首页 | 本学科首页   官方微博 | 高级检索  
     检索      

应用于无线传感网络的2.4GHz低噪声放大器
引用本文:路守领,韩科锋,姜祁峰,王俊宇.应用于无线传感网络的2.4GHz低噪声放大器[J].固体电子学研究与进展,2010,30(3).
作者姓名:路守领  韩科锋  姜祁峰  王俊宇
作者单位:1. 复旦大学专用集成电路与系统国家重点实验室,上海,201203
2. 上海集成电路技术与产业促进中心,上海,201203
基金项目:国家科技支撑计划课题资助 
摘    要:采用SMIC0.13μmRFCMOS工艺设计,并实现了应用于无线传感网络的2.4GHz差分低功耗低噪声放大器。在低功耗约束下,电路采用差分共源共栅源极退化电感结构。考虑了ESD保护PAD和封装等寄生电容,分析了输入阻抗匹配、增益、噪声和线性度,提出了低功耗条件下输入阻抗匹配和噪声优化措施。芯片测试结果显示,噪声系数NF为2.5dB,输出采用片外无源网络匹配下功率增益S21为9.4dB,输入三阶交调点IIP3为-1.5dBm。在1.2V电源电压下消耗电流3.3mA。芯片面积为860μm×680μm。

关 键 词:射频  低噪声放大器  无线传感网络  噪声系数  寄生电容

A 2. 4 GHz Low Noise Amplifier for Wireless Sensor Network
LU Shouling,HAN Kefeng,JIANG Qifeng,WANG Junyu.A 2. 4 GHz Low Noise Amplifier for Wireless Sensor Network[J].Research & Progress of Solid State Electronics,2010,30(3).
Authors:LU Shouling  HAN Kefeng  JIANG Qifeng  WANG Junyu
Abstract:A 2.4 GHz differential low power low noise amplifier for wireless sensor network is designed and realized in SMIC 0.13 μm RF CMOS process. Under the constraint of low power,the inductively degenerated common-source common-gate low noise amplifier is adopted. With the consideration of parasitic capacitor of ESD protection PAD and package,the input matching network,voltage gain,noise figure and linearity are analyzed,and the optimization of input matching network and noise figure are proposed. Measurement results show noise figure of 2.5 dB,power gain of 9.4 dB,input-referred third-order intercept point of-1.5 dBm while consuming 3.3 mA from a 1.2 V supply. The die area is 860×680 μm2.
Keywords:radio frequency  low noise amplifier  wireless sensor network  noise figure  parasitic capacitor
本文献已被 万方数据 等数据库收录!
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号