| Abstract: | Commingled polypropylene (PP)/banana granules were fabricated from slivers by mixing PP fibers and banana fibers by textile equipment. By twisting the sliver, the reinforcing fibers were compacted and bonded with the molten matrix material. PP/banana composites were prepared from commingled PP/banana granules by injection moulding method with special reference to the effect of maleic anhydride modified polypropylene (MAH-PP) concentration. The mechanical properties of the composites were found to depend on the concentration of MAH-PP. The tensile and flexural properties of the composites increased with the addition of MAH-PP up to 2 wt%. After 2 wt% addition of MAH-PP, these properties tend to be stabilized. On the other hand the unmodified composites showed the maximum impact strength. Fourier transform infrared spectroscopic (FTIR) analysis of the MAH-PP modified composites showed evidence of a chemical bridge between the hydroxyl group of the banana fiber and maleic anhydride of the MAH-PP through an esterification reaction. The feature peak of the esterification occurred in the range ～ 1743 cm?1. In order to confirm the esterfication reaction further, FTIR spectra of the banana microfibrils and MAH-PP modified PP/banana microfibril composites were taken and compared. The tensile fracture surfaces of the unmodified and MAH-PP modified PP/banana composites were studied by scanning electron microscopy (SEM). An improvement in adhesion between the fiber and the matrix was observed in the case of MAH-PP modified composites. Two different processing methods, both injection and compression mouldings were performed to prepare the PP/banana composites. Tensile properties of the composites prepared by these two methods were compared. The enhancement of tensile properties for injection-moulded composites compared to the compression-moulded composites is owing to the occurrence of orientation, better mixing and interaction between the fiber and the matrix during injection moulding. Finally, experimental results of the tensile properties of the injection-moulded composites have been compared with theoretical predictions. |
