共查询到20条相似文献,搜索用时 62 毫秒
1.
2.
影响金刚石合成的粉末触媒形态因素 总被引:2,自引:0,他引:2
采用相同成分体系的片状、球状Ni-Mn-Cu粉末触媒体为原料,在六面顶压机上进行人造金刚石高温、超高压合成的对比实验.结果表明:具有片状等不规则形状的NiMnCu粉末触媒合成工艺较球状同类粉末触媒合成工艺更稳定、易于掌握.针对上述结果,结合金刚石成核、生长过程中合成腔体内温度变化对上述实验结果进行了讨论. 相似文献
3.
采用片状铁基触媒借鉴粉末工艺合成金刚石 总被引:4,自引:0,他引:4
以单质金属粉为原料,采用粉末冶金方法制备了片状铁基触媒,并借鉴目前金刚石工业中最为常用的粉末触媒组装方式及合成工艺在高温高压下进行了金刚石合成试验.试验获得了粒径为300~500μm,具有六-八面体外形,形态完整,质量较高的立方金刚石单晶.检测发现,其主要性能指标均超过机械行业标准《人造金刚石技术条件》(JB/T7989-1997)对锯片级金刚石的技术要求,评级可在SMD30以上.同时,还具有较小的磁性和优于一般金刚石的热稳定性.试验验证了采用单质金属粉合成优质金刚石的可能性,有望进一步简化触媒制备工艺,降低金刚石的生产成本. 相似文献
4.
将静态超高压高温合成的人造金刚石晶粒利用RTO包埋法制备成适合TEM观察的样品,发现这些金刚石晶粒是由多根细长的纳米多晶棒沿一定取向规则地以捆束状堆叠、聚集而成,而这些纳米多晶棒之间填充了无定型碳.也就是说,人造金刚石晶粒是由结晶碳素和无定型碳组成的.由此,提出并绘制了人造金刚石晶粒的微观结构模型示意图,可用于解释人造金刚石的各向异性及其他宏观性能特征.在以上结论的基础上,笔者认为业界经常提及的“单晶”金刚石称谓可能并不严谨,可能并不是纯粹由结晶金刚石材料组成. 相似文献
5.
6.
7.
8.
9.
10.
利用FeNiMn55#粉末触媒在国产六面顶压机上进行工业金刚石单晶的合成,研究高温高压条件下(5.7 Gpa,1400~1600 ℃),C-FeNiMn55#粉末触媒体系中金刚石单晶的生长特性.结果表明,C-FeNiMn55#系能够合成出六-八面体及八面体金刚石,但六面体金刚石生长区间较窄,不易生长.通过光学显微镜观测表明,合成出的金刚石单晶呈黄色,晶形完整,晶体内部有气泡产生.M(o)ssbauer测试结果表明金刚石中包裹体的主要成分为Fe3C和FeNiMn55#合金. 相似文献
11.
12.
本文采用坩埚下降法,在真空密封的石英坩埚中成功生长出CsI-LiCl与CsI-LiCl:Na共晶闪烁体。通过扫描电子显微镜(SEM)观察晶体微结构表明该共晶中LiCl相与CsI相存在周期性的层状排列,CsI相的厚度在5 μm左右。共晶样品的X射线激发发射谱显示在CsI-LiCl和CsI-LiCl:Na共晶样品存在缺陷发光,在CsI-LiCl样品中还观察到了纯CsI的自陷激子(STE)发光。CsI-LiCl样品在α粒子激发下的多道能谱中观察到明显的全能峰,这一结果证明CsI-LiCl共晶可用于热中子探测的潜力。 相似文献
13.
以聚丙烯腈(PAN)为载体,六水合硝酸铈[Ce(NO3)3·6H2O]为原料,采用静电纺丝法制备了Ce(NO3)3/PAN纤维,在空气中热处理得到CeO2微纳米纤维,通过XRD、BET和SEM对CeO2微纳米纤维进行表征。采用静态吸附实验探讨了CeO2微纳米纤维去除水溶液中氟离子的性能,考察了溶液pH值、初始氟离子浓度及共存阴离子等对吸附性能的影响。结果表明,pH=3时,CeO2微纳米纤维对F-的吸附性能最佳,CeO2吸附量随着F-浓度的增大呈上升趋势。CeO2微纳米纤维对F-的吸附等温线遵循Langmuir模型,二级动力学模型能很好地描述CeO2微纳米纤维对F-的吸附过程。CeO2微纳米纤维的除氟性能优良,可为其实际应用提供理论参考。 相似文献
14.
Tosha Barclay Wallace Cordes Fu-May Yang Shaw-Tao Lin 《Journal of chemical crystallography》1998,28(3):171-175
Both the cis and trans isomers of 3,11,18,26-tetrathiatricyclo[26.2.2.15,9.213,16.120,24] hexatriaconta-5,7,9,20,22,24-hexene have been prepared and structurally characterized. Each of these centrosymmetric tetrathia dimers includes two cyclohexane rings in chair conformations with either 1,4-cis or 1,4-trans bonding and two meta-substituted benzene rings. The cis isomer packs into the monoclinic space group P21/a with a = 10.485(3)Å, b = 10.3956(18)Å, c = 14.1343(10)Å, = 105.200(13)°, Z = 2 and refined to an R factor of 0.046. The trans isomer crystallizes in the monoclinic space group P21/c with a = 10.7217(12)Å, b = 5.6797(7)Å, c = 25.415(5)Å, = 96.001(12)°, Z = 2 and refined to an R factor of 0.043. In the cis structure each benzene ring faces a cyclohexane ring while in the trans structure the cyclohexane rings face one another. 相似文献
15.
We perform first-principles coexistence simulations of the low-density and the high-density phases of supercooled liquid silicon and find a negative slope for the coexisting line in the temperature-pressure plane. Electron density maps and electron-localization function plots of the two phases of silicon show marked differences. The calculated differences suggest more localized electrons in the low-density liquid compared to the high-density liquid, coming from an increased population of covalent bonds, which further explain the calculated negative slope in the two phase coexistence regime. This is consistent with the presence of a pseudo-gap in low-density liquid silicon, absent in the high-density liquid which shows a metallic behavior. 相似文献
16.
本文以掺F的SnO2导电玻璃为基板,以硝酸锌水溶液为电解液,采用三电极恒电位体系电沉积制备ZnO纳米棒阵列,系统考察了硝酸锌浓度和沉积电位等工艺参数对ZnO纳米棒阵列的微观形貌及其发光性能的影响规律.结果表明,硝酸锌浓度和沉积电位对纳米棒阵列的形貌有显著影响,控制适宜的工艺条件可以制备出直径分布均匀、结晶性好且纯度高的六方纤锌矿ZnO纳米棒阵列.荧光光谱分析表明,电沉积制备出的ZnO纳米棒阵列在385 nm附近有一个强荧光发射峰,且发光性能稳定、对纳米棒阵列微观形貌的细微变化不敏感,使其在发光二极管和激光器等领域具有广阔的应用前景. 相似文献
17.
A. L. Bingham J. E. Drake C. Gurnani M. B. Hursthouse M. E. Light M. Nirwan R. Ratnani 《Journal of chemical crystallography》2006,36(10):627-630
Triethyl ammonium Salt of O,O′-bis(p-tolyl)dithiophosphate and O,O′-bis(m-tolyl)dithiophosphate have been obtained by reaction of p- and m-cresol, respectively with P2S5 in toluene and have been characterized by elemental analysis, IR, 1H and 31P NMR spectroscopy. The molecular structure of O,O′-bis(p-tolyl)dithiophosphate has been determined. Crystal data: [Et3NH]+[(4-MeC6H4O)2PS2]−: Monoclinic, P21/c, a=15.2441(9) ?, b=10.415(2) ?, c=3.9726(9) ?, β=91.709(7)°, V=2217.5(1) ?−3, Z=4.Supplementary materials Additional material available from the Cambridge Crystallographic Data Centre (CCDC no. 600927 for [Et3NH]+[(4-MeC6H4O)2PS2]− comprises the final atomic coordinates for all atoms, thermal parameters, and a complete listing of bond distances and angles. Copies of this information may be obtained free of charge on application to The Director, 12 Union Road, Cambridge CB2 2EZ, UK (fax: +44-1223-336033; email: deposit@ccdc.cam.ac.uk or www:http://www.ccdc.cam.ac.uk). 相似文献
18.
Tosha Barclay Wallace Cordes Fu-May Yang Shaw-Tao Lin 《Journal of chemical crystallography》1997,27(6):359-362
Structures of both thecis andtrans isomers of dithiahexahydro[3.3]metacyclophane, ?C6H4?CH2SCH2?C6H10?CH2SCH2?, have been determined, wherecis andtrans refer to the attachments to the cyclohexane ring. Thecis form crystallizes in the monoclinic space groupP21/c witha=8.4299(11)Å,b=21.772(2)Å,c=8.9724(13)Å, β=116.574(11)o, andZ=4. Thetrans isomer packs into the monoclinic space groupP21 witha=8.159(16)Å,b=10.185(5)Å,c=9.558(2)Å, β=112.435(18)o, andZ=2. The cyclohexane ring of thecis isomer is in the chair conformation, while the cyclohexane of thetrans isomer is found in a twisted boat conformation. 相似文献
19.
以表面活性剂CTAB和SDBS为化学添加剂,采用化学共沉淀法对碳酸锶晶体的生长形态进行调控,成功地制备出了实心的树枝状和花瓣为空心的花状碳酸锶粉体,并用X射线衍射(XRD)、扫描电子显微镜(SEM)和傅里叶变换红外光谱(FT-IR)等分析手段对样品进行了表征;最后重点对化学添加剂可能产生的影响机理进行了初步的探讨.结果表明,CTAB和SDBS在晶体生长的过程中能起到显著的影响作用,两者对粒子分散性能的作用效果相反,而且后者对晶体(013)和(213)晶面表面能降低的贡献明显大于前者. 相似文献
20.
F. Roussel U. Maschke J.-M. Buisine X. Coqueret F. Benmouna 《Molecular Crystals and Liquid Crystals》2013,570(1):685-693
Abstract Equilibrium phase diagrams of uncured and UV-cured difunctional hexanedioldiacrylate and the eutectic mixture of low molecular weight liquid crystals E7 are established by polarized optical microscopy and differential scanning calorimetry. Data are analyzed using the Maier-Saupe model of nematic order. In the case of the uncured system the Flory-Huggins free energy of isotropic mixing is applied while for the cured system, the Flory-Rehner elastic free energy model is used. A good correlation between experimental and theoretical phase diagrams is found in both systems. 相似文献