Comparative Study of Tribological Properties of Polyphenylene Sulfide (PPS), Polyethersulfone (PES), and Polysulfone (PSU)

The tribological properties of polyphenylene sulfide (PPS), polyethersulfone (PES) and polysulfone (PSU), which have similar molecular structures, were investigated using an end-face contact tribometer and a reciprocating tribometer. The thermomechanical behavior of the polymers was analyzed using dynamic mechanical analysis (DMA). PPS exhibited a maximum friction coefficient with increasing load and sliding speed, while the friction coefficients of PES and PSU decreased only slightly. The wear rate of PPS was much lower than that of PES and PSU under high loads and speeds. It is suggested that the main factors influencing the friction and wear properties of the neat polymers are their condensed state and heat resistance. Amorphous PES and PSU showed liquid-like behavior and very low friction when the frictional surface was in the molten-flow state. The macromolecular crystals of crystallizable PPS give it some solid-like behavior and load-carrying capacity; hence PPS exhibited lower wear than PES and PSU.