首页 | 本学科首页   官方微博 | 高级检索  
     检索      

TDLAS测量CO2的温度影响修正方法研究
引用本文:李峥辉,姚顺春,卢伟业,朱晓睿,邹丽昌,李越胜,卢志民.TDLAS测量CO2的温度影响修正方法研究[J].光谱学与光谱分析,2018,38(7):2048-2053.
作者姓名:李峥辉  姚顺春  卢伟业  朱晓睿  邹丽昌  李越胜  卢志民
作者单位:1. 华南理工大学电力学院,广东 广州 510640
2. 广东省特种设备检测研究院顺德检测院,广东 佛山 528300
3. 广东省能源高效清洁利用重点实验室,广东 广州 510640
基金项目:国家自然科学基金项目(51676073),“广东特支计划”科技青年拔尖人才(2014TQ01N334),广东省科技项目(2015A020215005),广东省质量技术监督局科技计划项目(2016ZT01)资助
摘    要:可调谐二极管激光吸收光谱(TDLAS)技术测量CO2浓度时,由于测量氛围温度变化的影响引起气体吸收谱线的线强和线型发生变化,最终导致浓度测量存在较大误差。为了克服温度变化对浓度测量的影响,选用中心波长在1 580 nm的DFB激光器,基于直接吸收法,模拟电厂尾部烟道内的高浓度二氧化碳气体环境,研究了在常温(298 K)和变温(298~338 K、间隔10 K)不同温度工况下CO2浓度的测量。结果显示,常温浓度测量的最大相对误差为-5.26%,最小相对误差为1.25%,相对误差均方值为3.39%,验证了TDLAS测量系统在常温下有着良好的测量精度和稳定性,但其在变温测量时浓度测量结果误差较大,其最大相对误差已经超过25%。为了修正温度变化对浓度测量结果的影响,适应工业测量的需要,在变温测量基础上利用最小二乘法拟合出测量系统在不同温度下的浓度与气体吸收的修正关系式。经过修正后,CO2浓度测量的相对误差降到5%以下,相对误差均方值降到3.5%以下。修正结果表明,所提出的修正方法可以有效抑制温度变化对浓度测量结果的影响,显著提高了测量系统在变温环境下的测量精度和稳定性,为TDLAS系统测量CO2浓度的现场应用提供了理论支持和技术保障。

关 键 词:可调谐二极管激光吸收光谱(TDLAS)  CO2浓度  温度修正  最小二乘法  直接吸收法  
收稿时间:2017-08-07

Study on Temperature Correction Method of CO2 Measurement by TDLAS
LI Zheng-hui,YAO Shun-chun,LU Wei-ye,ZHU Xiao-rui,ZOU Li-chang,LI Yue-sheng,LU Zhi-min.Study on Temperature Correction Method of CO2 Measurement by TDLAS[J].Spectroscopy and Spectral Analysis,2018,38(7):2048-2053.
Authors:LI Zheng-hui  YAO Shun-chun  LU Wei-ye  ZHU Xiao-rui  ZOU Li-chang  LI Yue-sheng  LU Zhi-min
Institution:1. School of Electric Power,South China University of Technology,Guangzhou 510640,China 2. Shunde Inspection Institute of Special Equipment Inspection and Research Institute of Guangdong Province,Foshan 528300,China 3. Guangdong Province Key Laboratory of Efficient and Clean Energy Utilization,Guangzhou 510640,China
Abstract:Tunable diode laser absorption spectroscopy (TDLAS) is often used to detect CO2 concentrations in many fields. But because of the variation of ambient temperature, the measured the line strength and line-shape are affected and may lead to the monitoring errors. Therefore, in order to overcome the influence of temperature change on the concentration measurement, we used the DFB laser with the center wavelength of 1 580 nm and the direct absorption method was used to measure the high concentration of carbon dioxide gas in the flue of the power plant under the condition of room temperature (298 K) and variable temperature (298~338 K,interval 10 K). The results showed that the maximum relative error of the concentration measurement was -5.26%, the minimum relative error was 1.25% and the relative error mean square was 3.39%, which indicated that TDLAS measurement system had good measurement precision and stability at room temperature. But the concentration measurement in the temperature measurement error, the maximum of relative error was more than 25%. Then, the influence of temperature change on the measurement of the concentration was solved to meet the needs of industrial measurement and on the basis of temperature change measurement, the least squares method was used to fit the correction relation between the concentration of the measurement system and the gas absorption at different temperatures. After the correction, the relative error of the CO2 concentration measurement was reduced to below 5%, and the relative error mean square value fell below 3.5%.The correction results showed that the proposed method can effectively suppress the influence of temperature change on the concentration measurement and improve the measurement accuracy and stability of the system in the variable temperature environment, which provides theoretical support and technical support for the TDLAS system field application.
Keywords:Tunable Diode Laser Absorption Spectroscopy (TDLAS)  CO2 concentration  Temperature correction  Least square method  Direct absorption method  
本文献已被 CNKI 等数据库收录!
点击此处可从《光谱学与光谱分析》浏览原始摘要信息
点击此处可从《光谱学与光谱分析》下载免费的PDF全文
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号