Investigation of the rigid amorphous fraction in Nylon-6

A three-phase model, comprising crystalline, mobile amorphous, and rigid amorphous fractions (χ _c, χ _MA, χ _RA, respectively) has been applied in the study of semicrystalline Nylon-6. The samples studied were Nylon-6 alpha phase prepared by subsequent annealing of a parent sample slowly cooled from the melt. The treated samples were annealed at 110°C, then briefly heated to 136°C, then re-annealed at 110°C. Temperature-modulated differential scanning calorimetry (TMDSC) measurements allow the devitrification of the rigid amorphous fraction to be examined. We observe a lower endotherm, termed the ‘annealing’ peak in the non-reversing heat flow after annealing at 110°C. By brief heating above this lower endotherm and immediately quenching in LN₂-cooled glass beads, the glass transition temperature and χ _RA decrease substantially, χ _MA increases, and the annealing peak disappears. The annealing peak corresponds to the point at which partial de-vitrification of the rigid amorphous fraction (RAF) occurs. Re-annealing at 110°C causes the glass transition and χ _RA to increase, and χ _MA to decrease. None of these treatments affected the measured degree of crystallinity, but it cannot be excluded that crystal reorganization or recrystallization may also occur at the annealing peak, contributing to the de-vitrification of the rigid amorphous fraction. Using a combined approach of thermal analysis with wide and small angle X-ray scattering, we analyze the location of the rigid amorphous and mobile amorphous fractions within the context of the Heterogeneous and Homogeneous Stack Models. Results show the homogeneous stack model is the correct one for Nylon-6. The cooperativity length (ξ_A) increases with a decrease of rigid amorphous fraction, or, increase of the mobile amorphous fraction. Devitrification of some of the RAF leads to the broadening of the glass transition region and shift of T _g.