Automated in situ trace element analysis of silicate materials by laser ablation inductively coupled plasma mass spectrometry

This paper describes the automated in situ trace element analysis of solid materials by laser ablation (LA) inductively coupled plasma mass spectrometry (ICP-MS). A compact computer-controlled solid state Nd:YAG Merchantek EO UV laser ablation (LA) system has been coupled with the high sensitivity VG PQII S ICP-MS. A two-directional communication was interfaced in-house between the ICP-MS and the LA via serial RS-232 port. Each LA-ICP-MS analysis at a defined point includes a 60 s pre-ablation delay, a 60 s ablation, and a 90 s flush delay. The execution of each defined time setting by LA was corresponding to the ICP-MS data acquisition allowing samples to be run in automated cycle sequences like solution auto-sampler ICP-MS analysis. Each analytical cycle consists of four standards, one control reference material, and 15 samples, and requires about 70 min. Data produced by Time Resolved Analysis (TRA) from ICP-MS were later reduced off-line by in-house written software. Twenty-two trace elements from four reference materials (NIST SRM 613, and fused glass chips of BCR-2, SY-4, and G-2) were determined by the automated LA-ICP-MS method. NIST SRM 610 or NIST SRM 613 was used as an external calibration standard, and Ca as an internal standard to correct for drift, differences in transport efficiency and sampling yield. Except for Zr and Hf in G-2, relative standard deviations for all other elements are less than 10%. Results compare well with the data reported from literature with average limits of detection from 1 ng x g(-1) to 455 ng x g(-1) and less than 100 ng x g(-1) for most trace elements.     

Imaging mass spectrometry in biological tissues by laser ablation inductively coupled plasma mass spectrometry

Of all the inorganic mass spectrometric techniques, laser ablation inductively coupled plasma mass spectrometry (LA-ICP-MS) plays a key role as a powerful and sensitive microanalytical technique enabling multi- element trace analysis and isotope ratio measurements at trace and ultratrace level. LA-ICP-MS was used to produce images of detailed regionally-specific element distribution in 20 microm thin sections of different parts of the human brain. The quantitative determination of copper, zinc, lead and uranium distribution in thin slices of human brain samples was performed using matrix-matched laboratory standards via external calibration procedures. Imaging mass spectrometry provides new information on the spatially inhomogeneous element distribution in thin sections of human tissues, for example, of different brain regions (the insular region) or brain tumor tissues. The detection limits obtained for Cu, Zn, Pb and U were in the ng g(-1) range. Possible strategies of LA-ICP-MS in brain research and life sciences include the elemental imaging of thin slices of brain tissue or applications in proteome analysis by combination with matrix-assisted laser desorption/ionization MS to study phospho- and metal- containing proteins will be discussed.     

Determination of long-lived radionuclides in concrete matrix by laser ablation inductively coupled plasma mass spectrometry

A laser ablation system using a Nd:YAG laser was coupled both to a quadrupole inductively coupled plasma (ICP) mass spectrometer and to a double-focusing sector field ICP mass spectrometer. Laser ablation inductively coupled plasma mass spectrometry (LA-ICP-MS) was applied for the determination of long-lived radionuclides in a concrete matrix. The investigated samples were two laboratory standards with a concrete matrix, which we doped with different long-lived radionuclides (e.g. ⁹⁹Tc, ²³²Th, ²³³U, ²³⁷Np) from the ng g⁻¹ to μ g⁻¹ concentration range and an undoped concrete material (blank). Detection limits for long-lived radionuclides in the 10 ng g⁻¹ range are reached for LA-ICP-MS using the quadrupole mass spectrometer. With double-focusing sector field ICP-MS, the limits of detection are in general one order of magnitude lower and reach the sub ng g⁻¹ range for ²³³U and ²³⁷Np. A comparison of mass spectrometric results with those of neutron activation analysis on undoped concrete sample indicates that a semiquantitative determination of the concentrations of the minor and trace elements in the concrete matrix is possible with LA-ICP-MS without using a standard reference material.     

Biomonitoring of essential and toxic metals in single hair using on-line solution-based calibration in laser ablation inductively coupled plasma mass spectrometry

Laser ablation inductively coupled plasma mass spectrometry (LA-ICP-MS) has been established as a powerful and sensitive surface analytical technique for the determination of concentration and distribution of trace metals within biological systems at micrometer spatial resolution. LA-ICP-MS allows easy quantification procedures if suitable standard references materials (SRM) are available. In this work a new SRM-free approach of solution-based calibration method in LA-ICP-MS for element quantification in hair is described. A dual argon flow of the carrier gas and nebulizer gas is used. A dry aerosol produced by laser ablation (LA) of biological sample and a desolvated aerosol generated by pneumatic nebulization (PN) of standard solutions are carried by two different flows of argon as carrier or nebulizer gas, respectively and introduced separately in the injector tube of a special ICP torch, through two separated apertures. Both argon flows are mixed directly in the ICP torch. External calibration via defined standard solutions before analysis of single hair was employed as calibration strategy. A correction factor, calculated using hair with known analyte concentration (measured by ICP-MS), is applied to correct the different elemental sensitivities of ICP-MS and LA-ICP-MS. Calibration curves are obtained by plotting the ratio of analyte ion M⁺/³⁴S⁺ ion intensities measured using LA-ICP-MS in dependence of analyte concentration in calibration solutions. Matrix-matched on-line calibration in LA-ICP-MS is carried out by ablating of human hair strands (mounted on a sticky tape in the LA chamber) using a focused laser beam in parallel with conventional nebulization of calibration solutions. Calibrations curves of Li, Na, Mg, Al, K, V, Cr, Mn, Fe, Ni, Co, Cu, Zn, Sr, Mo, Ag, Cd, I, Hg, Pb, Tl, Bi and U are presented. The linear correlation coefficients (R) of calibration curves for analytes were typically between 0.97 and 0.999. The limits of detection (LODs) of Li, V, Mn, Ni, Co, Cu, Sr, Mo, Ag, Ba, Cd, I, Hg, Pb, Bi and U in a single hair strand were in the range of 0.001-0.90 μg g⁻¹, whereas those of Cr and Zn were 3.4 and 5.1 μg g⁻¹, respectively. The proposed quantification strategy using on-line solution-based calibration in LA-ICP-MS was applied for biomonitoring (the spatial resolved distribution analysis) of essential and toxic metals and iodine in human hair and mouse hair.     

电感耦合等离子体质谱法测定花生中34种元素

建立了微波消解-碰撞/反应池(ORS)电感耦合等离子体质谱仪(ICP-MS)同时测定花生中的Na、Mg、Ca、Fe、Se、Mo和稀土元素等34种元素的分析方法。样品经微波消解后,在线加入内标元素45Sc、72Ge、103Rh、115In和209Bi消除基体效应,应用碰撞反应池技术,以4.5 mL/min流速的氦气作为碰撞反应气,有效消除多原子离子产生的质谱干扰。各元素的检出限为0.0003～17.37ng/mL,相对标准偏差(RSD)低于2.9%;标准物质的测定值均在标准值范围内,结果令人满意。该方法可用于花生中多种元素的同时测定。     

Analysis of solids by laser ablation - inductively coupled plasma - mass spectrometry (LA-ICP-MS)—I. matching with a glass matrix

The possibility of quantitative elemental analysis of solids by laser ablation - inductively coupled plasma - mass spectrometry (LA-ICP-MS) has been investigated. The solids were mixed with a flux and fused to a glass bead so that a similar matrix composition would be obtained for the different samples (matrix matching), and an internal standard could be added. Strontium, present in the flux materials, was found to be suitable as the internal standard. Two major problems were experienced in the analysis: memory effects and interference from polyatomic ions. The memory effects were probably due to deposits of particles in the transfer tubes between the laser ablation cell and the ICP torch. At masses below 80 m/z, strong interferences from polyatomic ions caused serious problems in the quantification and, for elements studied in that mass region, detection limits were poor. The technique was further applied more specifically to the determination of rare earth elements in geological materials, for which detection limits varied from 0.02 to 3 mg/kg. Quantitative analysis, independent of the kind of sample material, proved possible.     

A simple method of target preparation for the bulk analysis of powder samples by laser ablation inductively coupled plasma mass spectrometry (LA-ICP-MS)

A simple and rapid procedure using a glue technique has been developed for the preparation of stable targets from powder samples for bulk analysis by LA-ICP-MS. The procedure was evaluated for the analysis of trace elements in SiC, of rare-earth elements in different types of silicate (rocks, sediments, and soils), and of Au and platinum-group elements in geological silicates. The test analysis was conducted using an IR laser in combination with a quadrupole mass spectrometer. The recommended preparation procedure offers the possibility of different types of calibration, for example application of certified reference samples in combination with prepared spiked samples on a base of a natural or synthetic matrix, or addition calibration. The resulting calibration functions are linear over a range of several decades. The trueness of the results was evaluated by use of certified reference samples. Analytical concentration ranges, detection limits, and the relative standard deviations are reported.     

Multielemental analyses of tree rings by inductively coupled plasma mass spectrometry

Inductively coupled plasma mass spectrometry (ICP-MS) was evaluated for major, minor, trace, and ultra-trace elemental analyses of individual tree rings. The samples were obtained from an old-growth Douglas fir (Pseudotsuga menziesii) growing 15 km northeast of Mount St. Helens volcano, Washington, USA and from trees at various other North American sites. Samples were brought into solution by microwave digestion in sealed Teflon vessels. Eightly percent of elements from Li to U had detection limits in the solid (wood) below 8.0 ng g^–1 (parts per billion, ppb). When selected element concentrations in the Mount St. Helens samples are plotted against time, two anomalous peaks occur at A. D. 1478 and 1490 that closely correlate with past eruptions of the volcano. These preliminary results show that ICP-MS is a rapid and sensitive analytical method for multielemental analyses of individual tree rings.     

Spectral interpretation and interference correction in inductively coupled plasma mass spectrometry

To tackle the several problematic polyatomic interferences in inductively coupled plasma mass spectrometry (ICP-MS), we have developed a software approach based on data reduction of the measured total mass spectrum through multicomponent analysis (MCA). The approach leans on a working knowledge of interferents that are likely to be encountered in a sample matrix, which composition is known by virtue of the total mass spectrum and knowledge of applied solvents. The full isotopic patterns for all elements and expected interferents are used in the modelling MCA matrix of 250 masses × 105 species at maximum. Polyatomic abundances are calculated by the software. Since all species are modelled fundamentally through their known natural abundances, the MCA matrix can be manipulated and reprocessed until interpretation of the mass spectrum and, hence, interference correction are optimal. The optimum is attained by use of the bar graph and calculation modes of the PC software and criteria for properly found isotopic patterns. With optimized models stored in the data base, the user may routinely process samples in one go, and operate the ICP-MS system in a true all-element mode. Use of elemental equations or measurement of large multivariate calibration sets and pure component solutions are superfluous. Data reduction is solely based on the information about the isotopic patterns, present in the measured mass spectrum itself. As a result, in the case of interferences, detection limits may be lowered by one to two orders of magnitude. The approach is illustrated with an industrial example of Hf determined in NdFeB, and with an environmental example. Here, a suite of elements over the 50–82 amu mass range has been determined in different salt matrices in ground water.     

Determination of vanadium by reaction cell inductively coupled plasma mass spectrometry

Recent advances in inductively coupled plasma mass spectrometry (ICP-MS) have included the addition of interference reduction technologies, such as collision and reaction cells, to improve its detection capability for certain elements that suffer from polyatomic interferences. The principle behind reaction cell (RC)-ICP-MS is to remove a particular polyatomic interference by dissociation or formation of a different polyatomic species that no longer interferes with the analyte of interest. However, some interferences cannot be removed by commonly reported reaction gases, such as hydrogen, oxygen, or methane, necessitating using more reactive and hazardous gases, such as ammonia. The current study investigates oxygen as a reaction gas in RC-ICP-MS to specifically react with vanadium analyte ions, rather than the interferents, to produce a polyatomic analyte species and thereby provide a way to analyze for vanadium in complex environmental matrices. The technique has been tested on a series of river water, tap water, and synthetic laboratory samples, and shown to be successful in vanadium analyses in high chloride and sulfate matrices. The zinc isobaric interference on the new vanadium oxide analyte at m/z 67 is also investigated, and can be corrected by using a standard mathematical correction equation. The results of this study further increase the utility of RC-ICP-MS analytical techniques for complex environmental matrices.