磁头-磁盘接触作用力对磁记录层信息强度影响规律的定量研究

磁存储密度的持续增长会导致磁头-磁盘的间距不断减小, 这样, 极有可能引起磁头-磁盘接触退磁的发生, 从而造成磁记录层存储数据的丢失. 为了明确退磁过程中的相应作用关系, 本文通过磁力显微镜的相位成像原理直接给出了磁盘退磁的定量测量方法. 并且依据此方法, 利用纳米划痕实验研究了磁头-磁盘接触作用力对磁记录层信息强度的影响规律. 结果表明:当磁头-磁盘接触作用力超过临界退磁载荷时, 磁记录层的信息强度与磁头-磁盘接触作用力之间存在减函数关系; 在低接触载荷区域中, 即使磁记录层表面没有划痕产生, 磁盘退磁现象仍旧可能发生; 对于任意磁头-磁盘接触作用力, 磁盘表面的破坏区域总是会大于磁记录层的退磁区域; 当磁头反复划刮磁盘的同一位置时, 磁记录层的表面划痕处将出现弹性安定状态, 对应地, 磁记录层的信息强度会趋近于某一定值.

Quantitative research into the influence of slider-disk contact force on the information intensity of the magnetic recording layer

In order to achieve the requirement of rapid growth of the magnetic storage density, the slider-disk spacing needs to be reduced to less than 2 nm. However, the slider-disk contact can easily occur within such a narrow spacing, and eventually result in the loss of the stored data in the magnetic recording film, i.e., demagnetization of the magnetic disk. Therefore, research into the magnetomechanical relationship related to the slider-disk contact demagnetization is significantly important to identify the demagnetization mechanism and further improve the anti-demagnetization performance of the magnetic disk. In this study, the nanoscratch experiment and the magnetic force microscope technology are used to investigate the magnetomechanical behavior induced by the slider-disk contact. And according to the phase imaging principle of the magnetic force microscope, the relationship between the information intensity of the magnetic recording layer and the magnetic contrast measured by the magnetic force microscope is found. Thus, a quantitative analysis method is proposed, which is different from the previous qualitative observation of the magnetic domain change. Experimental results show that the critical demagnetization load during the slider-disk contact is 120 μup N. When the slider-disk contact force exceeds the critical demagnetization load, the increase of slider-disk contact force can lead to the decrease of the information intensity of the magnetic recording layer. And the decay rate of the information intensity will be rapidly enhanced after the slider-disk contact force reaches 380 μup N. Moreover, the variation trend of the information intensity with the depth of the residual scratch is the same as that of the information intensity with the slider-disk contact force. Specially, before the slider penetrates the hard carbon layer of the magnetic disk, the slider-disk contact demagnetization still may occur, corresponding to the load cases from 120 μup N to 200 μup N. In addition, for any slider-disk contact force, the area of the surface damage of the hard carbon layer is always greater than that of the demagnetization of the magnetic recording layer. This phenomenon is related to the elasto-plastic force fields in the hard carbon layer and the magnetic recording layer. Moreover, when the slider repeatedly scratches the same location on the surface of the magnetic disk, the information intensity of the magnetic recording layer will decrease with the increase of scratching number. After the scratching number is beyond 20, the elastic shakedown status may occur in the magnetic recording layer, and correspondingly, the information intensity of the magnetic recording layer can be close to a constant value. This result is derived from the work hardening process during the slider-disk repeatedly scratching.