Nd：YLF单纵模调Q激光器腔内脉冲稳幅的实验研究

报道用超快ＧａＡｓ光电导开关为基础的光电反馈网络对ＮＤ：ＹＬＦ单纵模调Ｑ脉冲激光器的腔内光强度成功地进行了负反馈控制，输出的调Ｑ激光脉冲幅度稳定性得到提高，不稳定度＜±３％。     

二极管激光侧面泵浦腔内倍频Nd：YAG板条激光器研究

用准连续６０Ｗ的二极管激光列阵侧面泵浦“之”字形Ｎｄ：ＹＡＧ板条激光器，当泵浦功率为４５Ｗ，脉宽为４００μｓ时，得到３．５ｍＪ的激光输出。用ＫＤ＊Ｐ电光开关调Ｑ，得到１８ｎｓ（ＦＷＨＭ）、２ｍＪ的脉冲激光输出，用ＫＴＰ晶体作腔内倍频，得到１５ｎｓ、０．８５ｍＪ的二次谐波激光输出。在腔内无调Ｑ元件且腔长小于５ｃｍ时，于近阈值处得到单频绿光输出，而当泵浦功率稍大，腔内有数个纵模振荡时，观察到激光的反相态，并用数值模拟的结果对此作了解释。     

半导体激光泵浦预激光锁模调Q固体激光器研究

报道半导体激光侧面泵浦预激光锁模调Ｑ的Ｎｄ：ＹＡＧ固体板条激光器，预激光锁模调Ｑ的激光脉冲宽度为３６ｐｓ，调Ｑ包纤各心的锁模单脉冲能量超过７μＪ，相应的峰值功率达２００ｋＷ。     

准连续60W半导体激光侧面泵浦声光调QNd：YAG板条激光器研究

用准连续６０Ｗ激光二极管列阵侧面泵浦Ｎｄ：ＹＡＧ板条激光器，获得３．５ｍＪ的激光输出和峰值功率为７５ｋＷ的声光调Ｑ激光脉冲，脉冲幅度起伏小于±１％。对研究结果进行了分析。     

用于激光核聚变的可长时间单纵模稳定运转的Nd:YAG和Nd:YLF激光振荡器的研究

成功地研究了准连续预激光调Q和脉冲预激光调Q Nd:YAG和Nd:YLF单纵模振荡器.首次解决了脉冲预激光调Q单纵模振荡器腔长控制的物理和技术问题,实现了长时间十分稳定的单纵模运转,已用于大型高功率激光核聚变系统.     

二极管激光侧泵浦单横模100Hz电光调Q激光器

介绍了二极管激光侧泵浦单横模１００Ｈｚ电光调Ｑ激光器的实验结果。泵浦源为一个线阵准连续１００Ｗ二极管激光器，激光工作介质为ＮｄＹＡＧ薄梯形板条，板条与泵浦源间用柱透镜耦合，ＫＤ＊Ｐ电光晶体调Ｑ。在１００Ｈｚ重复频率下，获得单脉冲能量２．３７ｍＪ，脉宽小于７ｎｓ，光束质量因子Ｍ２＝１．１的１．０６μｍ激光，光－光效率为８．５％，斜效率为１８．７％。     

全光纤波长可调谐调Q激光器

实现了全光纤波长可调谐主动调Ｑ和自调Ｑ激光脉冲输出。波长可调谐范围为５．７ｎｍ。主动调Ｑ激光脉冲的最高峰值功率可达２．６Ｗ,平均功率１ｍＷ。观察到了自调Ｑ现象,且对自调Ｑ现象给予了初步的解释。     

基于反射式布拉格光栅和Fabry-Perot标准具组合的Nd∶YVO4单频激光器

报道了一种激光二极管端面连续抽运的稳定单频主动调Q Nd∶YVO_4激光器。采用RBG与标准具组合的方式获得了稳定的高功率单频激光输出。RBG既作为输出耦合镜,又作为纵模选择元件,与标准具组合可进一步抑制多纵模,增长谐振腔的光学腔长,获得高功率输出。通过优化标准具的倾斜角度,可使标准具与RBG的中心波长匹配,并减小腔内插入损耗。最终在物理腔长为148.7mm的条件下,获得了功率为750mW,脉冲能量为75μJ@10kHz,脉宽为8.3ns的稳定的高功率单频激光输出。     

全固态单纵模脉冲Nd:YVO_4环形激光器

设计并研制了全固态调Q脉冲单纵模Nd:YVO4环形激光器。利用880nm激光二极管端面抽运Nd:YVO4晶体,通过四镜环形谐振腔中插入声光调Q晶体、标准具,并优化激光谐振腔的结构,获得了重复频率为200Hz、脉宽为26.6ns的单纵模脉冲1.064μm激光输出。当泵浦功率为15 W时,单纵模激光输出的单脉冲能量为570μJ、脉冲能量稳定性优于3%。     

微型饵玻璃激光器研究

报道了微型饵玻璃激光器的阶段性研究成果，研究在自由振荡情况下输出膜片反射率，氙灯气压及激光电容的大小对激光输出的影响，采用电光调Ｑ，获得了８ｍＪ的巨脉冲输出，采用转镜调Ｑ，获得了１２ｍＪ的巨脉冲输出，脉宽８０ｎｓ。     

脉冲LDA泵浦Nd∶YVO4/GaAs被动调Q锁模激光器

用脉冲激光二极管阵列（LDA）作为泵浦源、微柱透镜阵列和透镜导管作为耦合系统,以As＋注入GaAs可饱和吸收片作为被动调Q锁模元件,实现了Nd∶YVO4激光器调Q锁模运转.调Q运转阶段,激光器每泵浦脉宽内输出一个调Q脉冲,调Q脉宽7ns.调Q锁模运转阶段,初始透过率60％的GaAs晶片对调Q包络内的锁模脉冲的调制深度达到95％以上,锁模脉冲重复频率991 MHz.研究了加在LDA上的电压、方波脉冲的脉宽和重复频率对调Q锁模脉冲特性的影响,并对实验结果进行了讨论.     

LD-pumped 1.34 μm-Q-switched and mode-locked Nd:GdVO4 laser by a V3+:YAG saturable absorber

A diode-pumped passively Q-switched and mode-locked Nd:GdVO₄ laser at 1.34 μm with V³⁺:YAG as the saturable absorber is realized in a V-type folded cavity. About 100% modulation depth of mode locking can be obtained as long as the pump power reaches the oscillation threshold. The width of the mode-locked pulse is estimated to be less than 280 ps with 200 MHz repetition rate within an about 980 ns-long Q-switched pulse envelope. A maximum output power of 200 mW and Q-switched pulse energy of 5.7 μJ is obtained.     

超高斯光束抽运调Q固体激光器仿真模型研究

仿真计算一直是研究激光器的重要手段,而激光理论是仿真计算的基础.虽然半经典激光理论能够精确地描述激光的产生过程,但是其复杂性导致仿真需要庞大的计算资源和计算时间.为了能够更加高效地对激光器进行仿真,提出了一种调Q固体激光器的仿真模型.基于此模型,研究了影响主动调Q激光产生过程的因素.这些因素包括抽运功率、抽运光分布和模式竞争.仿真计算结果与对照实验测量数据相符合,说明了模型的有效性.     

A Single-Longitudinal-Mode Passively Q-Switched Nd:YVO_4 Laser Using Black Phosphorus Saturable Absorber

A black phosphorus(BP) saturable absorber(SA) solution with different concentrations(1.0 and 0.5 mg/ml) is fabricated with the liquid-phase exfoliation method. By using the BP-SA, a compact diode-pumped passively Q-switched Nd:YVO_4 laser is demonstrated. One reflecting Bragg gratings is used as the output coupler for mode selection. By inserting those BP-SA solutions in the laser cavity, the maximum single longitude mode,Q-switched output powers of 126 mW at 692.5 kHz and 149 mW at 630.3 kHz are achieved at the pump power of 8.0 W, corresponding to the pulse durations of 144 ns and 196 ns, respectively. Moreover, longitudinal-mode characteristics of Q-switched output laser in different optical cavity lengths based on two-kind BP-SA solution concentrations are investigated. Our results show that BP-SA could also be developed as an effective SA for the Q-switched, single longitudinal mode pulse laser.     

调Q激光脉冲的腔内时间整形

在Ｎｄ：ＹＬＦ单纵横激光器腔内调Ｑ脉冲达到某个预定的强度之后，腔内引入附加的损耗使腔内增益与损耗相平衡，净增益为零，这时腔内光强维持恒定，激光器输出为准平顶时间整形调Ｑ脉冲。     

基于少模光纤被动调Q柱矢量光光纤激光器

通过单模光纤和少模光纤熔融拉锥耦合的方法制备出模式转换器,而后将一层多壁的碳纳米管薄膜作为可饱和吸收体覆盖到拉锥光纤的锥区,形成一种可饱和吸收体柱矢量光器件.结合调Q光纤激光器和模式转换器件的优势,可以简单高效地产生脉冲柱矢量光束,并得到具有峰值功率高、模式纯度高等特点的脉冲高阶模式激光输出.通过实验实现了中心波长为1560nm、最大单脉冲能量和最大峰值功率分别为116nJ和57mW的稳定调Q脉冲输出.通过调节光路中的偏振控制器,可以分别实现径向和角向偏振的调Q脉冲激光的输出.     

The acousto-optic Q-switched mode-locking Nd:YVO4 laser

Q-switched mode locking (QML) has been observed in acousto-optic Q-switched Nd:YVO₄ laser that contained no mode-locking components. It was found that QML was easily realized in a long cavity and the modulation depth was observed to increase with increased cavity length. The maximum modulation depth was as high as 90%. This phenomenon is explained by the introduction of gain-related effect in the gain medium. The longitudinal modes at higher frequency, than the central frequency of the gain profile, experience positive guiding, which results in mode locking of these modes.     

A Stable Wavelength Operation Ho:YAG Laser with Orthogonally Polarized Pump

A stable wavelength operation Ho:YAG laser dual-pumped by two orthogonally polarized Tm:YLF lasers is reported. Under the cw operation mode, a laser output power of 24 W is measured. The corresponding opticaloptical conversion efficiency is 44.75% and the slope efficiency is 50.12%. Under the Q-switched operation mode,the output maximum average power is 22.8 W at the re-frequency of 6 kHz. The corresponding optical-optical conversion efficiency and slope efficiency are 42.64% and 48.01%, respectively. The output central wavelength is 2090.73 nm, the linewidth is 0.40 nm, and the beam quality is M~2 1.6. Moreover, the shift of the output central wavelength is less than 0.01 nm, and the linewidth shift is also less than 0.01 nm.