| 互连线RC模型应用条件的仿真研究 |
| |
| 引用本文： | 袁宝国,王胜国.互连线RC模型应用条件的仿真研究[J].电路与系统学报,2004,9(1):139-141. |
| |
| 作者姓名： | 袁宝国 王胜国 |
| |
| 作者单位： | 1. 上海第二工业大学,上海,201209
2. 北卡罗莱娜大学,夏洛特分校,美国 夏洛特 NC 28223-0001 |
| |
| 基金项目： | 美国自然科学基金资助项目(NSF: CCR 0098275) |
| |
| 摘 要： | 研究结果表明,在L与RC比值较小时,阶跃响应的上升时间基本上由RC的乘积决定,电感对电路的影响可以忽略,互连线采用RC模型与RLC模型结果应无多大差别。在L与RC比值较大时,阶跃响应曲线出现振荡,此时使用RC模型需满足工作频率低于RC模型的“上限使用频率;当工作频率超过RC模型的“上限使用频率”时,互连线的模型就必须采用RLC模型。RC模型的“上限使用频率”仅与互连线长度有关:fmax106(Hz·m)。
|
| 关 键 词： | 超大规模集成电路 互连线 仿真 电路模型 |
| 文章编号： | 1007-0249(2004)01-0139-03 |
| 修稿时间： | 2003年9月1日 |
Application Conditions for RC Interconnecting Model |
| |
| YUAN Bao-guo,WANG Sheng-Guo.Application Conditions for RC Interconnecting Model[J].Journal of Circuits and Systems,2004,9(1):139-141. |
| |
| Authors: | YUAN Bao-guo WANG Sheng-Guo |
| |
| Institution: | YUAN Bao-guo1,WANG Sheng-Guo2 |
| |
| Abstract: | Simulation of extremely high order interconnecting model is conducted by means of MATLAB. The rising time of step response mainly depends on the product of R and C. When the ratio of L and RC is small, the influence of inductance on the circuit can be neglected such that the difference between RC model and RLC model vanishes. The oscillation in step curve occurs when the ratio of L and RC is large. Therefore, it must be satisfied that working frequency can not be higher than the upper limit for the RC interconnecting model. Otherwise, RLC model must be adopted in interconnect modeling. The maximum frequency for RC interconnection is normally only related with the length of interconnection, i.e., fmax106/l. |
| |
| Keywords: | VLSI interconnect simulation circuit model |
| 本文献已被 CNKI 万方数据 等数据库收录！ |
|
