Insight of arsenic transformation behavior during high-arsenic coal combustion

The release of arsenic vapors (As³⁺) during high-arsenic coal combustion not only raises serious environmental concerns, but also causes catalyst deactivation in selective catalytic reduction (SCR) systems. To illuminate the mechanisms involved in the transformation of arsenic vapors towards less troublesome arsenates (As⁵⁺) during coal combustion, the accessory minerals in the high-arsenic coal were identified and the association relationship of these compounds with arsenic in fly ash was estimated. The results showed that Si/Al were the main inorganic elements in high-arsenic coal while the content of Ca was quite low. Ca was mostly transformed into sulfates during coal combustion and the effect of Ca on the arsenic transformation was limited. Al/Fe played a more significant role in arsenic speciation transformation and arsenic in the fly ash was predominantly bound with Al/Fe-oxides as arsenates. It was further confirmed that Al in kaolin/metakaolin showed good capacity on arsenic capture. In addition, few arsenic vapors were captured through the physical adsorption mechanism and the large fraction of As³⁺ in some fine particles was mostly attributed to the chemical reactions between arsenic vapors and Al-compounds. Meanwhile, a certain amount of arsenic vapors were converted into As₂O₅(s) under the influence of SCR catalyst and then carried by flue gas to participate in fly ash. Besides, part of arsenic distributed in the fly ash was through the stabilization of ash matrix in high temperature conditions. The transformation of arsenic from vapors towards particulate arsenic favored arsenic emission control by particulate matter control devices.