Protection of carbon steel with superhydrophobic coating against corrosion in NaCl solution

Corrosion and kinetics of partial electrode reactions on carbon steel St3 with superhydrophobic coatings of three types were studied in 0.5 M NaCl and 50 g/L NaCl +400 mg/L H₂S solutions. The investigations were carried out on electrodes made of carbon steel St3 with a chemical composition, wt. %: C – 0.20; Mn – 0.50; Si – 0.15; P – 0.04; S – 0.05; Cr – 0.30; Ni – 0.20; Cu – 0.20, and Fe – 98.36. To obtain the type I coating, the metal surface was textured by an IR laser radiation of nanosecond duration followed by chemisorption of fluorobutylsilane out of a solution in n-decane. To obtain a coating of type II, a nanoscale composite layer consisting of aggregates of aerosil nanoparticles was applied additionally to the outcome of type I method. To obtain a coating of type III, the metal surface after being textured by the infrared (IR) laser radiation of nanosecond duration was followed by chemisorption of fluoroxy silane. The influence of duration τ of the medium corrosive impact on protective effect of the superhydrophobic coating is considered. It was shown that upon reaching a steady state (after 72 h), the corrosion rate of steel with a superhydrophobic coating of I and II types in a 0.5 M NaCl solution is reduced by 23 ± 3 times compared with unprotected samples. Approximately the same picture is characteristic of electrodes with a coating of type III in a solution of 50 g/L NaCl +400 mg/L H₂S.