基于删失数据的ARMA模型参数估计与实证分析

利用生存分析中的K-M估计得到了删失数据下ARMA模型的参数估计,通过与完全数据下的参数估计进行对比,充分说明了该估计的效果.利用删失数据下ARMA模型的EM算法,对2013年5月2日到2014年5月8日的247个美元兑人民币的基准汇率数据进行建模分析和预测,并与实际数据进行对照,误差较小,说明估计和EM预测方法的可行性.     

无失效数据的Bayes和多层Bayes分析

本文推广了文献[6]的结果，对指数分布无失效数据的失效率，给出了Bayes估计、Bayes置信上限以及多层Bayes估计，从而可以得到无失效数据可靠度的估计，最后，结合实际问题进行了计算。     

无失效数据情形失效率的综合估计

对指数分布的无失效数据，提出了无失效数据情形失效率的综合估计法。在失效率的先验分布为截尾Gamma分布时，给出了失效率的多层Bayes估计。在引进失效信息后，在失效率的先验分布为截尾Gamma分布时，给出了失效率的多层Bayes估计和综合估计，并给出了可靠度的综合估计，结合实际问题进行了计算。     

基于最优估计的数据融合理论

本文提出了一种最优加权的数据融合方法，分析了最优权值的分配原则；给出了多源信息统一的线性融合模型，使其表示不受数据类型和融合系统结构的限制，并指出在噪声协方差阵正定的前提下，线性最小方差估计融合和加权最小二乘估计融合是等价的；介绍了数据融合中的Bayes极大后验估计融合方法，给出了利用极大后验法进行传感器数据融合的一般表示公式；最后以两传感器数据融合为例，证明了利用Bayes极大后验估计进行两传感器数据融合所得到的融合状态的精度比相同条件下极大似然估计得到的精度要高，同时它们均优于任一单传感器局部估计精度。     

�������ݷDz���ģ�͵Ĺ⻬��������

??In the last few decades, longitudinal data was deeply research in statistics science and widely used in many field, such as finance, medical science, agriculture and so on. The characteristic of longitudinal data is that the values are independent from different samples but they are correlate from one sample. Many nonparametric estimation methods were applied into longitudinal data models with development of computer technology. Using Cholesky decomposition and Profile least squares estimation, we will propose a effective spline estimation method pointing at nonparametric model of longitudinal data with covariance matrix unknown in this paper. Finally, we point that the new proposed method is more superior than Naive spline estimation in the covariance matrix is unknown case by comparing the simulated results of one example.     

高维稳健主成分聚类方法及其应用研究

随着信息技术的高速发展,每条数据所包含的信息越来越丰富,使得数据不可避免地含有异常值,且随着维数的增加,异常值出现的可能性更大。传统的主成分聚类分析对异常值特別敏感,基于MCD估计的主成分聚类方法虽然对异常值具有防御作用,但是在高维数据下MCD估计的偏差过大,其稳健性显著降低,而且当维数大于观测值个数时MCD估计失效。为此本文提出了基于MRCD估计的稳健主成分聚类方法,数值模拟和实证分析表明,基于MRCD估计的主成分聚类分析的效果优于传统的主成分聚类分析和基于MCD估计的主成分聚类分析,尤其是在维数大于样本观测值的情况下,MRCD估计更为有效。     

纵向数据下半参数联合均值协方差模型的贝叶斯分析

基于改进的Cholesky分解,研究分析了纵向数据下半参数联合均值协方差模型的贝叶斯估计和贝叶斯统计诊断,其中非参数部分采用B样条逼近.主要通过应用Gibbs抽样和Metropolis-Hastings算法相结合的混合算法获得模型中未知参数的贝叶斯估计和贝叶斯数据删除影响诊断统计量.并利用诊断统计量的大小来识别数据的异常点.模拟研究和实例分析都表明提出的贝叶斯估计和诊断方法是可行有效的.     

时空模型的局部众数回归

时空数据经常含有奇异点或来自重尾分布,此时基于最小二乘的估计方法效果欠佳,需要更稳健的估计方法.本文提出时空模型的基于局部众数(local modal, LM)的局部线性估计方法.理论和数据分析结果都显示,若数据含有奇异点或来自重尾分布,基于局部众数的局部线性方法比基于最小二乘的局部线性方法有效;若数据无奇异点且来自正态分布,两种方法效率渐近一致.本文采用众数期望最大化(modal expectation-maximization, MEM)算法,并在数据相依情形下得出估计量的渐近正态性.     

失效率的E-Bayes估计和多层Bayes估计

提出了一种可靠性参数的估计方法—E-Bayes估计法,对寿命服从指数分布的产品,在无失效数据情形,给出了失效率的E-Bayes估计的定义、E-Bayes估计和多层Bayes估计,并在此基础上给出了E-Bayes估计的性质.最后,结合发动机的实际问题进行了计算,结果表明E-Bayes估计法可行且便于应用.     

LAD estimation for nonlinear regression models with randomly censored data

The least absolute deviations (LAD) estimation for nonlinear regression models with randomly censored data is studied and the asymptotic properties of LAD estimators such as consistency, boundedness in probability and asymptotic normality are established. Simulation results show that for the problems with censored data, LAD estimation performs much more robustly than the least squares estimation.     

Manufacturing lead time estimation using data mining

We explore use of data mining for lead time estimation in make-to-order manufacturing. The regression tree approach is chosen as the specific data mining method. Training and test data are generated from variations of a job shop simulation model. Starting with a large set of job and shop attributes, a reasonably small subset is selected based on their contribution to estimation performance. Data mining with the selected attributes is compared with linear regression and three other lead time estimation methods from the literature. Empirical results indicate that our data mining approach coupled with the attribute selection scheme outperforms these methods.     

右删失时间序列AR模型参数估计

通过Kaplan-Meier估计和Nelson-Aalen估计得到了平稳时间序列被另一平稳序列右删失下.AR模型的参数估计.首先,通过与完全数据下的参数估计进行对比,说明了两种估计方法的效果.然后,根据计算机模拟的样本量以及删失率的不同,对比了两种估计的优劣,并且模拟结果表明两种估计是有效的.     

失效率的综合E-Bayes估计

该文提出了可靠性参数的一种新估计方法综合E-Bayes估计法.在无失效数据情形下给出了失效率的E-Bayes估计的定义,并给出了失效率的E-Bayes估计。在引进失效信息后，给出了失效率的E-Bayes估计，并在此基础上给出了失效率和其它参数的综合E-Bayes估计。最后，结合实际问题进行计算，结果表明该文提出的方法可行且便于应用。     

Non-linear model parameter estimation–estimating a feasible parameter set with respect to model use

This article deals with non-linear model parameter estimation from experimental data. As for non-linear models a rigorous identifiability analysis is difficult to perform, parameter estimation is performed in such a way that uncertainty in the estimated parameter values is represented by the range of model use results when the model is used for a certain purpose. Using this approach, the article presents a simulation study where the objective is to discover whether the estimation of model parameters can be improved, so that a small enough range of model use results is obtained. The results of the study indicate that from plant measurements available for the estimation of model parameters, it is possible to extract data that are important for the estimation of model parameters relative to a certain model use. If these data are improved by a proper measurement campaign (e.g. proper choice of measured variables, better accuracy, higher measurement frequency) it is to be expected that a valid model for a certain model use will be obtained. The simulation study is performed for an activated sludge model from wastewater treatment, while the estimation of model parameters is done by Monte Carlo simulation.     

失效概率的E-Bayes估计及其性质

该文提出了参数的一种新估计方法----- E-Bayes估计法. 在无失效数据情形, 给出了失效概率的E-Bayes估计的定义,在此基础上给出了失效概率的E-Bayes估计, 并给出了失效概率的E-Bayes估计的性质----- E-Bayes估计和多层Bayes估计的关系.最后, 给出了模拟算例, 结果表明该文提出的E-Bayes估计法可行且便于应用.     

A random model approach for the LASSO

The least absolute selection and shrinkage operator (LASSO) is a method of estimation for linear models similar to ridge regression. It shrinks the effect estimates, potentially shrinking some to be identically zero. The amount of shrinkage is governed by a single parameter. Using a random model formulation of the LASSO, this parameter can be specified as the ratio of dispersion parameters. These parameters are estimated using an approximation to the marginal likelihood of the observed data. The observed score equations from the approximation are biased and hence are adjusted by subtracting an empirical estimate of the expected value. After estimation, the model effects can be tested (via simulation) as the distribution of the observed data given that all model effects are zero is known. Two related simulation studies are presented that show that dispersion parameter estimation results in effect estimates that are competitive with other estimation methods (including other LASSO methods).     

二项分布无失效数据的Bayes可靠性分析

本文对二项分布无失效数据，给出了Bayes估计、多层Bayes估计和Bayes置信下限，并对一些结果进行了比较。     

无失效数据情形可靠性参数的估计和调整

本文在无失效取样情形下,提出了产品可靠性参数的一种估计和调整的方法———加权多层Bayes估计法.在无失效数据情形下失效率的多层Bayes估计和引进失效信息后失效率的多层Bayes估计的基础上,对可靠性参数进行了估计和调整———给出了失效率和可靠度的加权多层Bayes估计.最后,结合发动机的实际问题进行了计算,结果表明本文提出的方法可行且便于应用.     

Estimation for incomplete manpower data

Much attention has been paid to both non-parametric and parametric estimation for survival data with right censoring, particularly in the medical literature. In manpower planning the completed length of service until leaving is of great interest, and here also the data are right censored since people are still in service when data collection ends. However, it often occurs that the data are also left truncated since people are already in service at the beginning of data collection. These people have often been neglected both in estimation of the empirical distribution function and also in fitting particular parametric distributions. However, it is important to include them so as to use all the data, particularly when data are only present for a short period. The methods developed were applied to data for the completed length of service of both skilled and unskilled workers where the data were collected over a period of years. Using modified Kaplan-Meier estimation, applied to these data sets, empirical distribution functions were obtained. A number of parametric distributions were also fitted. The goodness of fit of these distributions as predictors of leavers and stayers over a given period was then tested using a chi-squared test.     

Estimation of spatial autoregressive models with measurement error for large data sets

Maximum likelihood (ML) estimation of spatial autoregressive models for large spatial data sets is well established by making use of the commonly sparse nature of the contiguity matrix on which spatial dependence is built. Adding a measurement error that naturally separates the spatial process from the measurement error process are not well established in the literature, however, and ML estimation of such models to large data sets is challenging. Recently a reduced rank approach was suggested which re-expresses and approximates such a model as a spatial random effects model (SRE) in order to achieve fast fitting of large data sets by fitting the corresponding SRE. In this paper we propose a fast and exact method to accomplish ML estimation and restricted ML estimation of complexity of \(O(n^{3/2})\) operations when the contiguity matrix is based on a local neighbourhood. The methods are illustrated using the well known data set on house prices in Lucas County in Ohio.