首页 | 本学科首页   官方微博 | 高级检索  
     

光栅投影相位法系统模型及标定方法
引用本文:安东,陈李,丁一飞,邓连杰,王永红. 光栅投影相位法系统模型及标定方法[J]. 中国光学, 2015, 8(2): 248-254. DOI: 10.3788/CO.20150802.0248
作者姓名:安东  陈李  丁一飞  邓连杰  王永红
作者单位:合肥工业大学 仪器科学与光电工程学院, 安徽 合肥 230009
基金项目:国家自然科学基金资助项目(No.51375136);国家科技支撑计划资助项目(No.2011BAK15B07);中航工业产学研专项资助项目(No.CXY2013HFGD22)
摘    要:本文针对传统投影光栅相位法的光学三角法模型进行了改进,采用直入射光路并配合使用一种简便易行的标定方法,只需使用相移公式求取相位差,而不会引入与系统几何位置关系有关的量,简化了求取高度矩阵的要求。实验结果表明,新系统模型精度良好,测量误差为0.107 mm。采用该模型和标定方法可以克服传统方法系统模型的局限性,最大限度减少误差源并提高抗干扰性。

关 键 词:三维轮廓  光栅投影  相位  标定  系统模型
收稿时间:2014-11-12

Optical system model and calibration of grating projection phase method
AN Dong;CHEN Li;DING Yi-fei;DENG Lian-jie;WANG Yong-hong. Optical system model and calibration of grating projection phase method[J]. Chinese Optics, 2015, 8(2): 248-254. DOI: 10.3788/CO.20150802.0248
Authors:AN Dong  CHEN Li  DING Yi-fei  DENG Lian-jie  WANG Yong-hong
Affiliation:School of Instrument Science and Opto-electronics Engineering, Hefei University of Technology, Hefei 230009, China
Abstract:In this paper, the traditional optical triangulation model based on phase method is improved, and a new model and calibration method are used which is independent of geometric parameters. The new model requires only calculating phase difference thorough phase shift formula without adding any geometry position parameters, which simplifies the requirement of resolving the altitude matrix. Parallel tests show with the new model, a measurement error of 0.107 mm is reached, showing a good accuracy. Through the study of this paper. This new model calibration method can overcome the limitations of traditional method and minimize the error sources as well as improve the capability of anti-interference.
Keywords:3D profile  grating projection  phase  calibration  system model
本文献已被 CNKI 等数据库收录!
点击此处可从《中国光学》浏览原始摘要信息
点击此处可从《中国光学》下载免费的PDF全文
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号