Wavelength-tunable, passively mode-locked fiber laser based on graphene and chirped fiber Bragg grating

We demonstrate a wavelength-tunable, passively mode-locked erbium-doped fiber laser based on graphene and chirped fiber Bragg grating. The saturable absorber used to enable passive mode-locking in the fiber laser is a section of microfiber covered by graphene film, which allows light-graphene interaction via the evanescent field of the microfiber. The wavelength of the laser can be continuously tuned by adjusting the chirped fiber Bragg grating, while maintaining mode-locking stability. Such a system has high potential in tuning the mode-locked laser pulses across a wide wavelength range.     

Tunable Bragg gratings for fiber lasers

A tuning method of a fiber Bragg grating by the bending compression-tension is considered. With this method, a relative tuning range of the resonance wavelength of the grating of about 5% has been obtained. The changes in the shape of the spectrum and in the grating reflectivity during the tuning process are studied. The reflectivity of the fiber Bragg grating has been found to considerably increase with increasing degree of compression. It is shown that such an increase is caused by compression-induced changes in the refractive index modulation amplitude in the grating. The fiber Bragg grating developed has been applied for tuning the radiation wavelength of an ytterbium fiber laser. The tuning range of the laser has been found to be 45 nm around the central wavelength 1080 nm.     

Multi-point, fiber-optic gas detection with intra-cavity spectroscopy

A novel intra-cavity fiber laser system is demonstrated for multi-point gas detection. The laser uses fiber Bragg gratings as wavelength-selective cavity mirrors and a tunable filter to tune the operating wavelength to the Bragg wavelength of a selected Bragg grating. The Bragg wavelengths of the gratings are chosen to be aligned to different absorption lines of a gas or gases, allowing gas concentrations at multiple locations to be determined.     

基于级联光纤Bragg光栅的外腔半导体激光器三波长同时激射

实现了使用3个级联的光纤Bragg光栅外腔半导体激光器3波长同时激射.3条谱线的峰值波长取决于光纤Bragg光栅的峰值反射波长,分别为1 531.5 nm、1 549.4 nm与1 554.8 nm.注入电流为52 mA时,激光器总输出功率为1 mW.该激光器的主要优点包括,由于输出波长被锁定在光纤Bragg光栅的Bragg波长上,因此输出波长稳定,谱线窄,成本低.可应用于多波长干涉测量以及全光通信等领域中.     

Continuously spacing-tunable multiwavelength semiconductor-optical-amplifier-based fiber ring laser incorporating a superimposed chirped fiber Bragg grating

We investigate a flexibly tunable multiwavelength semiconductor-optical-amplifier-based fiber ring laser with continuous wavelength spacing controllability incorporating a superimposed chirped fiber Bragg grating (CFBG). The wavelength spacing of a superimposed CFBG can be continuously controlled by symmetrically modifying the chirp bandwidth of the grating with the specially designed apparatus. We achieve a wide and continuous tuning range of the wavelength spacing from 0.35 to 0.78 nm. The continuous tunability of the wavelength spacing is measured to be ~ +/-0.033 nm/mm. By controlling the reflection bandwidth of the tunable CFBG, we can independently adjust the number of lasing channels from 2 to 23 at the wavelength spacing of 0.51 nm.     

Dynamic strain monitoring by wavelength locking between two fiber Bragg gratings fiber sensing system

We demonstrated a fiber sensing system using the method of wavelength locking of two identical fibers Bragg gratings (FBG) to interrogate the wavelength shift by directly measuring the intensity of the reflection from the sensing Bragg grating. The light source of the fiber sensing system is an EDFA fiber ring laser pumped by a 980 nm laser diode and a narrow bandwidth fiber Bragg grating for the filter of the ring laser resonator. The wavelength shift is converted to the intensity deviation of the reflection from the sensing FBG under strain variation, and is able to achieve real-time sensing of the dynamic strain sensing in civil engineering. The characteristics and key factors to maintain stability of the dynamic strain sensing system are discussed.     

Tunable multi-wavelength combined linear-cavity fiber laser source with equally changed wavelength spacing

A tunable multi-wavelength combined linear-cavity fiber laser source with equally changed wavelength spacing is proposed for the first time. The wavelength tuning is realized by stretching or compressing the fiber Bragg gratings incorporated in the laser cavity. To ensure a wavelength tuning with equally increased or decreased wavelength spacing, the gratings are mounted onto a plastic plate with angles between adjacent gratings such that the forces applied to the gratings has an equal force increment. A four-wavelength lasing with equal increased or decreased wavelength spacing is achieved experimentally.     

Single-mode fiber laser based on core-cladding mode conversion

A single-mode fiber laser based on an intracavity core-cladding mode conversion is demonstrated. The fiber laser consists of an Er-doped active fiber and two fiber Bragg gratings. One Bragg grating is a core-cladding mode converter, and the other Bragg grating is a narrowband high reflector that selects the lasing wavelength. Coupling a single core mode and a single cladding mode by the grating mode converter, the laser operates as a hybrid single-mode laser. This approach for designing a laser cavity provides a much larger mode area than conventional large-mode-area step-index fibers.     

Fiber laser with combined feedback of core and cladding modes assisted by an intracavity long-period grating

We present a fiber laser made in a single piece of conventional doped-core fiber that operates by combined feedback of the fundamental core mode LP((0,1)) and the high-order cladding mode LP((0,10)). The laser is an all-fiber structure that uses two fiber Bragg gratings and a long-period grating to select the modes circulating in the cavity; the laser emits at the coupling wavelength between the core mode LP((0,1)) and the counterpropagating cladding mode LP((0,10)) in the Bragg gratings. This work demonstrates the feasibility of high-order mode fiber lasers assisted by long-period gratings.     

Apodised fiber Bragg gratings fabricated with a uniform phase mask using Gaussian beam laser

A new exposure scheme for fabricating apodised fiber Bragg gratings by the use of a uniform phase mask and a Gaussian beam laser is demonstrated. Average refractive index is kept nearly constant along the grating to derive a side lobe suppression of 20 dB in the shorter wavelength. This scheme allows the writing of truly apodized fiber Bragg gratings.     

Wavelength-spacing tunable multiwavelength erbium-doped fiber laser based on four-wave mixing of dispersion-shifted fiber

We experimentally demonstrate a wavelength-spacing tunable multiwavelength erbium-doped fiber laser based on degenerate four-wave mixing in a dispersion-shifted fiber incorporating multiple-fiber Bragg gratings. We have achieved stable operation of the multiwavelength erbium-doped fiber laser, which has 0.8 nm spacing ten-channel lasing wavelengths and a high extinction ratio of more than approximately 45 dB, at room temperature. The output power of the multiwavelength erbium-doped fiber laser is stable, so the peak fluctuation is less than approximately 0.2 dB. By changing the properties such as loss and polarization state of multiple fiber Bragg grating cavities, we can exercise flexible control of the wavelength spacing of the multiwavelength output. We can also obtain switchable multiwavelength lasing operation by elimination of the effects of alternate single-fiber Bragg gratings.     

Highly efficient tunable fiber Bragg grating filters using multilayer piezoelectric transducers

We realized a wavelength tunable optical filter based on a fiber Bragg grating using multilayer piezoelectric transducers (MLP). The Bragg wavelength of the filter can be easily tuned in proportion to an applied low DC voltage. The tuning range efficiency was as high as 0.2 nm/V. We realized a 10 nm Bragg wavelength shift by applying as low as 50 V to the MLP. The MLP was also used in a higher order dispersion equalizer which consists of a pair of nonlinearly chirped gratings. A zero dispersion wavelength shift of 7 nm was successfully realized for the equalizer.     

Investigation of a multiwavelength raman fiber laser based on few-mode fiber Bragg gratings

We propose and experimentally demonstrate a simple multiwavelength Raman fiber laser based on few-mode fiber Bragg gratings without additional multichannel filters. The multiwavelength Raman laser output has a high extinction ratio of more than 45 dB. The multiwavelength output is so stable that the peak power fluctuation is less than 0.5 dB. The number of lasing wavelengths can be adjusted, corresponding to the properties of few-mode Bragg gratings with multiple resonant wavelengths. By the thermal tuning method, the lasing wavelength of each channel can be effectively controlled, and the laser's tunability is measured to be 10.5 pm/ degrees C.     

Highly reliable strain-tuning of an Erbium-doped fiber laser for the interrogation of multiplexed Bragg grating sensors

The authors implemented a tunable linear cavity Erbium-doped fiber (EDF) laser for the interrogation of multiplexed fiber Bragg grating sensors (BGS). A high-strength single-pulse draw-tower fiber Bragg grating (FBG) was used as the mechanically tunable element enabling the rapid wavelength sweeping of the laser center wavelength. A simple algorithm to process the noisy acquired data and identify the peak of the BGS spectra was employed. For the first time, this type of configuration was used to reliably interrogate at least three fiber Bragg grating sensors with a standard wavelength spacing between the Bragg wavelengths of 3 nm, without risk of breaking the stretched fiber, using an FBG with a simple PZT driven mount as the tuning elements.     

The ultra narrow-band fiber grating filter

In this paper, we propose an ultra narrow band fiber grating filter which is composed of two optical circulators and two fiber Bragg gratings (FBG). Through numerical simulation and experiment investigation, a narrow-band output spectrum with 1064 nm center wavelength and 0.017 nm bandwidth is obtained. It may find a certain application in the fields of free space optic communication, laser tuning and so on as we believe.     

Tunable fiber Bragg gratings for application in tunable fiber lasers

The resonance wavelength of the fiber Bragg gratings (FBGs) is tuned using two methods. Tunable FBGs are used as the selecting elements in the cavities of tunable lasers. An ytterbium-doped fiber laser with a wavelength tuning range of 1063–1108 nm and an output power of 6 W, a Raman fiber laser with a wavelength tuning range of 1252–1303 nm and an output power of 3 W, and an erbium-doped fiber laser with a wavelength tuning range of 1530–1580 nm are realized, and their characteristics are studied.     

Multi-Wavelength-Switchable Double Clad Yb3+-Doped Fiber Laser Based on Reflectivity Control of Fiber Bragg Gratings by Induced Bend Loss

We propose and demonstrate an all-fiber multi-wavelength switchable double-clad Yb³⁺-doped fiber laser based on the reflectivity cavity control by induced bend loss. The wavelength switching is realized by a variable reflecting mirror that employs a cascaded array of three high reflection (>99%) fiber Bragg gratings at 1064, 1080 and 1096 nm, with a bending controller inserted between each grating. The order of the Bragg gratings is decided according to the gain profile of the Yb³⁺-doped fiber and the induced bending loss allows us to select the Bragg-wavelength laser operation. The laser is capable of switching continuously from one wavelength to another, and slope efficiencies over 50% are obtained at each wavelength.     

一种新型的光纤光栅封装装置

介绍了一种新型剪刀形封装装置,并利用其进行了光纤布拉格光栅的温度补偿实验.这种封装结构保持了光纤光栅体积小的优点,同时无需给光纤光栅施加预应力;封装后不产生啁啾,并可与压电陶瓷结合,扩展光纤光栅布喇格波长的调谐范围;应变量的调节只跟金属丝有关,与支架的材料无关,从而大大简化了设计.在－30℃~80℃温区,温度灵敏度降低10倍以上,达到0.001 nm/℃,符合光纤通信要求.     

Interrogation unit for fiber Bragg grating sensors that uses a slanted fiber grating

A novel interrogation technique for fiber Bragg gratings is presented. It is based on measuring the characteristics of the outgoing near-field radiation from a tilted fiber grating. This scheme was experimentally checked and was found to offer a wide wavelength interrogation range as well as a good linearity, stability, and wavelength resolution.     

基于悬臂梁的光纤光栅线性调谐器研究

分析了基于悬臂梁的光纤光栅线性调谐的基本原理及调谐公式,指出了调谐范围、调谐灵敏度和反射波谱展宽与悬臂梁结构的关系,并提出了优化方案.实验中选用适当尺寸的悬臂梁,对粘贴其上的光纤光栅的反射波长实现了线性调谐,并可对调谐范围、灵敏度等指标进行灵活控制.