| Abstract: | The completeness of mercerisation can be evaluated by investigating the changes in the crystalline regions of cellulose from cellulose I (C-I) to cellulose II (C-II) by the X-ray powder diffraction method. Mercerisation experiments in four different solution systems: ethanol/water, acetone, DMSO and xylene, are reported. Also the effect of some additives, external pressure, treatment time and alkalisation temperature were studied. In two-phase solvent systems, structural changes of cellulose crystallites depended primarily on the distribution and solubility of sodium hydroxide in the solvent phases. The sodium hydroxide concentration in the hydrophilic phase must exceed 7–8 w/w-% before complete crystal change from C-I to C-II can occur. The precipitation of sodium hydroxide due to high concentration prevents the successful use of one-phase ethanol/water system in slurry process. On the contrary, the 2-propanol/water/sodium hydroxide system separates into two layers; to the water-rich lower layer and the 2-propanol-rich upper layer, where the sodium hydroxide remains mainly in the water-rich lower layer. This prevents the precipitation of sodium hydroxide and promotes the alkalisation of cellulose. Ammonium chloride and ammonium hydroxide clearly had a positive effect by promoting the crystal changes, however, the urea concentration used in this study was obviously too small. In the advantageous two-phase 2-propanol/water systems, the alkalisation time was only 15 min when the treatment temperature was kept between 0 and 10 °C. Reduced external pressure was found to have a small but still detectable positive effect on cellulose alkalisation while over-pressure prevented crystal changes. |
