Rheological and Mechanical Characterization of Multi-Walled Carbon Nanotubes/Polypropylene Nanocomposites |
| |
Authors: | M. Hemmati G. H. Rahimi A. B. Kaganj S. Sepehri A. M. Rashidi |
| |
Affiliation: | 1. Research Institute of Petroleum Industry (RIPI) , Tehran, Iran;2. Department of Mechanical Engineering , Tarbiat Modares University (TMU) , Tehran, Iran;3. Research Institute of Petroleum Industry (RIPI) , Tehran, Iran;4. Department of Mechanical Engineering , Tarbiat Modares University (TMU) , Tehran, Iran |
| |
Abstract: | The rheology and morphology of multi-walled carbon nanotube (MWNT)/polypropylene (PP) nanocomposites prepared via melt blending was investigated. The minor phase content of MWNT varied between 0.25 and 8 wt%. From morphological studies using a scanning electron microscopy technique a good dispersion of carbon nanotubes in the PP matrix was observed. The rheological studies were performed by a capillary rheometer, and mechanical properties of the nanocomposites were studied using a tensile and flexural tester. Both PP and its nanocomposites showed non-Newtonian behavior. At low shear rates the addition of MWNT content causes an increase in viscosity; however, viscosity is less sensitive to addition of MWNT content at higher shear rates. Flow activation energy for the nanocomposites was calculated using an Arrhenius type equation. From this calculation it was concluded that the temperature sensitivity of nanocomposites was increased by increasing of nanotube content. An increase in tensile and flexural moduli and Izod impact strength was also observed by increasing the MWNT content. From rheological and mechanical tests it was concluded that the mechanical and rheological percolation threshold is at 1.5 wt%. |
| |
Keywords: | Polypropylene multi-walled carbon nanotubes nanocomposite rheology mechanical properties SEM |
|
|