首页 | 本学科首页   官方微博 | 高级检索  
     检索      

差分LC VCO的设计方法
引用本文:满家汉, 赵坤,.差分LC VCO的设计方法[J].电子器件,2005,28(4):809-812.
作者姓名:满家汉  赵坤  
作者单位:中国科学院微电子研究所,北京,100029;中国科学院微电子研究所,北京,100029
摘    要:通过分析振荡器的两种典型相位噪声模型,给出了振荡器相位噪声与电路参数的关系。在此基础上,提出了优化VCO相位噪声的设计方法:设计高Q值电感;调整尾电流的大小;调整nMOS管和pMOS管的尺寸。文章最后给出了一个2.4GHz全集成VCO的设计,仿真结果表明在2.4GHz时VCO的相位噪声为-120.4dBc/Hz@600kHz,证明该方法对于VCO的设计具有较好的指导作用。

关 键 词:集成LC压控振荡器  噪声  相位噪声  锁相环
文章编号:1005-9490(2005)04-0809-04
收稿时间:2005-03-14
修稿时间:2005-03-14

Design Method in Optimization Differential LC VCO
MAN Jia-han,ZHAO Kun.Design Method in Optimization Differential LC VCO[J].Journal of Electron Devices,2005,28(4):809-812.
Authors:MAN Jia-han  ZHAO Kun
Institution:Institute of Microelectronic of Chinese Academy of Sciences, Beijing 100029, China
Abstract:An analysis of two famous oscillator phase-noise modules derives the relations between phase-noise and circuit parameters. And hence, a design strategy to optimize the phase noise of VCO, such as designing high Q inductor, adjusting tail current and sizing the dimensions of nMOS and pMOS, is presented. At the end of this paper, a 2.4GHz fully integrated VCO design is mentioned. The simulation result describes that the phase noise of the VCO is -120.4dBc/HzG 600 kHz. This result proves that the method is valid.
Keywords:integrated LC VCO  noise  phase noise  phase-locked loop
本文献已被 CNKI 维普 万方数据 等数据库收录!
点击此处可从《电子器件》浏览原始摘要信息
点击此处可从《电子器件》下载免费的PDF全文
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号