强短脉冲辐照叠加态原子增强阿秒脉冲强度

采用强短激光脉冲辐照叠加态原子提高孤立阿秒脉冲的强度。数值研究表明,与强短脉冲 (脉冲宽度只有几个光学周期的超短脉冲）辐照基态原子获得孤立阿秒脉冲相比,采用叠加 态原子的方案不仅同样可以获得孤立的阿秒脉冲,而且阿秒脉冲的强度得到显著增强。     

双色激光脉冲辐照叠加态生成强的38 as孤立脉冲

采用多周期800 nm激光组合1 600 nm红外激光脉冲辐照氦离子He⁺叠加态生成强、短孤立阿秒脉冲. 结果表明,相对于800 nm单色激光辐照基态情形,截止频率由70次谐波大幅度展宽到280次谐波,且获得频宽为108 eV并由单一短量子路径贡献的连续辐射谱,叠加该连续谱210次到280次谐波获得了脉宽为38 as的强、短孤立脉冲,其强度比单色场情形提高了11个数量级. 研究进一步表明,两束激光脉冲的时间延迟从0.05π到－0.05π之间获得的孤立阿秒脉冲是最优化的,且脉冲持续时间 关键词： 组合激光脉冲 相干叠加态 阿秒脉冲     

双色激光脉冲辐照下38 as孤立短脉冲的产生

通过数值求解一维含时薛定谔方程, 本文研究了具有特定波长的双色激光脉冲与氦原子相互作用产生的高次谐波和阿秒脉冲, 这里双色激光脉冲由5 fs较低强度基频钛宝石主脉冲与另一束较高强度的1330 nm 红外附加脉冲构成. 研究发现, 若两束脉冲之间的相对相位选择合适, 可以获得宽带连续辐射的高次谐波谱, 叠加该连续辐射谱可获得脉宽为38 as的孤立短脉冲. 进一步研究发现, 不同于以往孤立阿秒脉冲研究中选出长、短量子路径之一作为辐射源, 这里单阿秒脉冲来源于长、短两个量子路径的贡献, 只是这两个量子路径在很宽的谐波次数变化范围内辐射时刻比较集中. 关键词： 双色激光脉冲 阿秒脉冲 量子路径     

附加谐波脉冲生成强的39阿秒孤立脉冲

采用多周期800 nm激光组合它的27次谐波脉冲生成超短、宽频的孤立阿秒脉冲.研究表明,脉宽为1 fs的27次谐波脉冲可以有效地控制电子动力学过程.将其加入到单色激光场的特定时域,可以控制电离概率在半个光学周期内迅速提升,使得谐波的转化效率相对于单色场情形增强4个数量级,并实现单一的短量子路径选择,出现频宽为108 eV的超连续辐射谱,叠加该连续谱140次到210次谐波获得了脉宽为39as的强、短孤立脉冲.与文献[7]中采用5 fs/800 nm激光附加紫外阿秒脉冲的方法相比,该方案生成的连续谱频带增宽一 关键词： 组合激光脉冲 连续辐射谱 阿秒脉冲     

啁啾激光与半周期脉冲形成的组合场驱动原子产生单个阿秒脉冲

提出了由波长为800 nm、脉冲宽度为5 fs的啁啾激光与半周期脉冲形成组合场,并利用这种组合场驱动一维模型氦原子获得单个阿秒脉冲. 通过数值求解一维氦原子的含时薛定谔方程,发现氦原子在组合场驱动下高次谐波谱的截止位置可以扩展到I_p+21.6U_p. 对第二平台区域不同范围内高次谐波的叠加都能得到单个阿秒脉冲,最短可达37 as,特别是对平台区域的前端进行叠加不仅能够得到较短的单个阿秒脉冲,而且与截止位置附近高次谐波构造的阿秒脉冲相比,强度提高了3个数量级. 关键词： 啁啾激光场 半周期脉冲 高次谐波 阿秒脉冲     

少周期飞秒脉冲在氩晶体中高次谐波产生的最优控制

采用第一性原理的含时密度泛函理论,系统地研究了少周期高强度飞秒脉冲驱动氩晶体固体产生孤立阿秒脉冲的脉宽、强度随驱动脉冲波形、偏振方向的变化规律.结果发现：1)固体产生的孤立阿秒脉冲对驱动脉冲波形和偏振十分敏感;2)在最优的驱动脉冲波形和偏振情况下,固体产生的孤立阿秒脉冲的宽度与原子气相比没有明显增大的同时,其强度比原子气产生的强度大了接近4倍.结果对固体孤立阿秒脉冲产生及其调控的探索是有帮助的.     

通过控制量子路径得到孤立46阿秒脉冲

本篇文章提出了一种利用合成场的方案来获得孤立46阿秒脉冲.首先通过在双色场上叠加低频场得到合成场,其次,我们针对氦原子数值求解了一维含时薛定谔方程.计算结果表明,该方案不仅可以拓宽高次谐波谱的平台区域,也可以有效的选择短量子路径来贡献谐波谱.此外,通过调节低频场的强度可以进一步拓宽谐波谱的平台区域,通过叠加135阶到185阶谐波,可以得到孤立的46阿秒脉冲.     

通过控制量子路径得到孤立46阿秒脉冲

本篇文章提出了一种利用合成场的方案来获得孤立46阿秒脉冲.首先通过在双色场上叠加低频场得到合成场,其次,我们针对氦原子数值求解了一维含时薛定谔方程.计算结果表明,该方案不仅可以拓宽高次谐波谱的平台区域,也可以有效的选择短量子路径来贡献谐波谱.此外,通过调节低频场的强度可以进一步拓宽谐波谱的平台区域,通过叠加135阶到185阶谐波,可以得到孤立的46阿秒脉冲.     

利用超短的紫外光源来增强阿秒脉冲的强度

本文理论提出了一种利用超短紫外光源来增强阿秒脉冲强度的方法 .计算结果表明,当适当的加入一束62 nm或者125 nm超短紫外光源到双色激光场时,不仅高次谐波的截止能量被延伸了,而且谐波的强度也比原双色场时有明显的增强.尤其是当采用125 nm光源时,谐波的强度被增强了2个数量级,并且形成了一个232 e V的超长平台区.最后通过叠加谐波次数从113次到170次可获得脉宽仅为43 as的孤立阿秒脉冲,其强度比原双色场情况下产生的阿秒脉冲增强了2个数量级.     

利用超短的紫外光源来增强阿秒脉冲的强度

本文理论提出了一种利用超短紫外光源来增强阿秒脉冲强度的方法. 计算结果表明, 当适当的加入一束62nm或者125nm超短紫外光源到双色激光场时, 不仅高次谐波的截止能量被延伸了, 而且谐波的强度也比原双色场时有明显的增强. 尤其是当采用125nm光源时,谐波的强度被增强了2个数量级,并且形成了一个232eV的超长平台区. 最后通过叠加谐波次数从113次到170次可获得脉宽仅为43as的孤立阿秒脉冲, 其强度比原双色场情况下产生的阿秒脉冲增强了2个数量级.     

Few-cycle pulse characterization with an acousto-optic pulse shaper

An acousto-optic pulse shaper has been used to characterize few-cycle pulses generated in a hollow-core fiber. A grism pair precompensates for the dispersion of the acousto-optic crystal, allowing the full pulse-shaping window to be used for replica generation rather than self-compensation. A 9.4 fs pulse was measured, the shortest ever measured with an acousto-optic pulse shaper, to our knowledge.     

Spectrum of an optical pulse

Intensity structure in the spectrum of a noisy pulse is derived for the case of stationary phase. It is the frequency analogue of temporal intensity fluctuations present in incoherent light. Its relevance for laser mode-locking is briefly considered.     

Monotonically chirped pulse evolution in an ultrashort pulse thulium-doped fiber laser

We report on monotonically positively chirped pulse operation of a hybridly mode-locked thulium fiber laser. Dispersion management was realized with a small-core, high-NA fiber providing normal dispersion in the 2 μm wavelength region. The laser delivered pulses with 0.7 nJ energy at the 1927 nm center wavelength and sub-500-fs pulse duration after compression.     

Diffraction of an ultrashort pulse by an aperture

The scalar problem of diffraction of an infinitely short pulse by a plane screen is solved within Kirchhoff’s approximation. The response of an infinitely small aperture is calculated, and the explicit solution is found for the case of a circular aperture.     

Reducing pulse distortion in fast-light pulse propagation through an erbium-doped fiber amplifier

When a pulse superposed on a cw background propagates through an erbium-doped fiber amplifier with a negative group velocity, either pulse broadening or pulse compression can be observed. These effects can be explained in terms of two competing mechanisms: gain recovery and pulse spectrum broadening. The distortion of the pulse shape caused by these effects depends on input pulse width, pump power, and background-to-pulse power ratio. With the proper choice of these three parameters, we can obtain significant pulse advancement with minimal pulse distortion.     

Generation of an attosecond X-ray pulse in a thin film irradiated by an ultrashort ultrarelativistic laser pulse

The possibility of generating an attosecond x-ray pulse in a thin solid-density plasma layer irradiated by a femtosecond laser pulse of ultrarelativistic intensity has been demonstrated in numerical simulation. Changes in the plasma layer parameters during the light pulse result in the generation of a wide, partly continuous radiation spectrum in the layer. The separation of limited parts in the reflected or transmitted light spectrum makes it possible to obtain isolated short electromagnetic pulses with an intensity reaching 1% of the exciting light intensity.     

Nanospallation induced by an ultrashort laser pulse

A femtosecond laser pulse with power density of 10¹³ to 10¹⁴ W/cm² incident on a metal target causes ablation and ejection of the surface layer. The ejected laser plume has a complicated structure. At the leading front of the plume, there is a spall layer where the material is in a molten state. The spall layer is a remarkable part of the plume in that the liquid-phase density does not decrease with time elapsed. This paper reports theoretical and experimental studies of the formation, structure, and ejection of the laser plume. The results of molecular dynamics simulations and a theoretical survey of plume structure based on these results are presented. It is shown that the plume has no spall layer when the pulse fluence exceeds an evaporation threshold F _ev. As the fluence increases from the ablation threshold F _a to F _ev, the spall-layer thickness for gold decreases from 100 nm to a few lattice constants. Experimental results support theoretical calculations. Microinterferometry combined with a pump-probe technique is used to obtain new quantitative data on spallation dynamics for gold. The ablation threshold is evaluated, the characteristic crater shape and depth are determined, and the evaporation threshold is estimated.     

Plasma heating by an ultrashort light pulse

Nonstationary absorption of the energy of a short electromagnetic-radiation pulse in a superdense semibounded plasma is considered. An approach is proposed for finding the electron distribution function, wherein the region of the skin layer (in the anomalous skin-effect regime) is described as a boundary condition for the distribution function over the entire plasma volume. A self-similar electron-distribution function is obtained and is used to analyze the dynamics of the electromagnetic-field absorption, of the heat transfer, and of the bremsstrahlung of the heated plasma.Quantum Radiophysics Division, Lebedev Physics Institute. Translated from Preprint No. 22 of the Lebedev Physics Institute, Academy of Sciences of the USSR, Moscow, 1990.