Die swell ratio of polystyrene melt from an electro‐magnetized capillary die in an extrusion rheometer: effects of barrel diameter,shear rate and die temperature

A constant shear‐rate extrusion rheometer with an electro‐magnetized capillary die was utilized to investigate die swell behavior and flow properties of a polystyrene melt as the application of an electro‐magnetic field to the capillary die was relatively novel in polymer processing. The test conditions such as magnetic flux density, barrel diameter, extrusion rate and die temperature were studied. The results suggest that the maximum swelling of the polystyrene melt with application of the electro‐magnetic field could be enhanced up to 2.6 times (260%) whereas that without the electro‐magnetic field was 1.9 times (190%). The barrel diameter of 30 mm was found to be a critical value in the case of the die swell ratio and flow properties of the polystyrene melt were significantly affected by the magnetic flux density. This involved the number and angle of magnetic flux lines around the barrel part. Under the electro‐magnetic field, there were two mechanical forces influencing the die swell ratio and the flow properties; magnetic torque and shearing force. The die swell at wall shear rates less than 11.2 sec^?1 was caused by the magnetic torque, whereas at higher wall shear rates it was dependent on the shearing force. For a given magnetic flux density, the maximum increase in the die swell ratio as a result of the magnetic torque was calculated to be approximately 20%. Increasing the die temperature from 180 to 200°C reduced the overall die swell ratio and suppressed the effect of the magnetic flux density. Copyright © 2004 John Wiley & Sons, Ltd.