聚丙烯接枝马来酸酐/SiO_2复合载体型钛催化剂制备及表征

可用于负载烯烃聚合催化剂的材料很多,目前无机载体以SiO2和MgCl2最为普遍.但SiO2和MgCl2容易出现团聚现象,特别是由于SiO2表面羟基分布不均匀,会造成载体局部区域的催化剂浓度过大,活性中心过于集中,对烯烃共聚合时共聚单体的分布不利1].聚合物载体由于表面的官能团分布均匀及分布密度可调,负载后的催化体系对氧、水的稳定性增加.但聚合物载体制备较为复杂,且用研磨法得到的载体颗粒形态及分布不易控制,用于高温聚合时容易破裂.由于无机和有机载体各自具有某些特殊的优点,可以进行互补克服某些不利的因素,因而怎样利用不同类型载体的复配,得到性能优良的复合载体,已成为烯烃催化剂载体化研究的一个重要方向.本文制备了聚丙烯接枝马来酸酐(PMA)/SiO2复合载体,制备了负载化TiCl4烯烃聚合催化剂,其既可以避免由纯无机物为载体而引入过多的无机灰分,又可以避免仅用聚合物为载体而造成的负载率低的缺点,同时保持了无机载体的刚性和聚合物载体官能团的多分布性.

PREPARATION AND CHARACTERIZATION OF POLYMPROPYLENE GRAFTING MALEIC ANHYDRIDE/SiO2 COMPOSITE-SUPPORTED TITANIUM CATALYSTS

The composite,prepared with polypropylene grafting maleic anhydride and silica crosslinked by 3 aminopropyltriethyoxysilane,was used as the carrier to support titanium chloride.XPS and FTIR measurements were emplyed to investigate the states of several atoms during stepwise supporting catalyst for clarifying the mechanism.The results showed two possible mechanisms of active catalytic sites on the composite carrier:the catalytic sites bridged through MAO on the inorganic silica gel;on contrary,the catalytic sites bridging with carbonyls of amide formed in the composite.