Continuous cellulose fiber-reinforced cellulose ester composites. II. Fiber surface modification and consolidation conditions

We prepared thermoplastic composite panels using solution impregnation of continuous lyocell (regenerated cellulose) fibers with a cellulose mixed-ester (cellulose acetate butyrate) matrix. We examined both fiber-matrix adhesion and melt consolidation in an effort to produce uniform panels having low void content and high mechanical strength. We characterized the effect of surface modification by acetylation on interfacial adhesion between the cellulose fiber and cellulose ester. Whereas wood fiber acetylation had previously been observed to result in significant strength gains in (discontinuous) wood fiber- reinforced composites (with the same matrix material), we did not observe a similar increase in strength in the continuous lyocell cellulose fiber system. This suggests that interfacial stress transfer is not a limitation in this system. This was confirmed by microscopic examination of the fracture surfaces, which indicated that fiber-matrix adhesion was considerable in the absence of fiber surface modification. We then systematically varied melt consolidation conditions (temperature, pressure and time) in an attempt to define optimum consolidation parameters by using design of experiments (DOE) methodology. We measured both interlaminar shear strength (ILSS) and composite void volume. We found that a minimal void content (ca. 2.83 vol. %) occurred at moderate temperatures (200°C), low consolidation pressures (81.4kPa) and long press times (13min). This was also where we maximized the interlaminar shear strength (ILSS) at a value of 16.3MPa. This agrees with the regression model predictions. We observed the highest tensile properties at the ILSS and void-volume optimal-consolidation condition: a tensile modulus of 22GPa and tensile strength of 246MPa were obtained.