HL-2A装置边缘等离子体的实验观测

HL-2A装置边缘等离子体在中平面的特性是通过可移动的探针组、快速扫描气动4探针和LHW天线边缘的固定4探针进行研究的。用于测量主等离子体边缘的温度、密度、悬浮电位、空间电位、径向和极向电场、雷诺协强、径向和极向等离子体流速及其径向分布。偏滤器靶板上的14组嵌入式静电3探针阵列用于测量同一环向截面的内外中性化板上的电子温度、密度、悬浮电位及其分布。     

HL-2Aװ�ñ�Ե������������ľ���ֲ�����

介绍了一种对等离子体边缘进行径向扫描的往复静电探针系统,该系统由高压气源、传输杆、光栅尺、探针组件构成。它在一次放电中能测量主等离子体边缘的温度、密度、悬浮电位、空间电位、离子饱和电流、极向电场、粒子通量等参数的径向分布以及电子温度和密度的衰减长度。测量结果表明,利用该系统测量的主等离子体边缘参数分布与JT-60U、TEXT、HT-7等装置上测量的结果一致。     

HL-2A 装置的边缘参数测量

HL-2A 装置中平面边缘的等离子体特性通过磁力传动的马赫/ 雷诺协强/ 朗缪尔10 探针组进行了研究。10 探针组安装在可径向向里和向外移动, 并可绕轴旋转360^o 的传动杆上, 用于测量主等离子体边缘的温度、密度、悬浮电位、空间电位、径向和极向电场、湍流的雷诺协强、径向和极向等离子体流速及其径向分布。HL- 2A 装置的实验结果表明, 边缘等离子体扰动诱发的雷诺协强产生了边缘极向流; 雷诺协强的径向梯度驱动带状流抑制了湍流输运。     

HL-2Aƫ����λ�εı�Ե������������

通过中平面活动10探针组、往复快速扫描4探针和低杂波天线口的固定4探针测量了主等离子体边缘的温度、密度、悬浮电位、径向和极向电场、雷诺协强、径向和极向等离子体流速及其径向分布。用偏滤器靶板上的14组嵌入式静电3探针阵列测量了同一环向截面的内外中性化板上的电子温度、密度、悬浮电位及其分布。比较了在孔栏位形和偏滤器位形下边缘等离子体特性的差异,特别是两种位形下边缘温度和密度衰减长度的变化。分析了在多脉冲超声分子束加料和低杂波注入条件下的边界等离子体特性,以及雷诺协强的径向梯度与极向流和径向电场梯度与湍流损失的相互关系。     

HL-2A偏滤器位形的边缘等离子体特性

本实验利用主真空率和偏滤器靶板上的静电探针阵列直接测量边缘和偏滤器室的等离子体参数，即边缘温度Tea，密度nea，悬浮电位Фf，径向电场Er及其梯度dEr／dr，极向电场Ep，径向流速vr，极向流速vp.     

HL-2A��Ե�������估�����˵�ʵ���о�

在一次稳定放电过程中利用快速扫描气动探针系统得到电子温度、密度、等离子体电位、极向电场以及它们的涨落、粒子通量、能量通量在径向的分布。研究了HL-2A装置边缘的静电涨落及其输运。实验结果指出,在等离子体边缘涨落量不服从玻耳兹曼关系,存在由于等离子体空间电位的梯度所产生的径向电场剪切层。分析了涨落对边缘约束的影响。     

HL-2A装置偏滤器的脱靶等离子体实验

在HL-2A装置偏滤器靶板上采用嵌入式静电三探针阵列和偏滤器室内的电动扫描四探针组测量了同一极向截面的内外中性化板上和偏滤器室内的电子温度、密度、悬浮电位、空间电位、电场、电子压强及其分布,研究了偏滤器中等离子体参数的分布及非对称性和脱靶等离子体运行模式下的等离子体行为,开展了偏滤器脱离靶板等离子体的实验研究。利用主真空室的快速往复扫描三台阶式六探针系统测量了主等离子体边缘和偏滤器室内的等离子体温度、密度、粒子通量和中性粒子密度等参数,研究了脱靶等离子体的形成过程、物理特性、控制方法,以及对主等离子体性能的影响。     

碰撞等离子体中电中性条件对单探针测量的约束

在碰撞等离子体中使用单探针测量系统测得的伏安特性曲线会发生畸变. 实验中分别测量了非碰撞条件下(20 Pa)和碰撞条件下(400 Pa)氩气(Ar)电感耦合等离子体的单探针伏安特性曲线, 并进一步通过在400 Pa下测量不同位置处的单探针伏安特性曲线和引入干扰电极调节整体电中性约束的程度的方法来分析研究曲线的畸变现象. 结果表明碰撞等离子体中整体电中性约束条件会对非碰撞探针测量系统进行约束, 并通过理论分析和实验证明:在单探针测量过程中, 以真空室壁为电位参考点, 等离子体将通过改变自身等离子体电位来满足整体电中性的要求, 此时, 单探针测得的伏安特性曲线就不是理论上的单探针的鞘层伏安特性.     

MM-4中电位和分布实验

本文描述了用静电探针测量探针悬浮电位的方法,给出了MM-4电位分布的实验结果。结果表明,轴向电位分布不对称;在等离子体中沿轴向和径向存在双离子位阱。在离子能谱测量中观察到双离子温度。产生这样电位分布的机制,归于会切系统中的斯托沫区和电子枪的不同工作方式。测量的等离子体电位为-200——300V。     

HL-2A装置快速扫描气动探针的研制和运用

快速扫描气动探针已在HL- 2A 装置上用于对边缘等离子体参数的径向分布的测量, 特别是刮离层等离子体参数的特征长度和扰动的测量。该系统采用精密的气动气缸驱动带有探针组件的长驱动杆, 其最快速度可在60 ms 时间内水平扫描8 cm 的距离。探针信号测量具有1MHz 的快速时间响应和0. 04 mm 的空间分辨率。可靠地测量了HL- 2A 装置边缘电子温度和密度的时空分布。     

Observations of Edge Plasma on HL-2A Tokamak

The edge plasma characteristics are studied by a movable array of Mach/Reynolds stress/Langmuir 10-probes and fast reciprocating 4-probes in the boundary region. These probes can measure edge plasma temperature, density, poloidal electric field, radial electric field, Reynolds stress, poloidal rotation velocities and their profiles obtained by changing the radial positions of the probe array in different discharges. Measurement resuits are used to analyze plasma confinement, turbulent fluctuations and their correlation. The fixed flush 3-probe arrays are mounted on the 4-divertor neutralization plates at the same toroidal cross-section in divertor chamber. These probes are used to measure the profiles of the electron temperature, density and float potential in divertor chamber.     

Analyses of edge plasma characteristics in HL-2A

The edge plasma characteristics are studied by both a movable array of Mach/Reynolds stress/Langmuir 10-probes in the boundary region and the fixed flush probe arrays on the 4 divertor neutralization plates at the same toroidal cross-section in the HL-2A tokamak. The dependence of the Reynolds stress on poloidal flow in the edge plasma is analysed. The result indicates that the sheared poloidal flow in tokamak plasma can be induced by the radial gradient of Reynolds stress. In the divertor experiments of HL-2A, the profiles of the electron temperature, density and floating potential on divertor plates are measured by the flush probe arrays. The edge electron temperature in divertor configuration is higher than that in limiter configuration. The temperature asymmetry between outer and inner target plates is observed. The result of magnetic surface reconstructed from 18 Mirnov coils signals is presented. Both the particle recycling and the impurity flux in the bulk plasma during divertor discharges are discussed. Neutral gas pressure in divertor chamber, measured by fast ionization gauge during divertor discharge, is given.     

层流氩等离子体射流温度的测量

 采用给水冷管状静电探针施加负偏置电压、并使探针以一定速度垂直于射流轴线扫过层流氩等离子体射流的方法,测量探针所收集到的累积离子饱和电流随侧向位置的变化,利用Abel变换推导出了局部离子饱和电流密度沿射流径向的分布;采用自制的水冷动压探针,以动态扫描法测量了射流动压沿射流径向的分布;根据局部离子饱和电流密度和射流动压的测量数据,由理论关系式推导出了等离子体射流横截面上的温度分布,同时,采用谱线相对强度法测量了等离子体射流的激发温度。结果表明：两种方法得到的等离子体射流中心温度吻合较好,所得到的射流中心温度随弧电流加大而增大的变化趋势也一致。     

Edge Particle Flux with Temperature Fluctuation in the HL-2A Tokamak

Electron temperature, density, plasma potential and their fluctuation profiles at edge plasmas are measured simultaneously with a reciprocating probe system in HL-2A. The analysis results of four-tip data indicate that the temperature fluctuation has relative amplitude of 10-15%, gives more contribution to particle flux in lower （0- 25 kHz） and higher frequency （50-250 kHz） ranges. The coherence between temperature fluctuations and density or potential fluctuations implies that their coupling will impact anomalous transport. The measured diffusion coefficient is about three times of the Bohm diffusion coefficient when considering the temperature fluctuation. The particle flux with temperature fluctuation is discussed in HL-2A for the first time.     

Relaxation phenomena induced by edge biasing experiments in the CASTOR tokamak

In this paper we present the first experimental results obtained in the CASTOR tokamak by using a segmented biasing electrode, which is composed of five segments radially separated by 3 mm. The basic idea of choosing such configuration was to allow a spatial distribution of the biasing voltage in the radial direction. In the described experiments, one or more selected segments can be biased up to +300V, while the remaining segments can be either grounded or floating. Two rake probes measure the edge radial profiles of the floating potential and the ion saturation current at the top and low field side of the torus. A Gundestrup probe, located at the top of the torus, measures the parallel and perpendicular Mach numbers together with the local electron temperature and density. A clear and reproducible transition to a regime with improved particle confinement is routinely observed, if the electrode is inserted deep enough into the plasma (r/a ≈ 0.5) and if one or two segments are biased up to +250V (the remaining segments are floating). The steepening of the radial profiles of the plasma density and potential demonstrate the formation of a transport barrier just inside the last closed flux surface. Fast relaxations of the edge profiles, with a frequency of about 10 kHz or higher, are observed when the value of the average radial electric field within the barrier reaches values of about 20 kV/m and the density gradient increases up to a factor 3 with respect to the ohmic phase. A detailed analysis of the spatial-temporal behavior of these relaxations is presented. Presented at the Workshop “Electric Fields, Structures and Relaxation in Edge Plasmas”, Tarragona, Spain, July 3–4, 2005.     

金刚石膜合成条件下的鞘层与等离子体参数分布

本文报导了在用热阴极直流放电等离子体化学气相沉积（通常也称ＥＡＣＶＤ．即电子辅助化学气相沉积）方法合成金刚石的条件下的等离子体密度、电子温度、等离子体空间电位分布及基片附近等离子体鞘结构，并讨论其对成膜的影响．