study, the relation between lattice mismatch and electrical properties is investigated. A large, oriented PZT film with a size of 5 ×4 cm shows an improved P-E hysteresis behavior by use of this orientation control.     

Synthesis and mechanism research of an ethylene glycol-based sol-gel method for preparing PZT nanopowders

Lead zirconate titanate nanopowders Pb(Zr_0.52Ti_0.48)O₃ (PZT) were prepared by modified sol-gel process in ethylene glycol system with zirconium nitrate as the zirconium source. The research showed that it was critical to add lead acetate after the reaction of zirconium nitrate and tetrabutyl titanate in ethylene glycol system for preparing PZT of exact titanium content. The reaction mechanisms of the sol synthesis, preparation of xerogel and agglutinating process were characterized through using FT-IR, NMR, TG-FTIR, and GC-MS. The experiment proved that ethylene glycol system did not rely on hydrolysis and condensation reactions in the process of the sol formation, but on the formation of chain or network large molecules from complexation of ethylene glycol and all Ti and minor Pd, Zr. In the preparation of xerogel, the complexation reaction was so completed that it formed large molecules network composed of metal and dioxyethyl. Bulk weight loss happened before 350°C in the process of sintering xerogel to prepare PZT nanopowders. Volatile matters and vapor phase decomposition resultants were primarily oxy-compounds including ethylene glycol, aldehyde-ketone compounds, carbon dioxide and nitrate radical conversion matters. After 350°C, primary vapor phase decomposition resultants were carbon dioxide and minor carbonyl compound.     

Graded PZT ceramics for piezoelectric transformers

In the present study two types of the synthesized Pb(Zr_1−xTi_x)O₃ (PZT) powders differing in Zr/Ti ratio were used to prepare the spatially inhomogeneous (i.e., graded) structure. A position-dependent chemical composition was expected to cause the property gradient. Disk-shaped compacts were prepared in a way such that two different orientations of the radial gradients were formed. The solid state sintering under pressure was utilized to prepare ceramics. Simultaneous thermal analysis was used to study thermal behavior of the ceramic powders. Graded PZT ceramics were characterized using X-ray diffraction, scanning electron microscopy and energy dispersive spectroscopy. It was also characterized in terms of its dielectric properties by both bridge technique and the impedance spectroscopy. On the basis of graded PZT ceramics the disk-shaped radial mode piezoelectric transformer was developed and fabricated.     

Microstructure and ferroelectric properties of r.f. magnetron sputtering derived PZT thin films deposited on interlayer (PbO/TiO2)

Lead zirconate titanate (PZT) thin films were deposited on Pt/Ti/SiO₂/Si and interlayer/Pt/Ti/SiO₂/Si substrate by radio frequency (r.f.) magnetron sputtering with a Pb_1.1Zr_0.53Ti_0.47O₃ target. The crystallization of the PZT thin films was formed only by substrate temperature. When interlayer (PbO/TiO₂) was inserted between the PZT thin film and the Pt electrode, the grain growth and processing temperature of the PZT thin films were considerably improved. Compared to PZT/Pt structure, the dielectric constant and polarization properties of the PZT/interlayer/Pt structure were fairly improved. In particular, PZT/interlayer/Pt at the substrate temperature of 400 °C showed prevalent ferroelectric properties (_r=475.97, tanδ=0.0591, P_r=23 μC/cm²). As a result of an X-ray photoelectron spectroscopy (XPS) depth-profile analysis, it was found that PZT/interlayer/Pt deposited only by substrate temperature without the post-annealing process via r.f. magnetron sputtering method remained independent of each other regardless of substrate temperatures.