共查询到19条相似文献,搜索用时 595 毫秒
1.
2.
3.
提出了一种新型同轴插板式模式变换器,可以实现同轴TEM到圆波导TE11模式的变换。介绍了这种模式变换器的工作原理:即通过在同轴波导中沿轴向插入金属板,将同轴TEM模变换成扇形截面波导TE11模,进而利用不同扇形截面波导中的相移改变电场分布的轴对称性,在同轴波导中形成同轴TE11模,最后将同轴TE11模转换为圆波导TE11模式。基于这一原理设计了一个中心频率为3.8GHz的同轴TEM-圆波导TE11模式变换器,并进行了数值模拟。模拟结果表明:这种模式变换器可以承受高功率,中心频率上转换效率为98.5%,转换效率大于90%的带宽超过10%,在3.5~4.1GHz的频率范围内反射损耗低于0.3dB。 相似文献
4.
介绍了采用准光方法激励圆波导产生旋转TE6 2模式的设计原理、测试方法和实验结果。该模式产生器由毫米波光学系统和开放同轴波导谐振腔系统组成:毫米波光学系统由角锥喇叭天线、双曲面反射镜、抛物面反射镜、修正抛物面反射镜等部件组成;开放同轴波导谐振腔系统由开放同轴波导谐振腔、圆波导、测试辐射喇叭天线组成。通过网络分析仪和毫米波近场自动测试系统测试表明:该模式产生器在频率为96.4 GHz附近产生的圆波导旋转TE6 2模式的纯度达到97%。 相似文献
5.
6.
介绍了同轴插板式TEM-TE11模式转换器的设计:在同轴波导内沿径向插入四块金属板,将同轴TEM模转变为扇形截面波导TE11模,通过控制插板的长度使不同扇形截面波导输出TE11模的相位不同,最后在圆波导内形成TE11模;通过在插板的前端设置角向均匀分布的金属杆,实现了模式转换器的良好匹配。实验测得模式转换器的辐射方向图轴向最大,与数值计算结果吻合良好,表明实验中模式转换器的输出模式与数值计算结果一致,从而验证了同轴插板式模式转换器的可行性。 相似文献
7.
8.
提出了一种结构紧凑的、能将圆波导TM01模或同轴波导TEM模转换为圆极化TE11模的高功率微波模式转换器。该转换器由前后2个十字转门波导结对接组成,前者首先把圆波导TM01模转变为4个矩形波导中的TE10模,4个矩形波导的长度不等;后者再把4个经过不同相位延迟的矩形波导TE10模转变为圆波导中的圆极化TE11模。对所设计的1.75 GHz模式转换器进行了仿真研究,在中心频率上,该模式转换器转换效率为99%,轴比为0.03 dB;在1.575~1.900 GHz的频率范围内,转换效率大于90%,轴比小于2.5 dB,对应带宽为18.6%。 相似文献
9.
10.
11.
采用在圆柱坐标系中分离变量的方法,推出填充多层互易手征介质的金属同轴线各层电磁场之间的关系,得到其模式特征方程和圆波导模式特征方程,给出了填充两层手征介质金属同轴线部分模式的色散特性的数值计算结果,分析了手征介质参量及两层手征介质厚度变化等对手征同轴线传播特性的影响。如果互易手征介质的手征参数等于零,可得填充普通介质的同轴线的模式特征方程。与填充普通介质的同轴线中的模式相比,手征同轴线中的模式发生了分叉。当同轴线中所填介质的折射率增大时,其模式归一化截止频率和进行基模单模传输的带宽归一化频率都将减小。 相似文献
12.
推导了同轴波导的空间电荷限制流,其值大于圆波导的空间电荷限制流。因此在阴极电势和束流相等的情况下,同轴波导中的束流具有更高的动能,同轴器件有可能获得更高的微波转换效率。理论推导出同轴慢波结构中考虑束流空间电荷影响的色散方程,利用Matlab进行了编程求解。不考虑束流空间电荷影响时,编程计算结果与Superfish模拟结果一致。由考虑束流空间电荷影响的色散方程数值计算结果,可知文献中提出的同轴慢波结构相对论高功率微波产生器工作在准TEM模的π模,频率为7.67 GHz,峰值时间增长率较高,电子束损失的能量与其初始能量之比为34%。这些结果均与文献中的数值模拟结果一致。同时理论分析说明该种器件无论在能量转换效率,还是在产生微波脉冲的上升时间上均具有优势。 相似文献
13.
P. J. Castro J. J. Barroso R. A. Correa 《International Journal of Infrared and Millimeter Waves》1993,14(10):2191-2201
A study of ohmic selective properties of open coaxial cylindrical resonators has been conducted experimentally and compared with theory. The resonator consists of an inner cylinder made of silicon carbide symmetrically located inside an outer cylindrical, tube shaped waveguide. Several fundamental TE modes were identified over the range 9 to 17 GHz through measurements of the resonant frequencies and the associated quality factors. Mode discrimination is achieved both by exploring selective ohmic effects and examining the electrodynamical properties of the coaxial cylindrical waveguide. The effectiveness of a silicon carbide coaxial insert in providing ohmic mode selection is demonstrated in that the totalQ factors of TE
mp
modes with radial indexp2 become well below the quality factors for surface TE
m1 modes. It has been verified that both structure and number of resonant modes are strongly dependent on the diameter and the resistivity of the coaxial insert. 相似文献
14.
采用多导体传输线分析方法, 对同轴交错圆盘加载波导慢波结构进行了理论分析, 得到了这种慢波结构的色散方程; 利用该色散方程, 得到的色散特性与HFSS仿真软件模拟结果符合良好. 分析了结构参数的变化对同轴交错圆盘加载波导慢波结构的色散特性影响. 结果表明: 增加内径和减小慢波结构的单位周期长度可以拓展慢波结构的带宽. 对同轴圆盘加载波导和同轴交错圆盘加载波导两种慢波结构的色散特性进行了比较, 结果表明: 采用圆盘交错加载方式可以减弱色散, 拓展带宽. 研究结果对同轴交错圆盘加载波导在毫米波行波管中的应用具有指导意义.
关键词:
行波管
同轴交错圆盘加载波导
慢波结构
色散特性 相似文献
15.
16.
P. J. Castro J. J. Barroso R. A. Correa 《International Journal of Infrared and Millimeter Waves》1993,14(2):383-395
A study of selective properties of coaxial open cylindrical resonators have been conducted experimentally and compared with theory. The resonator consists of an inner circular cylinder symmetrically located inside an outer weakly irregular open waveguide. Several fundamental TE modes were identified over the range 9 to 17 GHz through measurements of the resonant frequencies and the associated loaded quality factors. It has been verified that the structure and the number of resonant modes are both strongly dependent on the diameter of the coaxial insert. Such an electrodynamical system proves to be useful in guided wave applications requiring, for example, filters, frequency-tunable resonators and devices for analyzing the modal composition of a signal. 相似文献
17.
A. S. Shlapakovskii 《Technical Physics》1997,42(5):516-521
A coaxial waveguide partially filled with a dielectric as the slow-wave structure of a dielectric Cherenkov maser is investigated.
The dispersion of the fundamental mode of this waveguide is very weak at phase velocities close to the velocity of light,
and for this reason a very wide gain bandwidth is possible under conditions of an interaction with a relativistic electron
beam. The dispersion equation for an infinitely thin tubular beam in a coaxial waveguide with a dielectric liner adjoining
either the outer or inner conducting surface is derived. The gain bandwidth as a function of the parameters of the electron
beam and the slow-wave system are investigated on the basis of numerical solution of the dispersion equation, and a comparison
with similar dependences for the conventional configuration of a dielectric Cherenkov maser is made. The structural features
of the coaxial configuration which enable novel approaches to the problems of matching the microwave signal at the entrance
and exit of the system are discussed.
Zh. Tekh. Fiz. 67, 66–72 (May 1997) 相似文献
18.
19.
设计了一种高功率微波双波段同轴馈源,从理论分析和数值仿真两方面进行了验证。它采用同轴结构馈电,C波段的工作中心频率为4.15 GHz,利用加入轴向波纹的圆波导结构馈电;L波段的工作中心频率为1.75 GHz,利用同轴波导馈电。通过调整外筒半径的大小,可有效抑制低频段高阶模的传输,同时径向波纹结构可有效改善高频段微波的辐射特性。利用模式匹配法和组合散射矩阵理论对馈源结构进行了分析,理论计算和数值仿真结果具有良好的一致性,所设计的双波段馈源结构紧凑,副瓣电平低,E面和H面方向图等化特性良好。 相似文献