Determination of cadmium in polyethylene by analytical atomic spectrometry with gas-phase sample introduction technique

Cadmium in polyethylene was determined by both inductively coupled plasma atomic emission spectrometry (ICP-AES) and atomic absorption spectrometry (AAS) with continuous-flow gas-phase sample introduction in a reaction medium of ascorbic acid. In the presence of mixture of cobalt and thiourea in the ascorbic acid solution, the sensitivities by both ICP-AES and AAS for cadmium were greatly enhanced. The gaseous cadmium species was phase-separated in a gas–liquid separator and directed via a stream of argon carrier gas to an inductively coupled plasma and an electrically heated quartz tube atomizer (QTA) for atomic spectrometry. Under the optimized experimental conditions, the best attainable detection limits at Cd I 228.802 nm line were 1.3 and 0.017 ng/ml with linear dynamic ranges of 10–500 ng/ml and 0.1–1 ng/ml in concentrations by ICP-AES and QTA-AAS, respectively. The instrumental precisions expressed as the relative standard deviation (R.S.D.) from ten replicate measurements of 50 and 1 ng/ml cadmium by ICP-AES and QTA-AAS were 5.6% and 3.2%, respectively. With the use of ICP-AES and QTA-AAS with gas-phase sample introduction method, six- and 200-fold improvements in detection limits for cadmium were obtained in comparison with their conventional solution nebulization methods, respectively. After the effects of several diverse elements on the determination of cadmium by ICP-AES and QTA-AAS with the present gas-phase sample introduction systems were examined, these methods were applied to the determination of low concentrations of cadmium in polyethylene. The results obtained by the present method were in good agreement with the certified values.