Embedded polymerization driven asymmetric PEM for direct methanol fuel cells |
| |
Authors: | Haiqin Pei L. Hong J.Y. Lee |
| |
Affiliation: | Department of Chemical and Biomolecular Engineering, National University of Singapore, 10 Kent Ridge Crescent 119260, Singapore |
| |
Abstract: | This work reports the fabrication of proton exchange membranes (PEM) with stronger resistance to methanol penetration than Nafion®117. A three-component acrylic polymer blend (TCPB) consisting of a copolymer of 4-vinylphenol-methyl methacrylate, poly(butyl methacrylate) (PBMA) and a copolymer of methyl methacrylate-ethyl acrylate is used as the methanol barrier. In order to implant a proton source phase within the membrane as homogeneously as possible, the hydrophilic monomers, 2-acrylamido-2-methyl propanesulfonic acid (AMPS), 2-hydroxyethyl methacrylate (HEMA) and poly(ethylene glycol) dimethylacrylate (PEGDMA), are polymerized only after they have been embedded in the TCPB matrix. The embedded polymerization has resulted in an asymmetric membrane structure, in which the hydrophilic network is sandwiched by two layers of matrixes with high percentages of TCPB. As expected, this asymmetric membrane structure exhibits lower methanol uptake than Nafion®117; and a proton conductivity in the range of 10−3–10−4 S/cm, which is dependent on the concentration of the sulfonic acid content. It is suggested that the two external layers in this asymmetric membrane provide primarily methanol-blocking and supporting proton-conducting properties; while the middle layer supplies protons and conserves water. This unique sandwiched PEM structure from embedded polymerization is confirmed by microstructure characterizations and by physical property measurements. |
| |
Keywords: | AMPS Embedded polymerization Asymmetric laminar structure PEM |
本文献已被 ScienceDirect 等数据库收录! |
|