Determination of heavy metals at the pg/g level in Antarctic snow with DPASV and IDMS

Summary Differential pulse anodic stripping voltammetry (DPASV) and isotope dilution mass spectrometry (IDMS) were used to analyse heavy metals in Antarctic snow samples. It was possible to determine Pb and Cd with DPASV at the German Antarctic station Georg-von-Neumayer whereas the analyses of Pb, Cd, Tl, Cr, Ni, Cu, Zn, and Fe with IDMS were carried out at the University of Regensburg. 80% of the elemental concentrations in surface snow samples analysed with IDMS lay in the following ranges: Pb=3–40 pg/g, Cd<0.2–3 pg/g, Tl<0.2 pg/g, Cr<0.8–15 pg/g, Ni<4.8–40 pg/g, Cu<11–30 pg/g, Zn=30–500 pg/g, and Fe=(0.5–1.5)×10³ pg/g. In most cases an acceptable agreement between the DPASV and IDMS results was obtained for Pb and Cd. More than 50% of all Pb analyses agreed within a deviation of 0–10 pg/g. The Cd results between both methods usually deviated by less than 1 pg/g. Slightly higher Pb concentrations were analysed in the average with IDMS compared with DPASV. This effect was not observed for the Cd data. A possible explanation for this fact are non-ionic Pb species in the melted snow samples, which cannot be analysed by DPASV. One particular investigation of Pb concentrations showed that the analysed data with DPASV decreased with the increasing length of sun-shine after a snowfall when samples of the same origin were determined. Blank control is the major requirement for accurate analysis results of heavy metals in this low concentration range. On the other hand, accuracy must always be tested by independent analytical methods. In this work it is shown that Pb and Cd can be analysed directly in the Antarctica with DPASV and that the result of this method is in acceptable agreement with the definitive method IDMS.

---

Bestimmung von Schwermetallen im pg/g Bereich in antarktischen Schneeproben durch differentielle Pulsinversvoltammetrie und massenspektrometrische Isotopenverdünnungsanalyse