Epoxy polymer coating to prevent the corrosion of aluminum nanoparticles

Aluminum nanoparticles were coated by epoxy polymer in order to prevent the corrosion reaction. The coverage of the epoxy polymer film was controlled from 0% to 100%, which changed the corrosion rate of nanoparticles quantitatively. The surface of the polymer coating was investigated by transmission electron microscopy (TEM) and atomic force microscopy (AFM), and the corrosion resistance of these nanoparticles was estimated by the wet/dry corrosion test on platinum (Pt) plate with a NaCl solution. From a TEM analysis, 10 mass% polymer‐coated Al particles in the synthesis were almost 100% covered on the surface by a polymer film of 10 nm thick. On the other hand, 3 mass% polymer‐coated Al was partially covered by a film. In the AFM–Kelvin force microscopy, the potential around the Al particles had a relatively low value by the polymer coating, which indicated that the conductivity of the Al was isolated from Pt plate by the polymer. Both the corrosion and H₂ evolution reaction rates were quantitatively reduced by the mass% of polymer coating. In the case of 10 mass% coated sample, there was very little corrosion of Al nanoparticles. This fact suggested that the electrochemical reaction was suppressed by the polymer coating. Thus, it was found that the corrosion reaction rate of Al nanoparticles could be quantitatively suppressed by the mass% of epoxy coating. Copyright © 2015 John Wiley & Sons, Ltd.