Three-dimensional photoelastic study of the load-carrying capacity/face width ratio of Wildhaber-Novikov gears for automotive applications |
| |
Authors: | K Lingaiah K Ramachandra |
| |
Institution: | 1. University Visvesvaraya College of Engineering, Bangalore University, 560001, Bangalore, India
|
| |
Abstract: | Wildhaber-Novikov gears are becoming more and more popular for heavy load applications. They have been tried as speed-reducing gears, in spite of heavy noise generation, in aircraft jet engines, marine engines and agricultural machinery. These circular-arc gears, though stronger than involute geras, have the disadvantage of needing larger face width. Axial face width required can be minimized only at the expense of load-carrying capacity. This is not a serious disadvantage with stationary engines. But in the case of automotive applications, this fact limits the load-carrying capacity of Wildhaber-Novikov gears, since space problem is very critical in these applications and large face widths, therefore, cannot be used for such gear-reduction units. The face width is determined by the helix angle and, therefore, a thorough investigation of the dependence of the load-carrying capacity on helix angle is necessary, if these special types of gears have to make headway into the automotive field. In this experimental investigation, three-dimensional photoelastic technique has been employed to study the load-carrying capacity/face width ratio. Three-dimensional gear models made of epoxy castings (Araldite B) were loaded in a specially built gear-loading fixture and were stress frozen. Gear cutters of Wildhaber-Novikov gears developed at the laboratory were used for the preparation of these three-dimensional gear models. The stress-frozen models were analyzed using the conventional slicing technique to study the contact and bending-stress distribution along the face width. The load-carrying capacity in terms of contact stress and bending stress has been studied for different face widths and helix angles. Twenty-deg pressure angle, 14-mm module gears of alladdendum type of Wildhaber-Novikov gears with different helix angles up to 40 deg were tested. The helical-overlap ratio used was 1.0. The conventional profile parameters were employed for the manufacture of gear cutters of end-mill type. The decrease in contact and bending strength with increase in the helix angle or decrease in the face width, as obtained from this photoelastic method of stress analysis has been compared with existing theoretical results. |
| |
Keywords: | |
本文献已被 SpringerLink 等数据库收录! |
|