Quantum correlations in dual quantum measurements

 We analyze the quantum measurement properties of dual non-degenerate parametric amplifers in the twin-beam configuration, in the cascaded back-action-evasion configuration, and in Kerr-type photon-number quantum non-demolition measurements. It is found that Einstein-Podolsky-Rosen correlations can be obtained between the quadrature components of an idler mode and the sum of the readout of two signal modes. Furthermore, we discuss dual-mode quantum non-demolition measurements on the combination of two light modes, and the generation of number-state entanglement. Received: 12 April 1996/Revised version: 2 July 1996     

Picosecond near- to mid-infrared optical parametric oscillator using KTiOAsO4

The operation and characterization of a high-repetition-rate singly-resonant picosecond optical parametric oscillator based on the non-linear material KTiOAsO4 and synchronously pumped by a Kerr-lens-mode-locked Ti:sapphire laser at 81 MHz is described. By utilizing non-critical type II phase-matching in a 10 mm crystal, average near-infrared output powers of 403 mW have been generated at 31% extraction efficiency. The oscillator exhibits a pump power threshold of 230 mW and with the available mirror set can provide signal tuning over 1.116–1.281 μm and idler tuning over 2.260–3.160 μm by tuning the pump wavelength over 770–896 nm. Without dispersion compensation, near-transform-limited signal pulses with durations of 1.01–1.03 ps and idler pulses with 1.61–2.91 ps duration have been obtained for 1.2 ps input pump pulses. This revised version was published online in November 2006 with corrections to the Cover Date.     

Phase-matched self-doubling optical parametric oscillator

We report a synchronously pumped intracavity frequency-doubled optical parametric oscillator that employs a single KTiOPO(4) crystal for both parametric generation and frequency doubling. Both nonlinear processes are phase matched for the same direction of propagation in the crystal. The parametric oscillator, pumped by a femtosecond Ti:sapphire laser at a wavelength of 745 nm, generates a green output beam at 540 nm with a 29% power conversion efficiency. Angle tuning in conjunction with pump wavelength tuning provides output tunability in the 530-585-nm range.     

Femtosecond optical parametric oscillator based on periodically poled KTiOPO(4)

We report a femtosecond optical parametric oscillator based on a periodically poled KTiOPO(4) crystal for which quasi-phase matching is achieved with a 24-microm poling period. The singly resonant parametric oscillator, synchronously pumped by a Ti:sapphire laser at a wavelength of 758 nm, generates a signal at 1200 nm and an idler at 2060 nm. The maximum signal power conversion efficiency of the device is 22% with a pump depletion of 69%. We tune the signal wavelength over a 200-nm band by changing the cavity length. In addition, pump wavelength tuning provides output tunability in the 1000-1235-nm range.     

Continuous-wave, singly resonant, intracavity parametric oscillator

Performance characteristics of a continuous-wave intracavity optical parametric oscillator are described by use of an experimental arrangement comprising a KTP singly resonant oscillator located within a Ti:sapphire laser cavity and analyzed by use of a steady-state model. Internal and external powers, circulating fields, tuning ranges, spectral bandwidths, and amplitude-stability levels are measured and discussed. The nonresonant idler tunes from 2.53 to 2.87 microm, delivers a maximum output power of approximately 0.4W and displays long-term amplitude-stable operation. The total downconverted power approaches the optimum power coupled out of the Ti:sapphire laser in the absence of frequency conversion.     

PUMP-TUNING KTP OPTICAL PARAMETRIC OSCILLATOR WITH CONTINUOUS OUTPUT WAVELENGTH PUMPED BY A PULSED TUNABLE Ti:SAPPHIRE LASER

We report on the implementation of a KTP optical parametric oscillator pumped by a pulsed tunable Ti:sapphire laser. Two major improvements were achieved, including the connection of the signal and idler tuning ranges and the high-output conversion efficiency through the signal and idler tuning ranges. Both in the signal and idler, the continuous output wavelength from 1.261 to 2.532μm was obtained by varying the pump wavelength from 0.7 to 0.98μm. The maximum output pulse energy was 27.2mJ and the maximum conversion efficiency was 35.7% at 1.311μm (signal).     

Observation of quantum jumps in a superconducting artificial atom

We continuously measure the state of a superconducting quantum bit coupled to a microwave readout cavity by using a fast, ultralow-noise parametric amplifier. This arrangement allows us to observe quantum jumps between the qubit states in real time, and should enable quantum error correction and feedback--essential components of quantum information processing.     

Continuous-wave singly resonant optical parametric oscillator based on periodically poled RbTiOAsO(4)

We report a continuous-wave optical parametric oscillator (OPO) based on periodically poled RbTiOAsO(4) (PPRTA). The singly resonant OPO, which is located within a Ti:sapphire laser, has a high-finesse signal cavity and delivers a maximum output power of 270 mW to the nonresonant idler wave at 2.92mum , through a 4.5-mm PPRTA crystal. For room-temperature operation and a crystal with a 30-mu;m grating period, pump tuning over 838-848 nm results in OPO tuning over 1.13-1.27mum (signal) and 2.53-3.26mum (idler), limited by the bandwidth of optical coatings. PPRTA exhibits thermal properties superior to those of periodically poled LiNbO(3) .     

Theoretical analysis of a quartz-enhanced photoacoustic spectroscopy sensor

Quartz-enhanced photoacoustic spectroscopy (QEPAS) sensors are based on a recent approach to photoacoustic detection which employs a quartz tuning fork as an acoustic transducer. These sensors enable detection of trace gases for air quality monitoring, industrial process control, and medical diagnostics. To detect a trace gas, modulated laser radiation is directed between the tines of a tuning fork. The optical energy absorbed by the gas results in a periodic thermal expansion which gives rise to a weak acoustic pressure wave. This pressure wave excites a resonant vibration of the tuning fork thereby generating an electrical signal via the piezoelectric effect. This paper describes a theoretical model of a QEPAS sensor. By deriving analytical solutions for the partial differential equations in the model, we obtain a formula for the piezoelectric current in terms of the optical, mechanical, and electrical parameters of the system. We use the model to calculate the optimal position of the laser beam with respect to the tuning fork and the phase of the piezoelectric current. We also show that a QEPAS transducer with a particular 32.8 kHz tuning fork is 2–3 times as sensitive as one with a 4.25 kHz tuning fork. These simulation results closely match experimental data.     

The scheme of QND meter of microwave quadrature amplitude

 We propose a new scheme of QND measurement in microwave band. It is shown that with deflection of electron beam in the electric field of a microwave resonator it is possible to measure quadrature amplitude of oscillations with the precision substantially exceeding the standard quantum limit. Estimates for the parameters of the experimental setup are presented. Received: 27 March 1996/Revised version: 5 August 1996     

Gas-phase photoacoustic sensor at 8.41 μm using quartz tuning forks and amplitude-modulated quantum cascade lasers

We demonstrate the performance of a novel infrared photoacoustic laser absorbance sensor for gas-phase species using an amplitude-modulated quantum cascade (QC) laser and a quartz tuning fork microphone. The photoacoustic signal was generated by focusing 5.3 mW of a Fabry–Pérot QC laser operating at 8.41 μm between the tines of a quartz tuning fork which served as a transducer for the transient acoustic pressure wave. The sensitivity of this sensor was calibrated using the infrared absorber Freon 134a by performing a simultaneous absorption measurement using a 31-cm absorption cell. The power and bandwidth normalized noise equivalent absorption sensitivity (NEAS) of this sensor was determined to be D=2.0×10^-8 W cm^-1/Hz^1/2. A corresponding theoretical analysis of the instrument sensitivity is presented and is capable of quantitatively reproducing the experimental NEAS, indicating that the fundamental sensitivity of this technique is limited by the noise floor of the tuning fork itself. PACS 43.60.Vx; 43.58.Wc; 43.58.Hp; 84.40.Xb     

Broadly tunable infrared femtosecond optical parametric oscillator based on periodically poled RbTiOAsO(4)

We present results from what we believe is the first reported example of an optical parametric oscillator based on periodically poled RbTiOAsO(4). The oscillator is pumped by a femtosecond self-mode-locked Ti:sapphire laser and, with a single-grating 2-mm-long crystal and one mirror set, a combination of pump and cavity-length tuning provided wavelength coverage from 1060 to 1225nm (signal) and 2.67 to 4.5 microm (idler). Average output powers were as much as 120mW in the signal and 105mW in the idler and interferometric autocorrelations recorded at signal and idler wavelengths of 1.1 and 3.26 microm, respectively, imply pulse durations of 125 and 115fs, respectively.     

Parametric instabilities and their control in advanced interferometer gravitational-wave detectors

A detailed simulation of Advanced LIGO test mass optical cavities shows that parametric instabilities will excite 7 acoustic modes in each fused silica test mass, with parametric gain R up to 7 and only 1 acoustic mode with R approximately 2 for alternative sapphire test masses. Fine-tuning of the test mass radii of curvature causes the instabilities to sweep through various modes with R as high as approximately 2000. Sapphire test mass cavities can be tuned to completely eliminate instabilities using thermal g-factor tuning. In the case of fused silica test mass, instabilities can be minimized but not eliminated.     

BiB3O6 femtosecond optical parametric oscillator

We report a femtosecond optical parametric oscillator (OPO) based on the nonlinear material BiB3O6. The OPO is synchronously pumped in the blue by the second harmonic of a Kerr-lens-mode-locked Ti:sapphire laser. It can provide wide and continuous tuning across the entire green-yellow-orange-red spectral range with a single crystal and a single set of mirrors. Using a 500 microm BiB3O6 crystal and collinear type I (e+e->o) phase matching in the optical yz plane, a signal wavelength range of 480-710 nm is demonstrated with angle tuning at room temperature at average output powers of 270 mW. With 220 fs blue pump pulses, near-transform-limited signal pulses of 120 fs duration have been obtained at 76 MHz repetition rate.     

Parametric amplification of few-cycle carrier-envelope phase-stable pulses at 2.1 microm

We demonstrate an optical parametric chirped-pulse amplifier producing infrared 20 fs (3-optical-cycle) pulses with a stable carrier-envelope phase. The amplifier is seeded with self-phase-stabilized pulses obtained by optical rectification of the output of an ultrabroadband Ti:sapphire oscillator. Energies of -80 microJ with a well-suppressed background of parametric superfluorescence and up to 400 microJ with a superfluorescence background are obtained from a two-stage parametric amplifier based on periodically poled LiNbO3 and LiTaO3 crystals. The parametric amplifier is pumped by an optically synchronized 1 kHz, 30 ps, 1053 nm Nd:YLF amplifier seeded by the same Ti:sapphire oscillator.     

Ti:sapphire second-harmonic-pumped visible range femtosecond optical parametric oscillator

A β-barium borate (BBO) femtosecond optical parametric oscillator (OPO) pumped by the second-harmonic of a modelocked 82 MHz Ti:sapphire laser is described. With intracavity dispersion compensation, pulse durations down to 30 fs are obtained with a total average power up to 100 mW. The current wavelength range, with a 400 nm pump, is from 566 nm to 676 nm. Unusual tuning characteristics, including bichromatic emission, are presented in detail and explained theoretically.     

EPR light beams and non-Gaussian quantum distributions in the time domain

We investigate time-dependent properties of Einstein-Podolsky-Rosen (EPR) light beams generated in nondegenerate optical parametric oscillator (NOPO) driven by a sequence of laser pulses with Gaussian time-dependent envelops. The peculiarities of EPR beams are discussed on the base of quadrature squeezing and also in the framework of phase-space Wigner functions for EPR beams which are combined on a half beam splitter. We also investigate the Wigner functions of intensity-correlated twin beams following the conditional photon state-preparation scheme. It is demonstrated that the Wigner functions involve negative values in parts of the phase space for the schemes with one-, two-, and three-photons.     

Ultra-stable microwave generation with a diode-pumped solid-state laser in the 1.5-μm range

We demonstrate the first ultra-stable microwave generation based on a 1.5-μm diode-pumped solid-state laser (DPSSL) frequency comb. Our system relies on optical-to-microwave frequency division from a planar-waveguide external cavity laser referenced to an ultra-stable Fabry–Perot cavity. The evaluation of the microwave signal at ~10 GHz uses the transportable ultra-low-instability signal source ULISS^®, which employs a cryo-cooled sapphire oscillator. With the DPSSL comb, we measured ?125 dBc/Hz phase noise at 1 kHz offset frequency, likely limited by the photo-detection shot-noise or by the noise floor of the reference cryo-cooled sapphire oscillator. For comparison, we also generated low-noise microwave using a commercial Er:fiber comb stabilized in similar conditions and observed >20 dB lower phase noise in the microwave generated from the DPSSL comb. Our results confirm the high potential of the DPSSL technology for low-noise comb applications.     

Entanglement of states and quantum distributions in pulsed optical parametric oscillator

The time-domain properties of Einstein-Podolsky-Rosen (EPR) entangled states of light are studied by means of analysis of both the Wigner functions and variance of quadrature amplitudes of generated modes. As a source of EPR states a non-degenerate optical parametric oscillator is considered driven by a sequence of laser pulses with a Gaussian time envelope.